-7 (ii) 1.6×10 7 A
Q: Example 5.3 A BPF is to be constructed using RC components that will only allow a of frequencies to…
A: In this question we will find values of the capacitors required for band pass filter....
Q: Q1: For the circuit of fig.(1), the voltage and current sources are given in a form of Fourier…
A: Step 1 Power: It is the rate of the change of the energy. The power is dissipated in the resistor is…
Q: The parallel-plate capacitor of Figure shown below is quarter-filled with mica (Er= 6). Find the…
A:
Q: A factory is supplied by a single-phase network of 220V-50Hz and contains in parallel: • 4 motors,…
A:
Q: Chapter #1 Programmable Logic Devices HW# 07 Q. Use the below PAL device to realize the logic…
A: The truth table is shown below, INPUT OUTPUT x y z f1 f2 0 0 0 0 1 0 0 1 1 1 0 1 0 1 0…
Q: EXAMPLE 3.5 A circuit with two resistors in series (100ohm and 200ohm), a two different temperatures…
A: In this question we will find noise voltage and noise power produced at load....
Q: Vi=VH For the circuit below find the load resistor if ID=30 .mA VDD=3.5 V Vo=VL R ID Ms 1.1 ΚΩ Ο
A:
Q: Find the voltage Vo and current I for the OPAMP circuit in Figur 5. You can assume that the OPAMP is…
A:
Q: * In 3 to 8 de-multiplexer if S2 S1 SO-000, then the input D is connected to the output Y1 YO Y7 O…
A: Solve the followings: 1. In 3-to-8 de-multiplexer S2S1S0=000 then the input D is connected to the…
Q: A 100 V peak signal at 1 GHz is applied to a transmission line of characteristic impedance 100 0,…
A: Given a transmission line has, Characteristics impedance, ZO=100 Ω Antenna impedance, ZA=75 Ω…
Q: What are the relationships of resistance, voltage and current, and the distribution of voltages and…
A:
Q: it, find the equivalent resistance and voltage across each resistance. Given the following:
A:
Q: illustrate charging by conduction and induction. Describe your materials and how the demonstration…
A: Given We need to explain charging by induction and conduction. Please find the below attachment for…
Q: multiplexer
A:
Q: The output of a linear system to a unit input u(t) is t² e2t. Tthe system function H(s) is
A: Given a linear system has, Output, Ct=t2e-2t Unit input, Rt=ut
Q: Problem 18. The standing-wave ratio on a mis- matched line is calculated as 1.60. If the incident…
A: Given here standing wave ratio on a mismatched line is 1.60 Incident power arriving at termination…
Q: Find the voltages V1 and V2 for the circuit shown in the figure P2.24 by combining resistances in…
A: The required parameters can be calculated by reducing the series and parallel connected resistors…
Q: Q5. Calculate the maximum and minimum collector current in (fig. 6) and find Icsat. and VCEsat. Vcc…
A:
Q: X/102 resistance in parallel with soll F Capacitance the Current throgh the Capacitance is: (c(+) =…
A: Capacitive reactance inversely proportional to frequency Inductive reactance directly proportional…
Q: A three phase transformer supplies a balanced three phase laod with constant impedance. The name…
A: Given information about a three-phase, Y-d (star-delta connected) transformer is, Sn=100 kVA. V1n=22…
Q: Consider the circuit below in which the dependent current source depends on the current it, the…
A:
Q: Find the total response of the system described by the following differential equation given that y…
A:
Q: The phase angle of the system G(S) = (a) 0° and 90° (b) 0° and -90° s+5 ; varies between S²+8s+9 (c)…
A: In this question, We need to choose the correct options What is variation of angle of given system.…
Q: a) A 18 V voltage source is applied across a circuit consisting of a 481 ohm resistor in series with…
A: Given here a electrical circuit and asked to find voltage across resistor.
Q: "In getting the Norton's equivalent current source, we assume all sources to be equal to zero…
A: In norton theorem circuit is replace by norton equivalent current source parallel with norton…
Q: If, in a 3-4 alternator, a field current of 50 A produces a full-load armature current of 200 A on…
A: Given, A 3-φ alternator has, Field current of 50 A Open circuit line voltage, Vocline=1730 V Open…
Q: Q1: Choose the correct answer for the following statements is a programmable logic device that has…
A: is a programmable logic device that has fixed AND array & Programmable OR array.
Q: Q1/ Write ( 1- The logical expression Y (A, B, C, D) = (0, 3, 5, 7, 8, 12, 14) is equivalent to Y…
A: NOTE: . As per our company guidelines we are supposed to answer only first three sub parts only.…
Q: the 2 2 resistor if: v(t) = 50+ 40 sin(wt) + 30 sin(3wt - 30) + 25 sin(5m
A: The Given equation is vt=50+40 sinωt+30 sin3ωt-30+25 sin5ωt+30Voltit=30+20 sinωt+15 sin2ωt-20+10…
Q: 4 Given the following T-Flip flops a) Plot the signals of Qo and Q1 with respect to the clk signal.…
A: Given: T-flip flops.
Q: The primary benefit of PAL is having a programmable AND array and fixed OR array, that it was…
A: For the above given statement we need to justify whether it is true or false. By using the concept…
Q: 5. Determine the total propagation delay from each input to each output for each circuit in Fig.…
A: Given gates diagram : (a) 74FXX (b). 74HCXX
Q: Find the total power required for the three radiators WITHOUT using PSPICE.
A: Voltage in the parallel circuit remain same across the components Current in parallel circuit can…
Q: From the characteristic shown below, find VGS at ID=1mA
A: The given characteristic is shown below: It is given that: ID=1 mA=1×10-3 A
Q: The primary benefit of PAL is having a programmable AND array and fixed OR array, that it was…
A: For the above given statement we need to justify it's correctness for the given concept PAL.
Q: A six pole wave wound armature has 40 slots. Each slot has 24 conductors and runs at 500 rpm. Find…
A: Given,P=6For wave wound A=2Z=40×24=960 N=500 rpmϕ=20m Wb=20×10-3 Wb
Q: Consider the circuit on the left with two resistors, a capacitor and an ideal OP-AMP. You may make…
A: The Given Ideal OP-AMP circuit is
Q: The shaft torque of a diesel motor driving a 100V dc shunt-wound generator is 25Nm. The armature…
A: It is given that: T1=25NmV=100VIa=18Aϕ2=0.85ϕ1T2=35Nm
Q: What are the factors affecting the dielectric strength of Transformer oil?? Explain the maintenance…
A: Given Questions on transformer oil. Please find the answers below.
Q: Q3: For the nMOS transistor in Fig.2 with ke= 130´A/V2 and V=0.7v. Find the drain voltage (Vo) and…
A:
Q: Calculate the resonant frequency of the network shown below. R1 R2 www A www B C L M^^^^
A:
Q: Problem 18. The standing-wave ratio on a mis- matched line is calculated as 1.60. If the incident…
A: In this question we will find value of the reflected power of line....
Q: For the figure shown below, the permeability in the core is 4 x 104 Wb/A-tums-m. What is the value…
A: Given figure, Number of turns, N = 60 Current, I=5 A Radius, r = 5 cm…
Q: Solve this means find transfer function only handwritten I want or else dislike
A: For the above given question we need to calculate transfer function of the given block diagram.
Q: multiplexer contains. multiplexer contains.... select lines 4-1 4 O 20 8 O select lines 16-1 4 O 8 5…
A: In this question we need to choose a correct option
Q: What is the value of Rx in kohms to be connected in parallel to a 75 kohms to reduce the value of…
A:
Q: EX2: infinite line along the z-axis with 20 nc/m. Calculate the capacitance between p=10 and p=4 for…
A: Used first Maxwell's equation. Dot product of E(electric field) and top, bottom surfaces are equals…
Q: +41mV +15 mV 15 k2 30 KG2 www Calculate Vo for the circuit shown below 600 k www 300 k www 30k02 www…
A:
Q: Find the unit-impulse response for each of the following linear systems. a. y(n) = 0.5x(n) – 0.5x(n…
A: Given: Unit-impulse response is required for the given linear systems.
Q: 21: Assume that V is a function of y and at y =2, V=5 volt and at y = 4, V = 10 volt. a) Fi. cis.…
A: In this equation shows that the potential distribution in a region is depend the local charge of…
Step by step
Solved in 2 steps with 2 images
- Four point charges are placed at corners of a square . At the top left is a charge of - 1 C, at the top right is a charge of - 2 C, at the bottom right is a charge of -3 Cand at the bottom left is a charge of - 4 C. What is the direction of the net electric force due to the four point charges on a positive charge Q located at the center of square ? O due North O due South O Sw O SE2Q -Q 2r (a) -Q -2Q (b) D- D- 2r 5- r (c) (d) What is correct order of the charge systems fro c>a>d>b A)The depletion region is Region of opposite charges Neutral region Region of infinite energy The region of free of charge carriers
- Which of the following properties might be different for nanoparticles and their macro counterparts? Color Electrical conductivity O Shape All of the aboveHere are the choices: Lorentz law charge Faraday's law Ohm's law Capacitance Resistivity of materials Resistance vs StrainA8-cm long wire carrying a uniformly distributed 12-µc charge is bent into a semicircle. What is the el O A) 4.2 MV B) 0.042 MV C) 0.42 MV O DI 42 MV E) 420 MV
- 0.4 cm outer radius, R and 0.2 cm inner radius, r. ...A resistor in the shape of a spherical shell is made up of a material with resistivity of 1.93 x 10-80-m has inner and outer radii of 1.5 mm and 3.7 mm, respectively. Determine the resistance of the said resistor. O 12.1038 microohms O The answer cannot be found on the other choices. O 608.8035 nanoohms O 902.9482 nanoohmsA dielectric is always an insulator. But an insulator is not necessarily a dielectric. True O False O May be
- Aluminum has a resistivity of 10.6×108 Nm at 20°C. What will the resistivity of Aluminum when then temperature is increased to 1000°C. (Take a as 2.65×10-³)An n-type piece of silicon experiences an electric field equal to 0.2 V/um. Calculate the velocity of electrons in this material. Un=1350 cm²/Vs, up = 480 cm²/V.s. Select one: O a. 2.7 x 10 m/s O b. 2.7 x 10 m/s O C. None of these O d. 2.7 x 108 m/sFor some reason it's saying the 0.3636 is wrong. I tried 0.364 as well thinking it may be have wanted it rounded. This is explained very well. Thank you. On the second part, you did 60-60 because the charge didn't change. Is that correct?