Answered: 15. 0.05 kg of steam at 10 bar is…

15. 0.05 kg of steam at 10 bar is heated in a rigid vessel reversibly until the pressure is 20 bar. The net heat flow is *

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: An ideal gas (R= 0.2081 kJ/kgK, Cp=0.5203 kJ/kgK, Cv=0.3122 kJ/kgK) is compressed steadily from 100…

Q: 4. (a) at a rate of 6.25 kg/s and exits at 0.2 MPa and 150°C, (Fig. below). The steam is losing heat…

Q: Note: Draw the P-V, T-S diagrams for all problems The work required to compress a gas reversibly…

Q: n a constant volume ‘Otto cycle’, the pressure at the end of compression is 12 times that at the…

A: Given Data⇒ Constant volume Otto cycle Pressure at the end of compression=12×Pressure at start of…

Q: An ideal gas (R= 0.2081 kJ/kgK, Cp%=0.5203 kJ/kgK, Cv=0.3122 kJ/kgK) is compressed steadily from 100…

A: Given Data P=20 kW P1=100 kPa P2=600 kPa T1=30°C=303 K Isentropic efficiency=90%

Q: R-134a enters a compressor operating at steady state at 200kPa. At this state, 5% of the mass is in…

A: R-134a enters a compressor operating at steady state at 200kPa. At this state, 5% of the mass is in…

Q: b) Air is compressed in a steady flow compressor operating at a pressure ratio of 8. The conditions…

Q: 1-Air enters an adiabatic nozzle at a pressure of 374 kPa and 500 K and exits at a pressure of 80…

Q: the isentropic efficiency of the turbine, b) the power produced by this turbine

A: Given: Inlet conditions P1=80 bar= 8 MPa T1=450oC Exit conditions P2=1 bar=100 kPa T1=150oC mass…

Q: Consider 5.0 pounds per minute of water vapor at 100 lbf/in2, 500oF, and a velocity of 100 ft/s…

A: Use the steam table at 100lbf/in2 and 500°F h1= 1279.1 btu/lbm, S1 = 1.7085 Btu/lbmR at P2= 40lb/in2…

Q: aturated water vapor at 300°F enters a compressor operating at steady state with a mass flow rate of…

Q: Consider 4.8 pounds per minute of water vapor at 100 lbf/in?, 500°F, and a velocity of 100 ft/s…

A: Given that , m=4.8 pound per minute v1=100 lbf/in2T1=500°Fv=100 ft/s η=95%

Q: a reversible adiabatic process the entropy S A Increases B decreases C remains constant

Q: Consider 5.0 pounds per minute of water vapor at 100 lb/in2, 500°F, and a velocity of 100 ft/s…

A: Given Data The mass of the water vapor is: ms=5 lb/min The pressure of the vapor is: P1=100 lbf/in2…

Q: In a turbine, steam expands reversibly from 10 bar to 1 bar. If the process is isentropic, and the…

A: Given data as per question Pressure at entry of turbine =10 bar Pressure at exit of turbine =1 bar…

Q: Steam passes through diffuser adiabatically during a reversible process. For the entropy balance,…

A: Solution:

Q: Saturated water vapor at 300°F enters a compressor operating at steady state with a mass flow rate…

Q: Steam enters an adiabatic nozzle at 440°C and 3 MPa with a velocity of 10 m/s, and exits with a…

A: Here, T1 = 440 °CP1 = 3 MPaV1 = 10 m/sP2 = 0.3 MPaV2 = 305 m/s

Q: Consider 4.8 pounds per minute of water vapor at 100 lbf/in2, 500oF, and a velocity of 100 ft/s…

Q: Consider 4.8 pounds per minute of water vapor at 100 lbę/in2, 500°F, and a velocity of 100 ft/s…

Q: Q3/ One mole of an ideal gas, initially at 40°C and 1 bar, is changed to 120°C and 15 bar by three…

Q: 2. Steam enters an adiabatic turbine steadily at 5 MPa, 350°C, and 25 m/s, and leaves at 200 kPa and…

Q: 1 m3 of air is heated reversibly at constant pressure from 15°C to 350°C, and is then cooled…

Q: In a natural gas liquefaction plant, the liquefied natural gas (LNG) enters a cryogenic turbine at…

Q: onsider 4.8 pounds per minute of water vapor at 100 lbf/in2, 500oF, and a velocity of 100 ft/s…

Q: R-134a enters a compressor operating at steady state at 200 kPa. At this state, 2% of the mass is in…

A: Given: Evaporator pressure =200kPaCondensor pressure P=1600kPaExit temperature of the…

Q: All equilibrium reversible processes have a total entropy to be equal to______

Q: Saturated water vapor at 300°F enters a compressor operating at steady state with a mass flow rate…

Q: An ideal gas (R= 0.2081 kJ/kgK, Cp=0.5203 kJ/kgK, Cv=0.3122 kJ/kgK) is compressed steadily from 100…

Q: For an ideal gas with constant specific heats, show that the compressor and turbine isentropic…

A: The turbine efficiency is given by the following expression: ηT=h3-h4ah3-h4s=T3-T4aT3-T4s By…

Q: 7. During the isothermal process at 88 °F, the pressure on 8 lb of air drops from 80 psia to 5 psig.…

Q: Discuss the during an internally reversible, adiabatic (isentropic) process, the entropy remains…

A: The total entropy of the system is the summation of entropy change due to internal reversibility and…

Q: (25 p) Steam at 30 bar and 320°C enters to a mixing chamber with a rate of 50000 kg/h and mixed with…

A: Condition for steam P1=30 bar T1=320°C m1˙=50000 kgh or ms˙=13.88 kgsecCondition for water P2=25 bar…

Q: In an actual cooling process of a closed system the entropy generation is: (a) positive, (b)…

Q: 0.05 kg of carbon dioxide (molecular weight 44), occupying a volume of 0.03 m3 at 1.025 bar, is…

Q: Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -12…

A: Temperature T1 = -12 C Rate = 18 kgm/min Pressure P1 = 5 bar Entropy change = 0.4842 KJ/K-min

Q: Saturated steam at 0.16 MPa is compressed in an irreversible adiabatic process with an efficiency of…

Q: Consider 5.2 pounds per minute of water vapor at 100 lbf/in2, 500oF, and a velocity of 100 ft/s…

Q: Saturated water vapor at 300°F enters a compressor operating at steady state with a mass flow rate…

A: Given Saturated water vapor temperature = 300 F Flow rate = 5 lb/s Compression pressure = 650…

Q: 5.0 0.04 m of nitrogen contained in a cylinder behind a piston is initially at 1.05 bar and 15°C.…

Q: A) 0.05 kg of carbon dioxide (molecular weight 44), occupying a volume of 0.03 m at 1.025 bar, is…

Q: 4. A mass of 0.05 kg of carbon dioxide (molar mass 44 kg/kmol), occupying a volume of 0.03 m3 at…

Q: whether it is supplied or rejected, and sketch the process on a T-s diagram.

A: Given:m=1 KgP1=20 barT1=250°CP2=30 barT2=T1=250°C

Q: A cylinder fitted with a frictionless piston contained an ideal gas, with a volume of 23 m³, a…

A: Given: Initial volume of the gas: →V1=23 m3 Initial temperature of the gas: →T1=17°C=290 K Initial…

Q: Consider 5.2 pounds per minute of water vapor at 100 lb/in?, 500°F, and a velocity of 100 ft/s…

Q: Saturated water vapor at 300°F enters a compressor operating at steady state with a mass flow rate…

Q: Consider 5.0 pounds per minute of water vapor at 100 lbf/in?, 500°F, and a velocity of 100 ft/s…

Q: Consider 5.2 pounds per minute of water vapor at 100 lb;/in?, 500°F, and a velocity of 100 ft/s…

Q: A cylinder that contains 0.067 kg of carbon dioxide (with molar mass 44 kg/kmol), occupying a volume…

Concept explainers

Buckling of columns

The column is described as a vertical member of the structure that carries an axial compressive load, and buckling is a lateral deformation of the column under the application of load.

Question

None

15. 0.05 kg of steam at 10 bar is
heated in a rigid vessel reversibly
until the pressure is 20 bar. The net
heat flow is *
greater than 700 kJ/kg
Less 700 kJ/kg
equal 700 kJ/kg
non of the above

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

(17 blanks) Calculate the efficiency of the Carnot Engine for ideal gas. Consider the figure below for a complete cycle of Carnot engine, where the cycle goes from ad->ab->bc->cd Carnot cycle Он TH Tc - V 02016 Pearson Education, Inc. processes: processes and segment ab & cd are the Where segments ad & bc are the and the volumes involved are Va, Vb, Vc, Vd, and the two temperatures TC and
Identify if the property of the following steam: Temp Specific Entropy Quality C kJ/kg-K % 202 5.798
steam enters the steam generating unit at a pressure of 20 bar and dryness of 0.96 and leaves at the same pressure at a temperature of 350°C. Mass flow rate of steam is 5kg/s. Find the percentage increase in volume (%) due to drying and superheating.
Find the quanity of heat required to produce 79% dry steam at 8000 kpa from feedwater at 50 degrees celcius ?.
Steam is throttled to 0.1 MPa with 20- degrees of superheat. What is the quality of throttled steam in % if its pressure is 0.75 MPa? Use the approximate formula for enthalpy in superheated condition.
Steam enters the steam-generating unit at a pressure of 20 bar and dryness of 0.96 and leaves at the same pressure at a temperature of 350°C. Mass flow rate of steam is 5 kg/s. Find the percentage increase in volume (%) due to drying and superheating.
Find enthalpy if 5kg of certain gas go through a reversible non flow that has constantpressure process from initial volume 2.129m3 and pressure of 700 kPa to a state where T2 = 550°C. A certain gas has R= 350J/kg-K and Cv = 0.94 kJ/kg-K a. 731.9675kJ b. 813.8610kJ c. 878.3610kJ d. 891.2610kJ
Dry saturated steam at 10 bar pressure expands isentropically through the nozzle to apressure of 4 bar. If the steam is supersaturated throughout the expansion, find (i)undercooling at the end of expansion (ii) degree of supersaturation
3. A water-tube boiler having a heating surface of 325.23 m² evaporates 6349.21 kg of water in an hour from a feed temperature of 66 °C. Boiler pressure is at 1.04 MPaa and the steam quality at the boiler outlet is 99 %. What percent of its rated Bo. Hp was the boiler developing?
Problem (8.2) A steam turbine develops 3000kW when the steam is supplied at 10 bar and 250°C. The vacuum in the condenser is maintained at 65 cm of Hg. The barometric reads 75.2 cm of Hg. The rise in temperature of cooling water is limited to 15°C. The temperature of the condensate coming out of condenser is 35°C. Find, (a) specific steam consumption of the plant, and (b) quantity of cooling water circulated through the condenser per hour. Assume there is no leakage in the condenser. Ans.[(a) 4.8 kg/kW.h, (b) 447 tons/h]
0.2 m'af an ideal gas at 200 "K and 2 har is cumpressed at constant volume to 4 har by heat addition. Then it is compressed adiabatically to 8 har, finally it expands isothermally to the initial point.Assume ep= 14.3 kkg K and ev= 10.2 kIkg K. 1- Draw pv diagram of the cycle. 2. Find the heat added of the constant vuhume proces. 3. Find the work of the adiabatic proces 4 Find the heat rejected and work of the isothermal process.
One mol of an ideal gas is taken through The gas is subjected a three-step cyclic process. successively to an isothermal expansion at 600 K from 5 to 3 bar (path a to b), a constant-pressure cooling (b to c), and a constant-volume heating (c to a). All processes are reversible. Cy and Cp AH for each step and for the entire process. Draw the cycle on the PV diagram. Compile all results in a table, as follows: 21.686 J mol-K-1 =30 J mol-1K-1. Calculate Q, W, AU and %3D