0.2 m'af an ideal gas at 200 "K and 2 har is cumpressed at constant volume to 4 har by heat addition. Then it is compressed adiabatically to 8 har, finally it expands isothermally to the initial point.Assume ep= 14.3 kkg K and ev= 10.2 kIkg K. 1- Draw pv diagram of the cycle. 2. Find the heat added of the constant vuhume proces. 3. Find the work of the adiabatic proces 4 Find the heat rejected and work of the isothermal process.

0.2 m'af an ideal gas at 200 "K and 2 har is cumpressed at constant volume to 4 har by heat addition. Then it is compressed adiabatically to 8 har, finally it expands isothermally to the initial point.Assume ep= 14.3 kkg K and ev= 10.2 kIkg K. 1- Draw pv diagram of the cycle. 2. Find the heat added of the constant vuhume proces. 3. Find the work of the adiabatic proces 4 Find the heat rejected and work of the isothermal process.

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter2: Matter And Energy

Section: Chapter Questions

Problem 30RQ: A gas is compressed inside a compressor's cylinder. When the piston is at its bottom dead center,...

See similar textbooks

Similar questions

Find the quanity of heat required to produce 79% dry steam at 8000 kpa from feedwater at 50 degrees celcius ?.
Thank you
TH 3 kg of air as an ideal gas undergoes a Carnot refrigeration cycle as shown The isothermal expansion occurs at 300K and isothermal compression occurs at 600K. The heat transfer to air during isothermal expansion is 125 kJ. Pressure at the end of figure. isothermal expansion is 75 kPa. a. Find pressure at the beginning of the isothermal expansion. Show all work and explain your numbers. b. Sketch this cycle on the T-s diagram. Show on the diagram the system states (1,2,3, and 4), the cycle direction, and the cycle work (not its amount)
Q1. A vapour compression refrigeration uses R-12 as a refrigerant and the liquid evaporates in the evaporator at - 15°C. The temperature of this refrigerant at the delivery from the compressor is 15°C when the vapour is condensed at 10°C. Find the C.O.P. if (i) there is no under cooling (ii) the liquid is cooled by 5°C before expansion by throttling. Take specific heat at constant pressure for the superheated vapour as 0.64KJ/kg k. and that for liquid as 0.94KJ/kg k the other properties of refrigerant are as follow: a) Temperature b) 0°С с) Enthalpy(KЈK)) d) Entropy(KJ/kg k) e) liquid _j) 22.3 0) 45.4 f) Vapour k) 180.88 g) liquid 1) 0.0904 9) 0.1750 h) Vapour m) 0.7051 i) -15 n) 10 p) 191.76 r) 0.6921
The photo below is the refrigeration cycle of Ammonia, Im just confused on where h2 and Tsup=105 C came from? what kind of table usedand how it is used?
An automobile tire is inflated to 105 kPa at 30 deg. C. After being driven the temperature rises to 55 deg. C. Find the final pressure under isochoric process.
IQ6: Aquantity of dry saturated steam occupics o.2634m at 15 Mpa. Determine the final condition of the Steam it it is compressed untrl he volume is halved a. if the compression is carried out in an iso thermal manner then find the heat regected. 3 6. if the compression follows the aw pv=c.
Calculate work done for the isothermal process.
The answer is 10.17kJ/s ,Show the work fast. Copied solution would not be useful
Exercises 1. The approach & efficiency of cooling tower is 10°C 4 60% respectively. If the tempe- rature of the H₂0 leaving the tower is 37°C, What is the temperature of H₂0 entering?
1 kg of steam at initial conditions of 5.1 MPa and 370 °C expands in a turbine until it becomes saturated. It is withdrawn and reheated to 340°C. After further expansion in the turbine to 160 , part of the steam is extracted for feedwater heating. The remaining steam expands to the condenser pressure of 0.018 MPa. find Wnet, Ec, Ee and the ideal steam rate. Remember, 1. For values taken from the steam tables: Use them as is, do not round off. 2. For values obtained by interpolation and final answers obtained by solving, use FOUR (4) decimal places. 3. PLEASE USE THE STEAM TABLE PROVIDED: https://drive.google.com/drive/folders/15t3WMv7xSTHmwXWXp0X2ZV6aYWhXuRCS?usp=sharing
3. A water-tube boiler having a heating surface of 325.23 m² evaporates 6349.21 kg of water in an hour from a feed temperature of 66 °C. Boiler pressure is at 1.04 MPaa and the steam quality at the boiler outlet is 99 %. What percent of its rated Bo. Hp was the boiler developing?