Answered: 12. Two capacitors 15uF and 30uF are…

12. Two capacitors 15uF and 30uF are connected in parallel, what is the total amount of capacitance? 9.38 uF 45 uF 10 uF 37.5 uF

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter8: Basic Electric Motors

Section: Chapter Questions

Problem 25RQ: List the five capacitor replacement rules.

See similar textbooks

Related questions

Q: Compare between solid iron rotor and drag-cup rotor

Q: Q2) A three-phase synchronous generator is driven by a gas turbine. The synchronous reactance is X-4…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: transformer is reconnected as a step-down 550/440 V autotransformer. Determine (a) current in the…

A: The solution is given below

Q: 5445 A a 20 I2 j20 -j20 212 1230v j20 ll I

Q: Discuss how the speed will change if field current is decreased in a shunt dc motor.

Q: Given a wye connected load Zı = 9 + j12 , Z2 = 9 - j12 and Z3 = 15. Source voltage equal 230V…

Q: Can a voltage be negative? Explain

A: In this question, We need to explain the negative voltage is be negative or not?

Q: Question 43 of 50 0011 0111 1011 0010 0110 1010 0001 1001 1101 +00 0000 0100 1000 100 Fig 3 Refer to…

A: We need to select correct option for given diagram .

Q: Determine the inductor current i(t) shown in the circuit below. I=0 4 2 ilt) 160 20 V 0.4 H v(r)…

Q: (d) In the cicuit shown in figure 6 find the currents I, and I2, express your answer as phasors.…

Q: Consider the circuit shown below. Select values for the capacitances and inductances to obtain a…

Q: Draw and label completely and properly the block diagram of MOD7 synchronous down counter with the…

A: A counter is counting devices that store the number of times an event occurs, whereas an up counter…

Q: BONUS: Consider the circuit shown below. Select values for the capacitances and inductances to…

A: The given circuit diagram is shown below: It is given that: R1=12 ΩR2=4 ΩR3=1 ΩR4=43 ΩR5=23 ΩR6=13…

Q: Determine re. 16 V 270 kn B- 110 2.70 O 16.32 ohms O 18.11 ohms O 8.72 ohms O 9.81 ohms

Q: (c) A 5O0KVA. 1100v. SOHZ. star connected. three- phase synchronous generator has per phase values…

Q: QI: Three infinite current sheet K, =-60 az at y = 7 and K = 20 az at y = 5 and K = -10 az at y %3D…

A: We need to find out magnetic field for given current distribution

Q: An op-amp circuit has a desired closed-loop voltage gain of 10. If the input resistor to the…

Q: Perform these operations using 8-bit signed two's complements arithmetic: i. 27 - 12 92 - 66 ii.…

A: 2.the operation using 8-bit signed two's complement arithmetic: Given, I. 92-66 ii. 27-12 III.…

Q: If the SNR of a wireless link is 180B and the RF bandwidth is 30kHz, using Shannon's capacity…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: 6. Schematic diagram on how to use ammeter in a given circuit.

Q: QI A 380 V, 50 Hz, 3-phase, star-connected induction motor has the following equivalent circuit…

Q: 2. Express the unit vector å, in spherical components at the point: (a) r = 2, 0 = 1 rad, o = 0.8…

Q: Discuss the following 1. Application of FDAS (Fire Detection and alarm system) 3.Device of FDAS

A: The fire alarms systems are in existence from several decades, but the use of modern engineering…

Q: 米 (0 1) r to Fig 2. The vector representation of the constellation diagram shown is an example of I…

A: Every signal has n bits to represent then it is 2n PSK

Q: In a filter, explain what happens at the cut–off frequency.

Q: 4. Determine the total capacitance. 3 F 6F 5F Ст 8F I5F

A: In this question, We need to determine the total capacitance C?

Q: Find Vcb where: Vbb = 5V Rb = 3.9K Ohms Rc = 180 Ohms Bdc = 50 Vcc = -15V

A: In this question, We need to determine the voltage VCB ?

Q: In simple explanation, why transistor is called CURRENT CONTROLLED DEVICE? I really need to…

A: Transistor : A transistor acts as a switch which main function function is to regulate the voltage…

Q: 16. 500 W of power is measured on the secondary side of an ideal 10:1 step-down transformer. How…

Q: The system function of a causal LTI system is 1+z¬! H(2) = (1 – 0.5z-1)(1+ 0.25z-1)' a) What is the…

A: The system function of a causal LTI system is: H(z)=1+z-1(1-0.5z-1)(1+0.25z-1) a) We need to find…

Q: . What is the effect of the field excitation to the back emf of the synchronous motor?

A: Synchronous motor- It is an electric motor which is operated at AC supply. As the name suggest, its…

Q: 10v 2.7v -17,3 -10v

Q: Q2) A- Draw only Mechanical characteristics of the following special motors (Torque /Slip): i-…

A: We are authorized to answer only 1 question at a time since you have not mentioned which question…

Q: P12.50. The four-resistor bias network of Figure12.22(a) on page 620 has R1=100 k2, R2=200 kQ,…

A: DC analysis of transistor is done by finding the finding the DC biasing values also known as Q…

Q: -H5 -H6 -H3 -H4 R(S) G2 1 Y( G1 G3 G4 -H1 -H2 G5 G6

Q: Compute the r.m.s and average values for the waveform of the Fig.1. 0 mA 40 20 t(S) -201 40 Fig.1

A: In this question, We need to determine the average current and rms current?

Q: 7) The restricted earth protection for the transformer is on the (A) high voltage side. (B) low…

Q: 1. Sketch Vo 20 V SV -20V

Q: 1. A point charge, Q = 30nC, is located at the origin in cartesian coordinate. Find the electric…

Q: Determine G(jw) = using MFT Q1 R2 R1 Is Rs

Q: The antenna for television station is located at the top of a 1,500 ft transmission tower. Compute…

Q: Apply the waveforms of Figure to the inputs of the 74ALS138 DEMUX as follows: D -> AO, C-> A1, B->…

A: Given the circuit, as shown below We need to apply the waveforms to the inputs of the 74ALS138 DEMUX…

Q: An automatic pressure control system measured the output as 8 psi. If error signal is 5 psi, such…

A: In this question we need to choose a correct option

Q: If an RC network has a cutoff frequency of 500 Hz, above which the attenuation is 0 dB. What is the…

Q: Q3/ A: For the power system shown, calculate fault current and when a 3-phase fault occurs at point…

A: In this question we need to find a fault current when 3 phase fault occurs at point F shown in…

Q: ind IBq,Icq, VcEq, VB, VE,Vc 16 V Ico 1.8 k2 510 k2 Vc VB VCEQ B= 120 IBQ VE

Q: 10230° + (2 – j4) ] (3 + j4)(3 – j5)* y = 100[ REAL IMAG (do not include "j" anymore) y Blank 1…

Q: 7. Consider the two systems in Figure 4.40. R(s) K1 K2 Y(s) 0.0099 (i) R(s) K1 K2 Y(s) 0.09 0.09 +…

A: Provided formula for the sensitivity. From obtained results option b is correct.

Q: Let Q, = 8 µC be located at P,(2, 5, -8) while Q, = -5 µC is at P2(6, -15, 8). Find F2, the force on…

Q: 1) Derive the Fourier Series expansion of the waveform below. v(t) A t (sec) 2 3

A: As per our company guidelines we are supposed to answer only first question kindly repost the other…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

12. Two capacitors 15uF and 30uF are connected
in parallel, what is the total amount of
capacitance?
9.38 uF
45 uF
10 uF
37.5 uF

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

List the five capacitor replacement rules.
What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
Please explain this question properly A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
Through a capacitor of capacitance 15 micro-farad with a frequency of 50 hz. Compute its reactance 212 ohms O 4,712 ohms O 0.0047 ohm O 0.0002 ohm
A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
1)The value of the capacitance reactive power in VAR is? /2) The value of the capacitor in micro farad is?
An inductor and a resistor are in series with a sinewave voltage source. The frequency is set so that the inductive reactance is equal to the resistance. If the frequency is increased, then options: Voltage across the inductor= Source Voltage Voltage across the inductor> Voltage across the resistor Voltage across the inductor= Voltage across the resistor Voltage across the resistor > Voltage across the inductor
A series R–L–C circuit comprises a 5µF capacitor, a 4ohm resistor and a variable inductance L. The supply voltage is 10∠0◦ V at a frequency of 159.1 Hz. The inductance is adjusted until the p.d. across the 4 ohm resistanceis a maximum. Determine for this condition (a) the value of inductance, (b) the p.d. across each component and (c) the Q-factor of the circuit.
What is the value of capacitance if the capacitive reactance is 50 Q .Assume frequency of supply as 50 Hz ? a. 53.3x10-5 F O b. 5.3x10-5 F c. 6.36x10-5 E d. 63.3x10-5 F