Answered: 12. The generation of "back voltage" is…

12. The generation of "back voltage" is a significant factor for which of the following? O A. Capacitive reactance O B. Phase shift C. Effectivo value D. Inductive reactance

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Related questions

Q: Q8. Which of the following is possible value of crest factor for a non-liner load current? (ay 1.5…

A: Crest factor It is the ratio of peak value to the effective value of given signal

Q: Part b.) (cutt off) repeat using nodal analysis. (Find phaser voltage at above values)

Q: A 3-phase heater with a star connected and phase resistance of 25 is fed by a chopper connected to a…

A: Note: As per our policy, I have attempted the first three subparts. Given that, the star-connected…

Q: Determine settling time and peak time of 2nd order system if damping ratio is 0.5 and frequency is 2…

A: Given values are =

Q: What is the impedance

Q: 5. An inductive reactance of 8 2 is connected in parallel with a capacitive reactance of 18 02; this…

A: given a electrical circuit in word and asked to find R for power factor = 0.5

Q: Pin = 920 W n the per-phase equivalent circuit he slip at pull-out torque, and find e.

A: An induction motor is an asynchronous motor in which the stator winding is connected to a…

Q: Open circuit test and short circuit test are conducted on Alternator at synchronous speed. Select…

A: The short circuit and the open circuit tests of alternator are conducted in order to determine all…

Q: In RLC series circuit, if the voltage across capacitor is greater than voltage across inductor, then…

A: Series RLC circuit- Applying KVL we get-

Q: down the equations of single Write phase transmen ot Bive the names of) he resistances, reae tance,…

A: A single-phase transformer operates only on one phase of electricity. From low voltage to high…

Q: Which of the information given about the governer (speed regulator) element in the power plant is…

A: Which of the information given about the governer (speed regulator) element in the power plant is…

Q: A single-phase motor draws 220 W at a power factor of 0.8 lagging when connected across a 240 V rms,…

A: Calculate the current through the circuit. Substitute for , for and for . Calculate the phase…

Q: What is the reactance of a 0.5 Henry inductor connected to a 12-volt battery? O 6? O 12 ? O 24 ? 48…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: Short Problem: Given a series circuit comprised of the following element: 60.38-ohm resistor,…

A: If impedance Z1 ,Z2 , Z3 are connected in series than equivalent impedance is Z1 +Z2 +Z2. Given…

Q: 3. A balanced load with an impedance of 52445° in each arm is delta connected ba three phase Y…

A: Balance load with an impedance Z=52<45 ohm Delta load line to line voltage 208V Phase current?…

Q: 15 A of current is taken by a non-inductive load at 125 V. In order that the same current shall be…

Q: Short Problem: Given a series circuit comprised of the following element: 64.01-ohm resistor,…

Q: 1. A resistor of102, an inductor of o.012H, and a capacitor of 90 µF are connected in series with a…

Q: Thyristor-Switched Series Capacitor (TSSC) for power factor improvement.

A: The power factor of any system can be improved to unity in ideal case with light loading and…

Q: What is the phase sequence of a three phase motor for which Van=220∠-100V and Vbn = 220∠140V? Select…

A: Phase sequence is the sequence on which voltages are appeared. If phase sequence is ABC then we say…

Q: During balanced load condition the current flowing through the neutral is

Q: A 25-ohm resistor connected in series with a coil of 50-ohm resistance and 150-mH inductance. What…

Q: Three phase system eliminates which of the following harmonic component or components in the…

A: Need to find three phase system eliminate which harmonics

Q: The reactive factor is the cosine of the phase angle between the voltage and the current Select one:…

Q: Three Impedances each of (14- j18)N are connected in mesh across a three-phase 415V ac supply.…

A: Introduction: The finished terminal of one winding is connected to the start terminal of the next…

Q: Refer to the given circuit and determine the resistance and reactance of the lagging coil load and…

Q: Pcoil - At 60 Hz frequency, switch the SW to other pole to terminate the Rin the circuit. Measure…

Q: If 3-phase transfomer configuration in figure in has the givens as listed below: E-line on high…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: The positive sequence harmonics component will add current to the neutral wire. Select one: O True O…

A: we know that positive sequence components are displayed by 120 degrees each other and sum of…

Q: An AC circuit with R, Land C in parallel, has the following branch currents. Resistive branch - 12 A…

A: The solution can be achieved as follows.

Q: -Calculate and draw the load current for the first two-period interval b-Calculate and draw the…

A: Rectifier: Because nearly every electrical appliance runs on DC (Direct Current), the rectifier…

Q: Series capacitor bank compensation for power factor improvement

Q: In a three-phase system phase shift between phases is 30°. Select one: O True O False

A: In this question, Choose the correct option. The given Statment In a three phase system phase…

Q: circuit in the figure: A) the impedance seen when viewed from the source B) Flow C) Phase angle…

Q: Identify the low voltage system from the following. a. primary distribution b. Secondary…

A: A low-voltage network, sometimes known as a secondary network, is a component of electric power…

Q: Q13. The input voltage wavef orm of single phase bridge is having only DCcomponent. O True O False

A: The input voltage waveform of single phase bridge is having only DC component?

Q: between the following in their right places to find the phase shift B-For the circuit shown, put ch…

A: As per policy I can submit only 3 sub parts in one post. Kindly resubmit other in another post. 1)

Q: Thyristor-Controlled Series Capacitor (TCSC) for power factor improvement

A: Reactive Power Compensation (RPC) is critical for maintaining a consistent voltage profile across…

Q: What is the Mathematical relationship between the hine Current, Ih, and the phase Currnt, lo 2

A: According to guidelines we need to solve only the first question. According to the question we have…

Q: Two equal voltages are out of phase with respect to each other by 90 electrical degrees. If the…

Q: Lissajous Choose... Figures Done Choose... STEP UP THE CURRENT STEP UP THE VOLTAGE FREQUENCY PHASE…

A: Need to find correct answer

Q: Draw the phasor diagram. Calculate the phase angle (Ø) and determine the power factor.

Q: A 6 Pole, so Hz, 3Ph woundrotur IM has rotr resistance and reactance per phase 0.02 and o.2…

A: Here, we have given: Number of poles, P=6 Frequency, f=50 Hz Rotor resistance, R2=0.02Ω/ph Stand…

Q: Q21-7he Line Volta8es at the terminal of abalanced Yeomected Lood 15 VAB=1206 Each Phase of the Lood…

A: Line voltage at load terminal is VAB=120∠0° Impedance for each phase=10∠30°ohm We know that…

Q: An impedance coil, in series with a resistor takes a current of 3A when connected to a 120V AC…

Q: . Sketch ofouthe metuenk shoun.below. and determine the du valtage e avarlalle

A: The solution can be achieved as follows.

Q: coil and capacitor are in parallel, with jBL = j0.05 and jBC = j0.03. What is the admittance vector,…

Q: Determine the phase spacing D.

Q: A load of 240 + j 120 is connected to a source of 480 V with a phase angle of 30o, through a…

Q: 3) A system has poles at 0.01 Hz, 1Hz and 80 Hz; zeros at 5 Hz, 100 Hz and 200 Hz, respectively. The…

A: Given : In the given question they have mentioned the pole and zero frequencies such as, Pole…

Question

12.
The generation of "back voltage" is a significant factor for which of the following?
O A. Capacitive reactance
O B. Phase shift
O C. Effective value
D. Inductive reactance

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Single Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A thyristor switched capacitor consists of: A. A fixed capacitance and a relatively small a relatively small surge limiting inductance B. A fixed capacitance and a relatively large surge limiting inducatance C. A variable capacitance and a relatively small surge limiting inductance D. A Variable capacitance and a relatively large surge limiting inducatnce
Draw the sinusoidal waveform of the AC voltage and current for the given loads below. Describe the characteristics of the waveform for each load. A. Pure resistor B. Pure inductor C. Pure capacitor
An alternating current varying sinusoidally with a frequency of 50 Hz has anrms value of 20 A.a) Determine the instantaneous value at 0.0025 seconds.b) Determine the instantaneous value, 0.0125 seconds after passingthrough a positive maximum value.c) At what time, measured from a positive maximum value, will theinstantaneous current be 14.14 A?
9. A noninductive load with a resistance of 30 Q2 is connected in series with a capacitor. The capacitor has a capacitive reactance of 25 Q and negligible resistance. The series circuit is energized from a 210 V, 60 Hz source. Determine: a. the impedance of the series circuit. b. the current, in amperes. c. the loss in volts across the noninductive resistance load. d. the loss in volts across the capacitor.
A capacitor C is connected in series with a 400 resistor across a supply of frequency 60 Hz. A current of 3 A flows and the circuit impedance is 500. Calculate: (a) the value of capacitance, C, (b) the supply voltage, (c) the phase angle between the supply voltage and current, (d) the p.d. across the resistor, and (e) the p.d. across the capacitor. Draw the Phasor diagram.
low voltage systems What is the general reason for selecting the capacitor voltage with a value greater than 400 V (such as 415,445 V) in Reactive Power Compensation? a) Reduce losses b) Harmonics C)Current decrease d) Voltage drop
A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
A Thyristor switched capacitor consists of: A. A fixed capacitance and a relatively small surge limiting inductance B. A fixed capacitance and relatively large surge limiting inductance C. A variable capacitance and a relatively smal surge limiting inductance D. A variable capacitance and a relatively large surge limiting inductance
1. Enumerate five formulas for series-parallel capacitances across Vt source and draw the circuit. 2. Enumerate five formulas for parallel-series capacitances across Vt source and draw the circuit.
A resistance RC and a 4 ohms capacitive reactance are in series and the combination isparallel to a 10 ohms resistance. What value of RC will yield a circuit phase angle of 450 ?.
TOE This is a photo of a capacitor that corrects the power factor in an AC setup, in DC it is used in electronic board for appliances and other small devices. Tell me something about this photo.
a) We assume that the switch is on. Calculate the reactance values and find the charging current in the circuit below. Is the circuit capacitive or inductive? Show that the voltage across the capacitance can be slightly larger than the source voltage U. (This is called the Ferranti effect and means that we can get a voltage rise beyond overhead lines with small loads. This is mostly relevant at the highest voltage levels. The frequency f is 50Hz, and assume voltage U= √2⋅24kV