10.84 If the water surface elevation in reservoir B is 110 m, what must be the water surface elevation in reservoir A if a flow of 0.03 m³/s is to occur in the cast iron pipe? Draw the HGL and the EGL, including relative slopes and changes in slope. Elevation = ? Water A T= 10°C Elevation = 110 m В L = 100 m,D= 20 cm, cast iron pipe L = 150 m D = 15 cm Cast iron pipe Problem 10.84

10.84 If the water surface elevation in reservoir B is 110 m, what must be the water surface elevation in reservoir A if a flow of 0.03 m³/s is to occur in the cast iron pipe? Draw the HGL and the EGL, including relative slopes and changes in slope. Elevation = ? Water A T= 10°C Elevation = 110 m В L = 100 m,D= 20 cm, cast iron pipe L = 150 m D = 15 cm Cast iron pipe Problem 10.84

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

o T ☺ ť The ratio between discharge and top width of a best hydraulic rectangular channel is 91/50, calculate the depth of the water and the channel width if the bed .slope is 1/ 3000 and Chezy coefficient; C = 50 مرّر للأعلى لاستعراض الفلاتر إضافة شرح. . . mum <
Q (5-7)/ Water flows uniformly in an earth rectangular cross section open. channel. Data available are: wasa.t €18.8 Longitudinal slope of bed level of the channel S, = 0.0004, n = wal aid sell 0.01 {s/m(13)), water flow rate Q=800 (m³/s) and B= 200 (m)..d =X Calculate values of the followings: 858 ETB)(-10) - CI8.8) - Water flow depth y and water flow velocity v in the channel.
Q (5-5)/ Water flows uniformly in an earth rectangular cross section open channel. Data available are: ad aspo an to zns lanoituga teoro n maiedve a) o Longitudinal slope of bed level of the channel S.= 0.0001, n = 0.025 {s/m(13)) and water flow rate Q=320 (m³/s), A = 200 (m²) and P = 100 MOON (m). Use the relation, B = 2y. tan (8/2). V/H) 0100,0 my) 200.0-n toisifices agains LEWIZZA Calculate values of the followings: y, B and v in the channel. ANSWER/ y = 4 (m), B=8 (m) and v= 1.6 (m/s). (mm) 3--0-A
A DrahmedsoilMechanicsnoteschapters pdf Downloads/DrahmedsoilMechanicsnoteschapter5.pdf 5.16 Refer to Figure in which upward seepage is taking place through a granular soil contained in a tank. Given: H1 = 1.5 m; H2 = 2.5 m; h = 1.5 m; area of the tank = 0.62 m?: void ratio of the soil, e = 0.49: G. = 2.66; and hydraulic conductivity of the sand (k) = 0.21 cm/sec. a. What is the rate of upward Valve fopen) seepage? b. Will boiling occur when h =1.5 m? Explain. c. What would be the critical value of h to cause boiling? Inflow Ans.: (a) q = 781.2 cm'isec, (b) No. (c) h = 2.77m 5.17 Refer to Figure of Problem 5.16. If H, = 0.91 m, H2 = 1.37 m. h =0.46 m, Ysat = 18.67 kN/m, area of the tank = 0.58 m2, and hydraulic conductivity of the sand (k) = 0.16 cm/sec, a. What is the rate of upward seepage of water (m/min)? b. If the point C is located at the middle of the soil layer, then what is the effective stress at C? Ans.: (a) i= 0.336, (b) q = 0.0187 m/min 5.18 A cut is made in a stiff,…
3. Two adjacent communities are represented by the simplified system shown below. Determine the water consumption and pressure at A if the pump pressure is 425 kPa, and the consumption and pressure at B are 50 L/s and 275 kPa respectively. Draw the HGL. Note, the elevation of the pump and communities A and B are provided in m. B 310.00 305.00 Pump 300.00 4000.00 400 Ø 1000.00 300 Ø C = 100 C=140
*hydraulics *Use handwritten Water Flows uniformly at a steady rate of 0.40 m3/s in a very long triangular flume which has side slopes of 1:1. the bottom of the flume is on a slope of 0.006 and n=0.012. Determine the critical depth of flow Choices: A.) 0.504 m B.) 0.604 m C.) 0.704 m D.) 0.804 m
Water flows in a trapezoidal channel 3m wide and has a side slope of 1 vertical to 2 horizontal. The bed slope is 1:5000 and depth of flow is 1.5m. Find the flowrate if Bain's constant is 0.109. ANSWER IMMEDIATELY
Hydrostatic pressure center Q\ complete the following table Tilt angle ( a ) Lowest water level Highest (sh)mm (St) mm 0 0 100 Level Weight Water Calculated Calculated FG.L FP.LD arm (FG)N level (LD)mm (FP)N (N.mm) (N.mm) L(mm) (s)mm 250 1.5 72.2 250 2.0 80.5 250 2.5 91 b= 75 (mm) y =9810 (N/m³) Calibration of pressure gauge Q\ Draw and mention the parts of the application? Orifice and jet trajectory test Q\ Determine the objective of the experiment then define the hydraulic bench?
*hydraulics *use handwritten Water Flows through the storm sewer shown laid on a slope of 0.005. Roughnesscoefficient n= 0.025. The flow rate is 2.69 m^3/s. Compute the depth of Flow. Width of water surface is 2.5 m and depth of semi circular is 0.5m. Choices: A. 0.60 m B. 0.70 m C. 0.80 m D. 0.90 m
Plz, solve the two parts of this question. Hydraulics. Reg.No: 5395 Question. a). A lined rectangular channel (n = 0.015) has a flow depth of 2m and a bed slope of 1 in 1600. Width of a channel is equal to the last digit of your registration number in meters. Retaining the rectangular shape and same total perimeter of a lining, DISCOVER the change in discharge for a most efficient x-section of a channel, if the bed slope, channel width and manning’s n remain same. b).DISCUSS the critical depth, normal depth and hydraulic depth of flow for subcritical and supercritical flow in open channel.
*hydraulics *use handwritten A rectangular channel 5.50 m wide and 1.30 m deep is laid on a uniform slope of 0.002. The roughness coefficient of the channel is 0.013. 1.) Which of the following most nearly gives the rate of flow in the channel in m^3/s. Choices are A.) 21.04 B.) 13.02 C.) 1.03 D.) 22.63 E.) 0.24 F.)0.67 2.) Which of the following most nearly gives the saving’s in lining per meter length of channel that could have been offered by using the most efficient rectangular section but adhering to the same flow capacity and slope in m^2/s. Choices are A.) 21.04 B.) 13.02 C.) 1.03 D.) 22.63 E.) 0.24 F.)0.67 3.) Which of the following most nearly gives the savings in earth excavation per meter length of channel that could have been offered by using the most efficient rectangular Section but adhering to the same flow capacity and slope in m^3/s. Choices are A.) 21.04 B.) 13.02 C.) 1.03 D.) 22.63 E.) 0.24 F.)0.67
A DrahmedsoilMechanicsnoteschapter5.pdf EMENT%20LURI/Downloads/DrahmedsoilMechanicsnoteschapter5.pdf of 62 Q 3.50 m 5.27 The dam shown in Figure is located on the anisotropic soil. The coefficients of permeability in the x and z directions are 5*107 and 1.8*10 m/s, respectively. Determine the quantity of seepage under the dam. Ans.: Nr = 3.25, Na = 12, q = 1.1 10 m/sec/m 15.00 m 1.00 m 3.00 m 8.00 m 33.00 m 8.00 m Soil Mechanics (177) Civil Eng. Dept, - College of Eng Assistant Prof. Dr. Ahmed Al-Obaidi 12:05 AM 4/12/2021 144 8. U. H. J. MI