1. For the following part sizes and geometric tolerances, determine the appropriate geometric tolerance for each discrete part size and calculate the virtual condition. A. Pin, q2.062 +.000/-.005, I|P .002 (M)| A ]

Chapter 3: 13. What type of geometric tolerance has no datum features? 14. A theoretically exact dimension is called a 15. The feature symbol specifies that a group of two or more interrupted features of size are to be considered one single feature of size. 16. For an individual regular feature of size, no element of the feature shall extend beyond the maximum material condition boundary (envelope) of perfect form. This statement is the essence of 17. What is the name of the symbol used to identify physical features of a part as a datum feature and must not be applied to centerlines, center planes, or axes? 18. The is the condition in which a feature of size contains the maximum amount of material within the stated limits of size. 19. The total positional tolerance equals the sum of the tolerance and the tolerance.

Given the drawing below, answer questions

7. This problem relates to tolerance stack-up using the absolute tolerance system, as explained in section 1-14. In the figure below, specified dimensions are as follows (all units in inches): a d 1.750 + 0.001 2.000 + 0.003 3.200 + 0.005 ?+0.010

Please answer fast max 30 minutes thank u

A piston ring from the piston in the previous problem needs to be replaced.Its thickness is measured using a vernier caliper. The vernier is shown. Whatis the thickness of the replacement ring?

In order to measure the extension of perfection in the mesh, the method of skewness is used.

Help needed in sketching thanks

Please finish

For a 10 H7/p6 fit