3 Single Phase, 100 kVA transformer are connected delat to supply an assorted load of 160 kW at 0.8 pf lagging. If one transformer is taken out for repair determine the… a) minimum kVAR of capacitor needed to prevent overloading of two transformer. (b) If the portion of the load os removed, find the pf of the load removed in 60 HP, 0.766 pf lagging, 90% efficiency.

Q: Across a 230 V, 60 Hz power supply is a 15 Ω non-inductive resistor. Find the equation of the…

A:

Q: Convert each of the following equations directly to gate-level circuits: a.F = ab' + bc + c' b. F =…

A:

Q: 1) What is reverse saturation current. 2) when does a diode act like an ideal switch

A:

Q: A second order system has a damping ratio of 0.23 and a natural frequency of 3.47 rad/sec. Find the…

A: Given data, In a second order system, Damping ratio, ζ=0.23. Natural frequency, ωn=3.47 rad/s.

Q: Determine the value of Current I. 20 Ω www OA. 1.2 Amps OB. 0.6 Amps OC. 1.5 Amps OD. 1.6 Amps OE.…

A: Given data, Circuit is given as,

Q: 240 V, 25 Hz single-phase ac generator is connected to a 20 Ω resistor. Find the  instantaneous…

A:

Q: 20V 452 852 34 652

A: We need to find out the current and voltage for given circuit by using of Norton and thevenin…

Q: Part G: Confirm your answer by deriving the value of Rx with mesh-current analysis (i.e. from…

A:

Q: 2) Using the Superposition Theorem determine the current in each part of the following network. B1…

A: When more than one source is present in the electrical network, the Superposition theorem is used.…

Q: explain the function and operation of an oil pressure switch

A: We need to explain the function and operation of an oil pressure switch.

Q: 3- In a square wave inverter the switches are controlled in square mode as shown in the bellow. In…

A: Given the circuit , R=10 ohm' L=10 mH

Q: Q2) A three-phase, full-wave full-controlled rectifier bridge circuit shown in fig(2) is operating…

A: As per the guidelines of Bartleby we supposed to answer first three subparts of the Question.…

Q: Problem 2. Calculate the electric field between the plates of a 4.7 uF capacitor that are separated…

A: In this question We need to determine the electric field between the plates.  We know electric field…

Q: 4. Find the Laplacian of V = x2y + xyz

A:

Q: Use two ideal op amps and resistors to implement the function +3x²--210-520 Yn U V. +

A:

Q: QUESTION 1 1.1 An AC circuit is given in Figure 1.1. The supply voltage is Ē = E20° at a frequency…

A: In this question We need to determine the total impedance of the circuit in the polar form ,…

Q: Exercise 9: Use the "synthetic multiplication" convolution algorithm to compute the output y[n] for…

A: I have written this solution as handwritten solution. Hope you find your solution clearly.

Q: FACTS Exam: 1. The following figure shows a multilevel inverter. What type of the multilevel…

A: Inverter: An electrical device called an inverter transforms direct current (DC) into alternative…

Q: A 500-V, 37.3 kW, 1000 RPM, DC shunt motor has on full-load an efficiency of 90 percent. The…

A: Input power = Terminal voltage× Line current = Output powerefficiency. For motor, Line current =…

Q: Find ReqT, currents and voltages of each resistor in the circuit. Fill the Table. ReqT R₂ W 6Ω I₁…

A:

Q: For the circuit shown, Vin is a step function that goes from 0 to VIN-1 at t-0. R-100 k 2, C-10µF…

A: In these questions,  We need to determine the voltage across node 2 with different different time…

Q: 1. What is the function of the modulator? 2. What are the signals called? input and output of the…

A: To explain: 1. Function of the modulator. 2. Input and output of the modulator. 3. Function of the…

Q: Exercise 8: Derive the spectrum of v(t) = 5 + 2 cos(2π(20)t) and make a plot versus frequency.…

A: I have written this solution as handwritten solution. Hope you find your solution clearly.

Q: Vo R₂ V₁ (+1 R3 13 V/₂

A:

Q: 2.) For the following bridge circuit, calculate the current I 50 Ω a 10 V 1008, 400 100 www 100 b R₁…

A:

Q: For the circuit shown in Fig. 7-17, design the resistor values to meet these specifications: Vcc=…

A: It is given that: VCC=10 VVCE@midpointIC=10 mA2N3904's βdc=100-300

Q: In a circuit with a positive voltage across a resistor and some current flowing to ground,…

A:

Q: A rechargeable battery has a capacity of 28900 C of charge. When connected to a 2.35 A DC power…

A: Given data, Charge Q = 28900 C. Current I = 2.95 A

Q: 8. ww V₁ R₁ m $7 Ry Given VIE BV R₂₁₂₁ = 4 V₂=20V P+3 = 8 9=1489="d

A:

Q: A 11 kVA, 4000/125 V, 60 Hz transformer has been tested to obtain the following data: Open circuit…

A: I have written this solution as handwritten solution. Hope you find your solution clearly.

Q: 5. Let's change our square wave to be less square. We're only going to have it be at the high…

A:

Q: A 1000 x 1000 bus admittance matrix for an electric power system has 8000 non-zero elements. The…

A:

Q: 5. For the circuit below, the switch is moved from position 1 to position 2 at t=0, (and remains…

A:

Q: Problem 3: Node Voltage Analysis 2-12 IA ✓ IA 2-22 62 What is the total number of nodes contained in…

A: In this question We need to determine the total number of nodes, super nodes and node voltage.  We…

Q: . The reason that curves on roads are often banked is because a) the coefficient of static friction…

A: Answer: To find the reason that curves on roads are often banked

Q: A sine wave has a maximum value of 50 V. Find its instantaneous value at 120º.

A:

Q: An alternator is supplying a load of 300 kW at 0.6 p.f. lagging. If the power factor is raised to…

A: Given data, An alternator is supplying a load of P=300 kW at pf cosϕ=0.6 lagging. The alternator…

Q: One of its roots for a 2nd order system is given in Fig. 2 on the s-plane. Find the %PO, C, con, and…

A: Type of control system Closed-loop control system  The more accurate response even in the case on…

Q: For the previous question, estimate the capacitance per unit length (pF).

A: Capacitance per unit length of a coaxial cable : b=Outer Diametera=Inner DiameterCapacitance…

Q: 1- In a buck DC/DC converter: V₁ = 100 V, R= 8M, D= ton = 0.8, f == 20000 Hz, L = 200 µÍ, Find: a)…

A: Types of Converter   DC-DC Converter (Chopper) DC AC Converter (Inverter) AC-DC Converter…

Q: Problem 3: Node Voltage Analysis 2-12 IV -+ IA b 7 IA wed 2-12 ع6 6-52 What is the total number of…

A:

Q: 259 34 1 258 € 452 20V

A:

Q: 1) 2) 90 (± 4 +50 V 18v 52 3V -i ia J.s Find i + 30 V₂ 2 Find V₁ = ¿₁ کو 2 = i₂=

A: Note: Current in series circuit remain same but voltage change based on resistance. Voltage in the…

Q: Find the Transfer Function of Lag Compensator of Given Figure.

A:

Q: What are the problems that may encounter in design and optimization of electric machines for…

A: We need to explain what are the problems that may encounter in design and optimization of electric…

Q: 12V 100 ΚΩ 12 ΚΩ ww 47 ΚΩ Μ 12 mA 10 ΚΩ HI a

A:

Q: 5. What is static synchronous compensator (STATCOM)? What is the main. advantages/disadvantages of…

A: We need to explain STATCOM.

Q: Consider the following feedback control systems: R(s) + E(s) 5 2 s²+3s+5 Y(s) 1) Derive the…

A: Given: A feedback control system, To find: a) Derive the relationship E(s)/R(s), b) Apply the input…

Q: 2) vs has magnitude 10 V and the complex frequency is s = -2 +j10 s¹. Determine i(t) in time domain.

A:

Q: Consider the circuit below. b R1 w R₂ R3 mi R5 R7 wit RG R42 RS # /= 8A, /₁ = 2.2A, V4 = 37.2V, and…

A: Note: Current in series circuit remain same but voltage change based on resistance. Voltage in the…

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.