=2. Express y = y₁ + y₂ as a single sinusoidal function if y₁and y2= 40 cos(wt + 60°)A) Solve by using trigonometric identitiesB) Solve by using the phasor concept20 cos(wt30°)

Answered: Image /qna-images/answer/6bdf4e03-44ee-4118-9d27-4983c07a7a97.jpg

Answered: = 2. Express y - ₁ + y₂ as a single…

= 2. Express y - ₁ + y₂ as a single sinusoidal function if y₁ and Y₂ = 40 cos(wt+ 60°) A) Solve by using trigonometric identities B) Solve by using the phasor concept 20 cos(wt 30°)

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.6P: (a) Transform v(t)=75cos(377t15) to phasor form. Comment on whether =377 appears in your answer. (b)...

See similar textbooks

Related questions

Q: Design a 4-bit Gray Code to Excess-3 code converter. Include the truth table, simplified equation…

A: Introduction - Gray code - The Gray code is a binary number scheme arrangement in which two…

Q: Problem: Suggestion easuring circuits in the laboratory using meas u method for the time constant of…

A: Time constant is defined as the time to reach 53% of steady state value in charging circuit It is…

Q: For an N channel E MOSFET what is the value of Id when VGS(TH)=3 V and Vgs(on)=4 V and k=1.5 mA/V2…

Q: V, ο Zi 82 ΜΩ F 11 ΜΩ +20 V Rs 610 Ω 2 ΚΩ Ipss = 12 mA Vp=-3V rd = 50 ΚΩ Cs I ο Vo Το

Q: 68ΚΩ +12V + Vo 22kΩ Va -9V 72k92 a. Calculate vo when VG = 3V. b. Specify the range of values of v…

A: Operational amplifier: The operation amplifier is used to amplify the signal and it is three…

Q: A 2MVA, 2.3kV 3 Y-connected alternator operates at rated kVA at a power factor of 80%. The DC…

Q: Consider the diode circuit of Figure 1.1. The source voltage Vs = 20 V, the resistances values are…

Q: 3. Given the circuit below, find the values of the following: a. Ic Vcc b. Rc C. Ic 2.2 ΚΩ w la= 20…

A: We need to find out unknown resistance value for given circuit

Q: Find the transfer function T(s) = x2 (s)/F(s) of the given system. x1(t) 8 mm x2(t) f(t) 10 14 6 + 8…

A: In this question, We need to determine the transfer function? We are solving this problem using…

Q: Determine the value of the current i for the circuit shown below. 200 Ω 150 Ω 40 V 500 Ω M 600 Ω

Q: Given the circuit below, find the values of the following: a. Ic b. Rc c. Rb

Q: Q: Draw output voltage waveform for this circuit if ß-50. +10v +5v -1v Vi 2 3 t(ms) 50k +10v -10k…

A: We need to find out output voltage for given circuit

Q: A 2200 V, 200 HP, 3 phase mesh connected synchronous motor is working on full load at an efficiency…

Q: B: List the location and equation of Economical Number of Transformers operation of distribution…

A: Distribution system: Distribution system is the essential part of power system. It is used to…

Q: Symmetrical Components 4) Given Va= 10243°, Ub= 142-134°, Vc = 12/110°. a) find Vo,U₁ and V₂.

Q: Find the transfer function T(s) = Vo(s)/Vi(s) of the given system. 6H ww 20 Vi(t) 3H 4Ω Vo(t) 5F ΖΩ…

A: To find the transfer function T(s) = Vo(s) / Vi(s)

Q: the block diagram for three phase transmission line system

A: Here we discuss about single line diagram of 3 phase transmission line. First one must understand…

Q: 5 + 3-j4 2 10 L90° V 12 + + 15/0% V 200° Za = 5 ohms Zb= 3-j4 ohms Zc= 2 ohms Zd = 12 ohms V1= 20…

A: In this question we will find node voltage and branch currents...

Q: Determine the following DC values: IB, IC, IE, VC, VB, ID, VO, VDS, VD, VS AC values: Zin, Zo, Avs,…

A: Solution

Q: A RL circuit has a battery emf E=-22V and a switch closes at 0.0s. At t=1.25s, the ammeter=0.2A. If…

A: Writing the current equation in RL circuit. It=I∞1-e-RtLI∞=steady state current =ER…

Q: A total current of 10A flows through parallel combination of three impedance: (2 - j5), (6+j3) and…

A: We are authorized to answer only one question at time since you have not mentioned which question…

Q: 3 Ω ) 12/0° v j2Ω 11 6/0° V j3 Ω 4 Ω -j22 3/10⁰

Q: 3-phase Wye-Delta Connected source to load system has the following particulars: Load impedance 5+j4…

Q: From the circuit below, what is the value of the mesh current B when the direction of all the mesh…

A: In this question we need to choose a correct option

Q: A 60 cycle alternating current has a maximum value of 40 amperes. It crosses the time axis in a…

Q: Let w= 100rad/s in the circuit. Find the input impedance, Zin 20 (2 www Zin 10 Q2 ww 2 mF 0.1 H

Q: Determine the values of i3, v4, i5, and v6 in the circuit shown below. + U1 18 Ω Mob ΟΔ + 20 Ω· · Μ…

Q: r Nodal Analysis.

A: For mesh analysis equations- Summation of voltage drops in a closed loop is always zero. For nodal…

Q: is the equivalent transfer function: (s) + G(s) H(s) y(s)

Q: capacitor is charged with 0.23 watt-sec of energy at a voltage of 48 volts. What is the capacitance?

Q: If w = 500 rad/s and I = 2.5 angle 40, find vs(t) ww 10 Ω 1,(1) + 25/-30° V • 25 Ω Μ | 20 mH

Q: alternating wave voltage has a maximum value of 150 volts and a frequency of 50 hertz. a. determine…

A: In this question we will find voltage wave equation ....voltage value at given time and phase…

Q: A10 microfarad capacitor has 250 milliamperes of current flowing through it. How much voltage at 60…

Q: b. Can we use both a decoder and encoder in the same circuit? If yes, how and why. Then give three…

A: Encoder: decoder convert a set of signals into coded binary signal. It has 2N input lines and N…

Q: Find the transfer function T(s) = Vo(s)/Vi(s) of the given system. 6H www 20 Vit) 3H 40 Vo(t) 5F www

Q: A given transistor has the following values: hFE = 200, hfe 120, hie= 5 ks2, hre = 40, = and hoe =…

Q: A coil having a resistance of 25 Ω and an inductance of 150 mH is connected in series with a 80 μF…

Q: calculate the Nyquist diagram of the following transfer function sys = 334.1 s^2 + 45.38 5 + 227.3

A: We need to calculate the Nyquist diagram of the following transfer function:…

Q: Q: Draw output voltage waveform for this circuit if ß-50. +10v +5v -1v Vi 2 3 4 t(ms) Vi AC 50k +10v…

A: Brief description: The common emitter current gain of the amplifier is 50. For the given common…

Q: Q5: find the Fourier series of the following equation - 1<x<0 f(x) = { x 0<x< 1 1<x<3 1

Q: between Find the equivalent capacitance "a" and "b" for the combination of capacitors. shown: (Note:…

Q: Using the laplace transformation table, evaluate the following, considering any other variable other…

Q: Find 1, in the circuit shown in the figure below using superposition. 6 kil 2 kl 2k12 www 30V 12kil…

Q: Develop a two-component matching network for a ZL = (40 + j10) ohms , load and a 50 ohms, source.…

A: Solution

Q: A coil of resistance 16 ohm is connected in parallel with a coil of resistance R₁. This combination…

Q: A linear dynamic system is governed by the following Laplace transformed equation. (3s + 5)X(s) = =…

Q: Find Rab

Q: Please explain this equation for nodal analysis. Why did Vs1 and Vs2 became negative? Why did Vs3…

A: In this question we will solve nodal equation.... We know that current always flow from positive…

Q: 1. Use nodal analysis and find the voltages across z1, z2, z3 and z4. Use node A as your reference…

Q: Given the circuit shown in Figure Q1: (i) If R₁ = 5 km2, determine the current I₁ flowing through…

A: For part i and ii we will apply nodal analysis and ohm's law For part (iii), maximum power we gets…

Question

=
2. Express y = y₁ + y₂ as a single sinusoidal function if y₁
and y2
= 40 cos(wt + 60°)
A) Solve by using trigonometric identities
B) Solve by using the phasor concept
20 cos(wt
30°)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

2-A resultant current is made of two components: a 10 A D.C. component and a sinusoidal component of maximum value 14.14. The average value of the resultant current is amperes (a) 0 (b) 24.14 (c) 10 (d) 4.14 and r.m.s. value is - amperes (e) 10 (f) 14.14 (g) 24.14 (h) 100
Step by step answer how to converting Rectangular form, Phasor form, and sinusoidal form
transform sinusoidals to phasor.
Using a line phasor (circle), draw the two given phasors. Use the sine function as the base function.
What is the Cartesian representation of z = 3502-150°? O a. z = -303.11 -j175 O b. z = -175 +j303.11 O c. z = -303.11 +j175 O d. z=-175-j303.11
An electrical circuit with a sinusoidal voltage source, a resistor, and a capacitor all connected in series. The voltage across the capacitor: Select one: a. Leads the current in the capacitor by exactly 90o b. Is in phase with the sinusoidal voltage source c. Is in phase with the voltage across the resistor d. Leads the current in the circuit by 90o e. Lags the current in the circuit by 90o
Determine the total impedance as seen by the voltage source. If the voltage source can be represented by a unitary phasor (Vs=1) , determine the phasor of the current I passing through the voltage source as well as the phasor of the voltage across the resistor R.
Given the operation of sinusoids. 20 sin 400: + 10 cos(4007 + 60-) – 5 sin/400:- 20-) a. Solve using phasor method. Express your answer in rectangular form. b. Express your answer in polar fom
Two alternating voltage are given by v1 = 120 sinωt volts and v2 = 200 sin(ωt – π/4) volts. Obtain sinusoidal expressions for v1 + v2 . (a) by plotting waveforms, and (b) by vector. Please show some graph and diagram on how you solve this problem ?
The capacitive reactance (XC) ............. be affected by the harmonics of non-sinusoidal wave. * will cannot could all-of-them
For the circuit below a. Find total impedance and admittance of the circuit in polar form.b. Find total current and current through each element in phasor form.c. Draw the phasor diagram for the currents I, IR, IL, IC and the voltage E and find the time domain sinusoidal expressions for the currents and voltage (use peak values for the amplitudes).
Problem # 4 Consider the sinusoidal voltage and current: v(t) = 170 cos(120rt - 60°) V and i(t) = 60 sin(120at - 30°) A. %3D %3D a) b) Plot v(t) and i(t) and determine if the current is leading or lagging the voltage. Find the Phasor representations of both voltage and current. Determine the rms values of both voltage and current. c)