10. At star connection unbalanced load system the neutral current is. c. less than zero b. greater than zero. a. equal to zero. A nal. d. greater than or equal to zero.
Q: Q4/Find the solution of the following operation for hexadecimal numbers F26/ O None of them O…
A:
Q: 3) Three audio waves having amplitudes of 100V, 200V and 250V respectively and corresponding…
A:
Q: 5) When the frequency of an a.c. circuit containing resistance and inductance is increased, the…
A: As per the guidelines of Bartleby we supposed to answer first three subpart only for solution of…
Q: 6) Simplify the following functions, and implement them with two-level NAND gate circuits: (a) F(A,…
A: The given Boolean expression can be implemented with the help of NAND gate by simplifying the…
Q: Q2 (a) Referring to oscillator circuit depicted in Figure Q2(a), determine the value of RF so that…
A:
Q: A 5.0 MHz magnetic field travels in a fluid for which the propagation velocity is 10x10 m/sec.…
A:
Q: The systems input output equation is in the picture find the zero state response yzs(t) to x(t) =…
A: Given data, The input-output equation:- d2y(t)dt2+4dy(t)dt+3y(t)=x˙(t)-2x(t)
Q: Qle) Find, and in the circuit given. Use KVL and ohms law only to solve. 12 V 40 60 4V
A:
Q: Show how the PAL-type array in Figure 10-64 should be programmed to implement each of the following…
A: Given A sum of products expression and we need to implement it on a PAL array. Please find the…
Q: Determine the gain of the following circuit V₁ R₂ 4 k R₁ 100 ΚΩ V.
A: Given circuit:
Q: 06) Consider the circuit shown in figure 5, assume that V Q6a) ID(en) (in mA) is: A) 0.02 B) 2 C)…
A: The circuit diagram is shown below, Where,RD = 4kΩandVZ =8 V
Q: Find lb in the circuit shown below if Vg = 25/15 V and la = 5/15ο Α. j3 Ω 19 + | | Z =j5 Ω In 4Ω −j2…
A:
Q: LI> GH LS 4H L3> 2.4K 6H 1 N2 120v Tod N3
A: Given data, The value current flow through the L2 is 30 A
Q: What is the thermal efficiency of a coal fired thermal plant having a coal consumption of 0.48…
A: In this question we need to find thermal efficiency of a given power plant.
Q: The transfer curve for a p-. 4 channel FET dose lie at Second quadrant False True O
A:
Q: With a D'Arsonval movement with
A: Voltmeter- Measuring device used to measure voltage. It is connected across (parallel) the element…
Q: An infinite length line conducts current along the Y axis. The current is unknown but the magnetic…
A: From right hand thumb rule Whenever the thumb indicates the current direction.Remaining finger…
Q: of tion Find the magnetic force acting on a charge Q-3.5 C when moving in a magnetic field of…
A:
Q: A conductive loop on the x-y plane is bounded by p = 2.0 cm, p = 6.0 cm, D = 0° and = 90°. 1.5 A of…
A: It is given that: A conductive loop on the x-y plane is bounded by ρ=2.0 cm, ρ=6.0 cm, ϕ=0° and…
Q: Q8/F(A,B,C,D)= [m(0,2,5,8,10,13)+[d(1,7,12,15) G(A,B,C,D)= [m(6,7,11,12)+[d(0,2,3,8,13,15) Chose the…
A:
Q: What are the characteristics of an ideal operational amplifier?
A: The characteristics of an ideal operational amplifier is provided in the following section.
Q: Q1: For the binary sequence 11111011111, sketch the resulting waveforms from sinusoidal modulation…
A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…
Q: draw the root locus for G4(s) on regular graph paper,
A: Given plant transfer function is G4s=1ss+3s+4s+8. The given block diagram of the closed loop control…
Q: For the circuit of the following figure: Find the total admittance Y-T Find the voltages V ̅1 and V…
A:
Q: A sinusoidal voltage is 20 V has a time of 5 ms. peak-to-peak, between consecutive peak and trough,…
A: In this question, We need to determine the general equation of the voltage If peak to peak…
Q: 1- In Memory Mapped I/O: The CPU treats I/O ports just as if they weren't memory locations. a) True…
A: Given few multiple choice questions . Please find the below attachment for clear explanation.
Q: Which of the followinh statements are true about an op-amp? a.op-amps have very high input impedance…
A: The solution is provided in the following section.
Q: Compute for the resulting current in the circuit shown. * R₁ E₁=10 Vo - Vo 47 ΚΩ 771 R1 – 2.2 ΚΩ O…
A:
Q: or the parallel operation of two 1-ph transformers with unequal induced e.m.fs; prove that: - There…
A: Transformer is the static device it is used to transfer the electrical power from one terminal to…
Q: . The discrete-time system shown in Fig. 1 is known as the unit delay element. Det whether the…
A:
Q: Calculate the the input Voltage of an inverting op-amp with the following parameters Rf = 1 MOhms,…
A:
Q: Explain in clearly the difference between Intensive and Extensive readings.
A: Given Enumerate the differences between intensive and extensive reading. Please find the below…
Q: if you design differentiator to differentiate input signal varies in frequency between 1 KHz and 20…
A: A cut off frequency magnitude response is 3 dB lower 0 Hz. Formula cutoff frequency : fc = 1(2π RC…
Q: A 150 kVA, 7500 V / 450 V, 52 Hz transformer have copper loss on full load, and it valued is 1555W.…
A:
Q: Use the concept of current division to find the steady-state expression for io(t) in the circuit…
A:
Q: 24: The cct shown use atransistor having B = 100 and Parameter values Rc = 0.5kn, RE=IKn VBB= • VCC…
A:
Q: Analyse the circuit (write all necessary steps and formulae required and upload the answer sheet)…
A: As per the guidelines of bartleyby I need to answer first three subparts only so kindly repost other…
Q: Calculate the energy required for a geared dc motor to lift a 2200-1b load through 50ft in 10…
A:
Q: By using a mass scale, five readings were taken to measure a mass of 50
A:
Q: 3U The op-amp circuit that adds each input voltage to the output multiplied by uts separate…
A: Given A multiple choice question based on operational amplifier. Please find the below attachment…
Q: A 6-pole, 3 phase, 50 Hz induction motor runs at 750 rev/min at full load. Calculate i. the…
A: In this question we will find synchronous speed , slip and frequency ...
Q: Q4/Find the solution of the following operation for hexadecimal numbers F26/A O 153.CDD O None of…
A: In this questions, we need to perform the Hexadecimal division. Now the table of Hexadecimal no. A…
Q: A 200-volt electromotive force is applied to an RC-series circuit in which the resistance is 1000…
A: It is given that: E(t)=200 VR=1000 ΩC=5×10-6 Fi(0)=0.2 A
Q: 3J Calculate the the Input Voltage of a non-inverting op-amp with the following parameters Rf =…
A:
Q: 1. Draw the output waveform for each technique (a) ASK (b) FSK (c) PSK for binary digits 10011001
A:
Q: Q4/Find the solution of the following operation for hexadecimal numbers F26/A 183.DDD O 153.CDD O…
A:
Q: If 12 v peak sine wave is applied across half wave rectifier, value of the PIV across the diode is…
A:
Q: Use 4 decimal places for your final answers. Three identical loads with resistance of 75 ohms and…
A:
Q: Q2: A JFET has parameters of Vp-6V and loss - 3mA. Plot the transconductance curve for the devi…
A: Given,For a JFET,Vp=-6 VIDSS=3 mAandVGS=0V, -1V, -3V, -5V, -6V
Q: Use star-delta transformation to find the value of the total resistance of the electrical network…
A:
Step by step
Solved in 2 steps with 1 images
- In a string of suspension insulator with three units, the line unit has 20kV and k=0.35. The voltage across tower unit is........ and across middle unit is.......Which of the following statements is/are true? A In purely resistive circuit, the current lags voltage. (B In purely capacitive circuit, the voltage lags current. In purely resistive circuit, the current is in phase with voltage. D In purely inductive circuit, the current leads voltage.7. TY Hat CHICL Ans. 1. Iron los.........varies approximately as V². 2. Cu loss..........it also varies as ² but decreases with an increase in voltage if constant kVA output is assumed. 3. Efficiency...........for distribution transformers, efficiency at fractional loads decreases with in- crease in voltage while at full load or overload it increases with increase in voltage and vice- versa. 4. Regulation..........it varies as but decreases with increase in voltage if constant kVA output is assumed. 5. Heating.........for constant kVA output, iron temperatures increase whereas Cu temperatures decrease with increase in voltages and vice-versa. quems
- Combination circuit what is PT? RT? IT? Voltage Across each load?3. What are the classifications of Core Loss and Copper Loss?What effects are produced by change in voltage? 1. Iron los..........varies approximately as V². 2. Cu loss..........it also varies as V² but decreases with an increase in voltage if constant kVA output is assumed. 3. Efficiency...........for distribution transformers, efficiency at fractional loads decreases with in- crease in voltage while at full load or overload it increases with increase in voltage and vice- versa. 4. Regulation..........it varies as but decreases with increase in voltage if constant kVA output is assumed. 5. Heating.........for constant kVA output, iron temperatures increase whereas Cu temperatures decrease with increase in voltages and vice-versa.
- Using Kirchhoff's Law, determine the load currents. All The possible current and voltage equations. With complete solutionsPower factor correction is usually done by adding _________ to the load circuit.Select the correct response:a. switchb. capacitorc. inductive loadsProblem 1 - Series en Parallel AC networks [19] Look at the circuit in Figure 1 and determine the following: (a) Total Admittance. (b) Total Impedance. (c) Total Current (l:). (d) Current (I1) through impedance Z2. (e) Current (12) through impedance Z3. (f) Current (I3) through impedance Z4. (g) Is this an inductive or capacitive circuit? A. B Zs 220V;50HZ Figure 1 (h) Voltage across Z1. (i) Voltage across A and B. G) Voltage across Zs. Z1 = 3 + j5 ohm Z2 = 10 + jo ohm Z3 = 5 + j15 ohm Z4 = 10 – j30 ohm Zs = 20 – j30 ohm Admittance and Impedance in rectangular notation. All currents and voltage in polar notation. Take voltage as reference.
- Consider three ideal single-phase transformers (with a voltage gain of ) put together as three-phase bank as shown in Figure 3.35. Assuming positive-sequence voltages for Va,Vb, and Vc find Va,Vb, and VC. in terms of Va,Vb, and Vc, respectively. (a) Would such relationships hold for the line voltages as well? (b) Looking into the current relationships, express IaIb and Ic in terms of IaIb and Ic respectively. (C) Let S and S be the per-phase complex power output and input. respectively. Find S in terms of S.A bank of three single-phase transformers, each rated 30MVA,38.1/3.81kV, are connected in Y- with a balanced load of three 1, Y-connected resistors. Choosing a base of 90MVA,66kV for the high-voltage side of the three-phase transformer. spify the base for the low-voltage side. Compute the per-unit resistance of the load on the base for the low-voltage side. Also, determine the load resistance in ohms referred to the high-voltage side and the per-unit value on the chosen base.Three single-phase, two-winding transformers, each rated 450MVA,20kV/288.7kV, with leakage reactance Xeq=0.10perunit, are connected to form a three-phase bank. The high-voltage windings are connected in Y with a solidly grounded neutral. Draw the per-unit equivalent circuit if the low-voltage windings are connected (a) in with American standard phase shift or (b) in Y with an open neutral. Use the transformer ratings as base quantities. Winding resistances and exciting current are neglected.