197Chapter 4 Problems4.31 Concentrated sulfuric acid (18.3 M) has a density of 1.84 g/mL.(a) How many moles of H2SO, are in each milliliter of solution?(b) What is the mass% of H SO in the solution?

Molarity of a solution is defined as the number of moles of solute present in one liter solution,…

Answered: 197 Chapter 4 Problems 4.31…

Chemistry: Principles and Reactions

8th Edition

ISBN:9781305079373

Author:William L. Masterton, Cecile N. Hurley

Publisher:William L. Masterton, Cecile N. Hurley

Chapter10: Solutions

Section: Chapter Questions

Problem 16QAP

See similar textbooks

Similar questions

Write an equation from the following description: reactants are gaseous NH3 and O2, products are gaseous NO2 and liquid H2O, and the stoichiometric coefficients are 4, 7, 4, and 6, respectively.
What is the molarity of each ion present in aqueous solutions of the following compounds prepared by dissolving 28.0 g of each compound in water to make 785 mL of solution? (a) potassium oxide (b) sodium hydrogen carbonate (c) scandium(III) iodite (d) magnesium phosphate
Methanol, CH3OH, is used in racing cars because it is a clean-burning fuel. It can be made by this reaction: CO(g)+2H2(g)CH3OH(l) What is the percentage yield if 5.0103gH2 reacts with excess CO to form 3.5104gCH3OH ?
On Easter Sunday, April 3, 1983, nitric acid spilled from a tank car near downtown Denver, Colorado. The spill was neutralized with sodium carbonate: 2HNO3(aq)+Na2CO3(aq)2NaNO3(aq)+H2O(l)+CO2(g) a. Calculate H for this reaction. Approximately 2.0 104 gal nitric acid was spilled. Assume that the acid was an aqueous solution containing 70.0% HNO3 by mass with a density of 1.42 glcm3. What mass of sodium carbonate was required for complete neutralization of the spill, and what quantity of heat was evolved? (Hf for NaNO3(aq) = 467 kJ/mol) b. According to The Denver Post for April 4, 1983, authorities feared that dangerous air pollution might occur during the neutralization. Considering the magnitude of H, what was their major concern?
4-103 Caffeine, a central nervous system stimulant, has the molecular formula C8H10N402. (a) How many moles of caffeine are present in 6.19 1025 molecules of caffeine? (b) Imagine you dissolve caffeine in water to a volume of 100.0 mL, which is known to have a density of 1.23 g/mL. How many molecules of caffeine are present in this volume? (c) How many nitrogen atoms are present in 3.5 mg of caffeine? (d) Complete the skeletal structure of caffeine, where all the bonded atoms are shown but double bonds, triple bonds, and/or lone pairs are missing. (e) Identify the various types of geometries present in each central atom of caffeine using VSEPR theory. (f) Determine the various relative bond angles associated with each central atom of caffeine using VSEPR theory (g) What is the most polar bond in caffeine? (h) Would you predict caffeine to be polar or nonpolar? (j) Consider the combustion of caffeine, which results in formation of NO2(g) as well as other expected products. Write a balanced chemical equation for this reaction. (j) The heat of combustion for caffeine is 2211 kcall/mol. How much heat will be given off if 0.81 g of caffeine is burned completely? (k) Calculate the weight of H2O(g) that can be prepared from 8.00 g of caffeine mixed with 20.3 g of oxygen gas.
4-89 If 7.0 kg of is added to 11.0 kg of to form which reactant is in excess?
Ten mL of concentrated H3PO4 (91.7% by mass, d=1.69g/mL) was accidentally poured into a beaker containing 20.0 g of NaOH. Not all the NaOH was consumed. How many grams of NaOH were left unreacted? The equation for the reaction is H3PO4(aq)+3OH(aq)3H2O+PO43(aq)
Sodium borate decahydrate, Na2B4O710H2O is commonly known as borax. It is used as a deodorizer and mold inhibitor. A sample weighing 15.86 g is heated until a constant mass is obtained indicating that all the water has been evaporated off. (a) What percent, by mass of Na2B4O710H2O is water? (b) What is the mass of the anhydrous sodium borate, Na2B4O7?
What is the molarity of each ion present in aqueous solutions of the following compounds prepared by dissolving 20.00 g of each compound in water to make 4.50 L of solution? (a) cobalt(lll) chloride (b) nickel(lll) sulfate (c) sodium permanganate (d) iron(ll) bromide
4.79 Phosphoric add (H3PO4) is important in the production of both fertilizers and detergents. It is distributed commercially as a solution with a concentration of about 14.8 M. Approximately 2.1 X l09 gallons of this concentrated phosphoric acid solution is produced annually in the United States. Assuming that all of this H3PO4 is produced by the reaction below, what mass of the mineral fluoruapatite (Ca5(PO4)3F) would be required each year? Ca5( PO4)3F+5H2SO43H3PO4+5CaSO4+HF
A chemist prepared a compound that she thought had the formula FeI3. When the compound was analyzed, it contained 18.0% Fe and 82.0% I. Calculate the mass percentage composition expected for FeI3 and compare the result with that found in the analysis. Is this the correct formula of the compound?
The pictures below show a molecular-scale view of a chemical reaction between H2 and CO to produce methanol, CH3OH The box on the left represents the reactants at the instant of mixing, and the box on the right shows what is left once the reaction has gone to completion. D Was there a limiting reactant in this reaction? If so, what was it? Write a balanced chemical equation for this reaction. As usual, your equation should use the smallest possible whole number coefficients for all substances.

SEE MORE QUESTIONS

Recommended textbooks for you

Chemistry: Principles and Reactions

Chemistry

ISBN:

9781305079373

Author:

William L. Masterton, Cecile N. Hurley

Publisher:

Cengage Learning

Chemistry for Engineering Students

Chemistry

ISBN:

9781337398909

Author:

Lawrence S. Brown, Tom Holme

Publisher:

Cengage Learning

Chemistry: The Molecular Science

Chemistry

ISBN:

9781285199047

Author:

John W. Moore, Conrad L. Stanitski

Publisher:

Cengage Learning

Chemistry: Principles and Reactions

Chemistry

ISBN:

9781305079373

Author:

William L. Masterton, Cecile N. Hurley

Publisher:

Cengage Learning

Chemistry for Engineering Students

Chemistry

ISBN:

9781337398909

Author:

Lawrence S. Brown, Tom Holme

Publisher:

Cengage Learning

Chemistry: The Molecular Science

Chemistry

ISBN:

9781285199047

Author:

John W. Moore, Conrad L. Stanitski

Publisher:

Cengage Learning

Chemistry: Matter and Change

Chemistry

ISBN:

9780078746376

Author:

Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Publisher:

Glencoe/McGraw-Hill School Pub Co

Chemistry & Chemical Reactivity

Chemistry

ISBN:

9781337399074

Author:

John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Publisher:

Cengage Learning

Chemistry: Principles and Practice

Chemistry

ISBN:

9780534420123

Author:

Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

197 Chapter 4 Problems 4.31 Concentrated sulfuric acid (18.3 M) has a density of 1.84 g/mL. (a) How many moles of H2SO, are in each milliliter of solution? (b) What is the mass% of H SO in the solution?