24) 24) Neatly draw the logic circuit for the expression below. Do not minimize or change the expression. (A + BC) + ABC + B

the primary to circulate E-circuited

Where are cable operator signals the most weakest and distorted? (Choose 2) at the photodiode detector at the first stage amplifier at the electrical output at the input section at the detector Submit Response Question 6 Select the appropriate response Which term describes the statistical deviation of the actual number of arriving photons from the average number of photons at the receiver? dark current shot noise O post amp noise Submit Response ORIN

Consider the circuit with an RGB LED connected to Arduino as shown in figure 1: fghij abcde + - DIGITAL (PWM-) O UNO ARDUINO RGB LED pins Red LED Blue LED Green LED Arduino Pins Pin 3 Pin 4 Pin 5 Ground Ground Table 1: RGB LED pin connections to arduino Figure 1: RGB LED connected to Arduino Answer the following questions: a) Write a short code, configuring all the Arduino pins connected to LED as output.

Refer to the National Electrical Code® or the working drawings when necessary. Where applicable, responses should be written in complete sentences. For problems 1 and 2, six luminaires, similar to Style E used in the Commercial Building, are to be installed in a room that is 12 ft x 18 ft (~3.7 m x ~5.5 m) with a 9 ft (2.8 m) floor-to-ceiling height. The spacing ratio for the luminaire is 1:0. 1. The maximum distance that the luminaires can be separated and achieve uniform illuminance is ft ( m). For problems 2-5, two luminaires, 8 ft (2.5 m) and 4 ft (1.2 m) in length with dimensions as shown in Figure 15-7, are to be installed in tandem (end to end). The end of the long luminaire is to be 2 ft (600 mm) from the wall. 2. The center of the outlet box should be roughed in at ft ( m) from the wall. 3. The first support should be installed at the wall. ft ( m) from 4. The second support should be installed at from the wall. ft ( m) 5. The final support should be installed at the wall. ft…

08:32 ☑ < Block Test Assign... 16% Q : 4. Solutions to this assignment should be submitted via Google Classroom by the due date. 5. No late submissions will be accepted. 6. A cover page should accompany your submission. 7. You will be penalized if you fail to adhere to instructions. MARK ALLOCATION Question Question 1 Question 2 Marks 15 10 Question 1 a) Determine Thévenin's equivalent circuit for the circuit shown in Figure 1. given that, is the load of interest. 1000 480 F [15] Question 2 10/45° V 1 kHz 33002 ли 22002 Figure 1 ZL 75 mH Given the circuit of an ideal OPAMP, as shown in Figure 2, determine the output voltage phasor V [10] V 2.50/30.0° V f=1.00 kHz 1.00 ΚΩ Figure 2 470 nF OV 2/3 3/3