2.41 A parallel plate capacitor is made of two circular plates separated by a distance of 5 mm and with a dielectric with dielectric constant of 2.2 between them. When the electric field in the dielectric is 3 x 104 V/m, the charge density of the positive plate will be, nearly

Q: Parking system (combinational logic circuits) Design a simple parking system that has at least 4…

A: Given: 4 parking spots.  we have to design a system using combinational logic circuit that allows to…

Q: Next the multimeter will be used to measure the voltage VOUT_B for the second potential divider. The…

A: We need to find out output voltage for given circuit.

Q: R₁ E₁ R₂ E₂ With E1 = 20 V; E2 = 70 V; R1 = 22; R2 = 10; R3 = 5. Find the current I through resistor…

A: Given circuit, Where, E1=20 VE2=70 VR1=2 ΩR2=10 ΩR3=5 Ω

Q: Name 3 applications for closed-loop system

A:

Q: A three phase full wave uncontrolled bridge rectifier has an AC input voltage of 90 V RMS at 60 Hz…

A: Given, A three phase full wave uncontrolled bridge rectifier,                    Vin= 90V rms (line…

Q: An inductor, a capacitor, and a resistor are all connected inseries across an ac source. If the…

A: It is given that: 1. An inductor, a capacitor, and a resistor are all connected in series across an…

Q: 400 V 3 phase through a 3 phase 4 wire distributor, delta connected 5 horse power is supplied to the…

A:

Q: Find the value of the total current (I) and real power (P) in the given circuits below.

A:

Q: The reactance of O 100 Ohms 000 48.48 Ohms 87.46 Ohms 1.64 Ohms

A: Given data, Impedance is given, Z=100∠610

Q: What is the equivalent capacitance in nF if three capacitors of 6 nF, 1.9 nF, and 7.4 nF are…

A:

Q: Find the relationship between input voltage which is considered a sinusoidal signal of frequency ω…

A:

Q: Using only the data given in the text, what is the maximum number of telephones that the existing…

A: Probability sampling refers to the selection of a sample from a population, when this selection is…

Q: 14 Calculate the value of stored energy in an inductor if the value of inductance is 10 mH and 2 mA…

A:

Q: A star connected reflector supplies a delta connected load. The impedance of the load branch is (8 +…

A:

Q: oper wire of certain length and ance is drawn out to three times gth without change in volume, w…

A:

Q: a. b. C. Explain briefly the different between open-loop and closed-loop system. List four…

A: a. Open-loop control system Closed loop control system In this type of control system, the…

Q: Determine the divergence of the vector field P = x²yz ax + xy az O a. 2xyz ax O b. 2xyz O c. 2xyz +…

A:

Q: In the following circuit find thevenin's voltage across terminals A and B. www 492 16A O a. 13.09 V…

A: Given circuit,

Q: Given the circuit below and after the current no longer flows C₁ =1 farads C₂ =9 farads C3 =1 farads…

A: Given circuit, C1=1 faradC2=9 faradC3=1 faradV=92 volts

Q: For JFET, if Ipss = 15 mA. VGS (off)= - 7 V, and gm. = 4 mS or mA/V. Determine the transconductance…

A: We have an JFET with, IDSS = 15 mA = 15 * 10-3 A VGS (off) = -7 V gmo = 4 mS = 4 *10-3 S VGS = - 4 V…

Q: A three-phase, 460 V, 98hp 1,60 Hz, four-pole induction machine delivers rated output power at a…

A: We are authorized to answer only 3 subparts at a time since you have not mentioned which part you…

Q: For step response of an under damped second order system, the settling times are given as: ts1: for…

A: Given for step response of a under damped system Settling time for 1% tolerance band: ts1 Settling…

Q: Three infinite uniform sheets of charge are located in free space as follows: 3 nC/m2 at z = -4, 6…

A: A two-dimensional flat surface containing an infinite number of charges is referred to as a "plane…

Q: a) i. With the aid of a circuit diagram briefly explain how data from 2 registers can be added…

A: Register: The register is a cell that holds the data and the digital processing gets completed by…

Q: The current passing a 1 kW electric hair dryer is 2.5 A; what is the voltage across the hair dryer…

A: Given: Power rating of dryer, P=1 kW Current, I=2.5 A

Q: closed-loop voltage gain of the amplifier circuiti

A:

Q: In the circuit given below, R = 16 2. Using mesh analysis, find the value of la, ib, and ic. a↓ 30 V…

A: Given circuit,

Q: The reactance of the Impedance Z=1 O 100 Ohms 48.48 Ohms 87.46 Ohms 1.64 Ohms

A:

Q: E1=+10V- Determine I, V₁, V₂ and Vo # Si ID +V1- ww 4.7k 2.2k +V2- E2=-5V - Vo

A:

Q: To achieve 75 percent modulation of a carrier of V, 190 V, what amplitude of the modulating signal V…

A: Modulation index is given, m=75 %=0.75 Amplitude of carrier signal Vc=190 V

Q: A CRO measurement has 2.3 divisions measured for peak-to-peak amplitude of a signal; what is the rms…

A: We got an CRO measurement as, No. of division for peak to peak signal = 2.3 Volts/div = 5   We need…

Q: and

A: Given: 1) A pure capacitor is connected to an AC power supply. in this circuit the current. 2) In a…

Q: A capacitor of capacitance 4700mF is charged to a potential difference of 18v. It is then partially…

A:

Q: What is the maximum modulating frequency allowed in commercial FM broadcastings? a. 40 KHz b. 75 KHz…

A: Frequency modulation: Frequency modulation is a process of changing the frequency of the carrier…

Q: Q3 (ABET) Calculate the power delivered to the 3-ohm resistor using superposition: Ο 20 V ΣΩ www. ΤΩ…

A: This question belongs to circuit theory . It is based on the concept of super position theorem in…

Q: 1. A standard TTL gate performs what logic function for positive logic? 2. If all inputs of a TTL…

A: ANSWER (1) A standard TTL gate perform NAND LOGIC function for Positive…

Q: 5. Using 2nd approximation, find current I. D₁, Si E₁ = 20 v R, = 2.2 kΩ M KH D₂, Si O E₂ = 4 v

A: We need to find current for given circuit

Q: A coil composed of 100 turns has an inductance of 5 mH. If the number of turns is doubled without…

A: Given data, A coil composed of  N=100L=5 mH Number of turns is doubled without changing the other…

Q: Find the value of the total current (I) and real power (P) in the given circuits below. 1. All value…

A: Given data, As per given instruction, all resistors is of 1-ohm and the supply voltage is 48 V

Q: x(t)= C0 + C1*sin(w*t+theta1) + C2*sin(2*w*t+theta2) x(t)= A0 + A1*cos(w*t) + B1*sin(w*t) +…

A:

Q: The reciprocal current is denoted by i = 100 in (314 t + 30°). Then its (1) maximum value (2)…

A:

Q: Give examples of copper use.

A: Copper is widely used in electrical machines and the power system, uses of copper are listed below:…

Q: Can you explain to me the properties of Laplace transform by solving a diffrental equations as I…

A: The Laplace transform changes the frequency domain into the time domain. When working with…

Q: 3. A load of 40+j55 ohm is connected across a 120-Volt source. Determine the value of the reactive…

A: Given parameters: Load resistance, RL = 40 + j55 ohm Source voltage, Vs = 120 V   To find: Reactive…

Q: is (t) (* = 0 IF R{ v For the RC circuit above, the initial voltage across the capacitor is zero.…

A: Given a circuit with following data R = 2kΩ C = 25μF is(t) = 10mA Switch is closed at time t = 0…

Q: An alternating voltage is given by e= 200 sin 2π 50t . Then find the time taken to + 60 V for the…

A:

Q: For the given circuit in figure, data is mentioned. Find the fault current when the system is…

A:

Q: Insert plot here: Resistor Voltage vs Resistance

A:

Q: The mms voltage across a 0.018 μF capacitor is 1.5 V at a frequency of 50 Hz. Part A What is the rms…

A: Given,    C = 0.018 μF    V = 1.5V    f = 50 Hz    Irms =?

Q: The upper critical frequency of a particular op-amp is 100 Hz. What is its open-loop 3 dB bandwidth?

A: Given data, Upper critical frequency fH=100 Hz The given circuit is an op amp circuit,

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.