1. An accelarated aging-test is to be performed on a bushing with a capacitance of 1250 pF by applying a voltage of 275 kV at a frequency of 4 kHz. A series- resonant circuit will be designed with a wire-wound inductor having a quality factor, Q, of 11. Calculate, (a) The output voltage and power necessary for the 4-kHz supply, (b) The magnitude of the inductance required, and (c) The current from the supply if the bushing breaks down during the test. (Consider the breakdown as an ideal short circuit.)

1. An accelarated aging-test is to be performed on a bushing with a capacitance of 1250 pF by applying a voltage of 275 kV at a frequency of 4 kHz. A series- resonant circuit will be designed with a wire-wound inductor having a quality factor, Q, of 11. Calculate, (a) The output voltage and power necessary for the 4-kHz supply, (b) The magnitude of the inductance required, and (c) The current from the supply if the bushing breaks down during the test. (Consider the breakdown as an ideal short circuit.)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Consider the circult given below a) Identify the circuit with details b) Find the Q-point O Find Vs,Vs Vo, Vos and Vas d) Find the RMS output voltage and draw it In the same graph- with Input e) Comment on the output signal if the input increases to Vinp=20V V 18 V 2.7 w - 10 MA atanm - - 6 V C 100F -0.3 F 1.5 MD - 130 F 220 11
2.A series R -L-C circuit is to be made resonance when connected to a 200 – volt 500 cycle source. If the inductance is 0.047 henry, determine the capacitance of the capacitor and the minimum ohmic value of the resistor if the voltage drop across the capacitor is limited to 580 volts?
In a RC type low pass fitter, the cut-off frequency is 1500 Hz, Assuming the capacitance to be 500 nF. The value of the resistance is - (in)
A full-wave rectified voltage of 18 V peak is connected to a 400micro F filter capacitor. What are the ripple and dc voltages across the capacitor at a load of 100 mA?
Show the capacitors, whether it is effective at low or high frequencsies Draw low frequency small-signal-equivalent circuit. AND LOWER corner is 82Hz frequency. Design the circuit. Draw the high frequency small-signal-equivalent circuit. AND UP-CORNER İS 172Hz frequency. DESİGN THE CIRCUIT.
100 used to compand A companding system with u from 0V to 10 V sinusoid signal. Draw the characteristic of the typical system.
A reactor of resistance 50 ohms and inductance of 150 mH is connected in parallel with a capacitor, what must be the capacitance of the capacitor to produce resonance to 250 volt, 60Hz main? QUICKLY I NEED IT IN5 MINS
THW FREQUENCY RESPONSE ( NEED NEAT HANDWRITTEN SOLUTION PLEASE OTHERWISE DOWNVOTE).
Calculate the bandwidth in kHz Blank 1 and an inductor's Q Blank 2 at100MHz. It has an inductance of 6mH and a series resistance of 1.2k2.
A resistor of resistance R=1000 Q is maintained at 17 °C and it shunted by 100 µH inductor. Determine the rms noise voltage across the inductor over a frequency bandwidth of: Ans: 182 x109 volt i) ii) 15.9 kHz 159 kHz Ans: 9.22 x10-8 volt 111) 1590 kHz Ans: 2.34 x10-6 volt
H.W: A resistor of resistance R-1000 2 is maintained at 17 °C and it shunted by 100 uH inductor. Determine the rms noise voltage across the inductor over a frequency bandwidth of: i) 15.9 kHz Ans: 182 x109 volt ii) iii) Ans: 9.22 x10-8 volt Ans: 2.34 x10-6 volt 159 kHz 1590 kHz
5. For a 1Vpp sinusoidal input, at a frequency of 1KHz, draw the output for each circuit.