3. A 250 kVA, 0.5 lagging power factor load is connected in parallel to a 180 W, 0.8 leading power factor load and to a 300 VA, 100 VAR inductive load. Determine the total apparent power in kVA.

Q: Two point charges of 318 statcoulomb and 414 statcoulomb are 6.8 cm apart. A point between the…

A:

Q: Use Norton Theorem to solve for the current and voltage at 40 ohm resistor. 12ου 20 Ω 2 10 Ω 3 Α Α…

A:

Q: Unless given, use the: POLAR FORM for voltage and current, RECTANGULAR FORM for impedance. Consider…

A:

Q: Use wye-delta/delta-wye transformation to determine the value of current i and equivalent resistance…

A: In this question , we will find equivalent resistance and current i .....

Q: 2. Determine the current flowing in R₁, R₂, R3, R4, Rs and V₁. (if Voltage drop across R,=20 V).…

A: The required parameters can be calculated by using the ohms law, kirchhoff's current law and voltage…

Q: A 220 V self-excited shunt motor has armature and field resistances of 0.2 Ω and 220 Ω respectively.…

A: Given data : Field resistance Rsh=220Ω Armature resistance Ra=0.2Ω First speed N1=1000rpm Line…

Q: 9) The voltage across a 12-mH inductor is v= 24cos (200t – 10°) V. Find the instantaneous through…

A: In this question we have given voltage across inductor ....We have to find out current through it...

Q: Does IT = IR1 + IR2 + IR3 in a series circuit? Explain your answer. 2. Is the measurement current…

A: following problem solve by ohms law it is given as

Q: According a- l v to the figure, average voltage b- 2 v c- 3v b-4v 304 V P Si R2: 1k

A:

Q: 12V 6Ω www 1Ω 9 A 3 Ω 8 Ω 12

A:

Q: The diodes are ideal, zero cut in volts, zero forward resistance and infinite reverse resistance.…

A:

Q: C is ↑ 7.5 mH 12 Ω For the circuit shown above, what is the maximum average power that can be…

A:

Q: 1. A sinusoidal signal has a frequency of 4KHz the best sampling frequency is: a- Equal to 8 KHz. b.…

A:

Q: The manufacturer of a selected diode gives the rate of fall of the diode current di/dt = 20A/µs, and…

A: Given data, Diode specifications didt=20 A/μstrr=5 μs

Q: Q2.) What is the displacement transducers? And then list of types with valuable explanation for each…

A: Transducer is a device which converts one form of energy into other form of energy.   Displacement…

Q: Q³: From the circuit, find the following:- 1- Vc. 2- Vout at 12 volt. 3- Vour at -12 volt. 4- Draw…

A: Brief description:  In the above given question they want to know the value of output and the…

Q: The following circuit contains two op-amp stages. a) Name the basic circuit structures and draw a…

A: 1) The circuit is given as It is a cascading of the two amplifiers to achieve high gain. A Block…

Q: A carrier signal given by 10 cos 2 x 10³t volt is FM modulated by single tone Hz message 4 cos 2 x…

A: Given  A message signal,carrier signal and modulation index. We need to determine the max frequency…

Q: hat are some real-world applications of sinusoidal functions? Please discuss to some depth and also…

A: Types of  Basic input signal  Unit step signal  ramp signal parabolic signal Sine and Cosine signal

Q: 15) A 100 HP motor operates at 95% of its load capacity. The motors efficiency is 88% and the power…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Refer to the figure; if VCE = 0.2 V, Ic(sat) is: 10 V = 4.7 kn Ra www VINS 1.2 MO O 2.085 mA O 0.05…

A: For given circuit We need to find out saturation current .

Q: Q1.) A CRT deflection plates of (60mm) long and (0.5cm) apart. The screen is (22cm) away from the…

A:

Q: Q6.) Identify whether the following statement are true(T) or false (F) 4-A piezo-electrical…

A: Here we check whether the given statements are T or F.

Q: 1) Design an active band-reject filter that has gain 13 and the stop frequency between 129 and 1950…

A: Given  Few specifications of a band reject filter.we need to design it. Please find the below…

Q: Exercise: Given IE 1.3 mA, ß= 100, and ro = 40 k, sketch: 1. The CE and CB hybrid equivalent models.…

A: A closed path, where electric current can flow defined as an electric circuit. It is various…

Q: What is the capacitance of a capacitor with 4.9 m² plates cross-sectional area and 0.07 m apart in…

A: Brief description: In the above given question they have mentioned area of the plates and distance…

Q: Below is a 3-phase, 3 wire system. Compute for the line currents, total real power, total reactive…

A: Given line voltages are Vab =200 ∠0 V Vbc=200 ∠240 V  =200 ∠-120° Vca =200 ∠-240 V =200 ∠120 V it…

Q: numbers. Sh 4. Design equation F(A,B,C,D) -(1,2,3,6,8,10,12,13,15) using a 4x1 Mux?

A: Brief description : For the given minterms we need to design multiplexer circuit which accepts 4…

Q: 8 V 2/1 6Ω ww 12 V 4Ω 44-45. The loop equation for the circuit is: (A) -12 + 6i+8+4i = 0 (C) 12+…

A: In this question , we will write loop equation...

Q: Q3/A) A 1000-VA 230/115-V transformer has been tested to determine its equivalent circunt. The…

A: given that  VOC=230VIOC=0.45APOC=30WPOC =VOCIOCcosϕ∘cosϕ∘=POC VOCIOC=30230×0.45=0.289POC =VOC2RC⇒…

Q: Use nodal analysis and MATLAB to find V, in the circuit of Fig. 3.73. 8 Ω Μ + To 4 Α 2 Α ΤΩ www Μ ΖΩ…

A:

Q: A Select the best answer for all of the following: 1. It is required to send information with a…

A: (1) To send information with minimum bandwidth we can use frequency division multiplexing ,the…

Q: The switch has been in position a for a long time. At t=0, the switch moves from position a to…

A: To switch has been in position a for a long time.

Q: (c.) Determine the core loss when the transformer is connected to a 4700 (primary) volt 60 cycle…

A: Given: A 60 kVA 4800/460 volt, 60 cycles, distribution transformer has the following resistance and…

Q: After a long time in position-a, the switch in the circuit shown Fig.5 is change to position-b at…

A:

Q: What is the voltage when current is 5 A and resistance is 88 ? Do NOT include units Round your…

A: for determine voltage  we use ohm's law it is given as when pressure and temprature is constant then…

Q: Two impedances are supplied by Vrms, as shown in Figure 2, where Arms. The first load draws P₁ =…

A: It is given that: P1=23.2 WQ1=50 VARAssuming,V=100∠160° VI=2∠190° A

Q: 54(-15°) (2+j3) + 8 -2+j7

A:

Q: 1) When a synchronous motor is running at synchronous speed, the damper winding Produces......…

A:

Q: 8) Find the instantaneous voltage across a 8-μF capacitor when the current passing is i = 2sin (60t…

A: In this question,  We need to determine the instantaneous voltage across the 8uF capacitor  If…

Q: Why are optical filters, such as a 690/50 bandpass, filter placed in front of photo-detectors?…

A: Given  We need to enumerate the reasons why band pass optical filters are used infront of…

Q: 1. Determine the impedance of the circuit of Figure 4.1 at frequencies of 100 Hz, 10 kHz and 1 MHz.…

A:

Q: in a series Ri circuit voltage across the resistor is 100 V and the voltage across inductor is 50 v.…

A: Given, VR = 100 V , VL = 50 V, To calculate the power factor of the circuit.

Q: The time constant RC has a unit of

A: In this question,  We need to choose the correct options What is unit of the time constant RC?

Q: Example 3.6: Find vo(t) in the circuit of Fig. 16.7. Assume v,(0) = 5 V. 10 Ω ww + 1022 0.1 F vo(1)…

A: In this question we need to find a voltage Vo(t) for the given circuit.

Q: 2.1) A parabolic reflector antenna used for radio astronomy to observe a certain patch in the sky,…

A: Given: A parabolic reflector antenna used for radio astronomy to observe a certain patch in the sky…

Q: b) The maximum mean output voltage of a three-phase controlled full-wave rectifier is 540.2 V whilst…

A: Given  Parameters of a full wave rectifier we need to find the ripple factor of full wave and half…

Q: R₁ www R₂ www R₂ o a b

A:

Q: L1 R1 mm 50Q 10mH V1 C1 220 Vrms :10uF 60 Hz 0° Computed Values Compute the expected power factor of…

A:

Q: 2) Determine the Thevenin voltage and resistance at terminals and b. 2.5 Ω www 25 V 15 Ω b ww

A:

Synchronous Motor

The synchronous motor is an AC electric type motor where at a steady-state the shaft rotation is synchronized with the supply current variable-frequency. To an integral number of AC cycles, the rotation period is exactly equal. The stator of the motor in the synchronous motor contains multi-phase AC electromagnets due to which a magnetic field is created that rotates in time with the oscillation of the line current. The rotor contains a permanent magnet and the rotor rotates in synchronization with the stator field at the same rate and provides the second synchronized magnetic field which is rotating in nature as a result. When the synchronous motor is supplied with independently excited multi-phase AC electromagnets on both the rotor and the stator, it is termed as a doubly-fed machine. The most widely used AC-type motors are the synchronous AC motor and the induction AC motors.