1) Heating the water in a 55-gallon water heater requires about 2.0 x 103 kJ of energy. a) Assume the energy came from natural gas with 80% efficiency; how many grams of natural gas are required? b) Assume the energy came from electricity with 80% efficiency and that the electricity was produced from the combustion of coal with 30% efficiency; how many grams of coal are required?

1) Heating the water in a 55-gallon water heater requires about 2.0 x 103 kJ of energy. a) Assume the energy came from natural gas with 80% efficiency; how many grams of natural gas are required? b) Assume the energy came from electricity with 80% efficiency and that the electricity was produced from the combustion of coal with 30% efficiency; how many grams of coal are required?

Sustainable Energy

2nd Edition

ISBN:9781337551663

Author:DUNLAP, Richard A.

Publisher:DUNLAP, Richard A.

Chapter3: Fossil Fuel Resources And Use

Section: Chapter Questions

Problem 17P

See similar textbooks

Similar questions

Problem 10 A homeowner is trying to decide between a high-efficiency natural gas furnace with an efficiency of 95 percent and a ground-source heat pump with a COP of 3.3. The unit costs of electricity and natural gas are $0.112/kWh and $1.44/therm (1 therm = 105, 500 kJ). Determine which system will have a lower energy cost.
Consider a 400-MW, 32 percent efficient coal-fired power plant that uses cooling water withdrawn from a nearby river (with an upstream flow of 10-m3/s and temperature 20 °C) to take care of waste heat. The heat content of the coal is 8,000 Btu/lb, the carbon content is 60% by mass, and the sulfur content is 2% by mass. How much electricity (in kWh/yr) would the plant produce each year? How many pounds per hour of coal would need to be burned at the plant? Estimate the annual carbon emissions from the plant (in metric tons C/year). If the cooling water is only allowed to rise in temperature by 10 °C, what flow rate (in m3/s) from the stream would be required? What would be the river temperature if all the waste heat was transferred to the river water assuming no heat losses during transfer? Estimate the hourly SO2 emissions (in kg/h) from the plant assuming that all the sulfur is oxidized to SO2 during combustion.
An average American consumes approximately 105 kJ of energy per day. The average life expectancy of an American is 77.9 years. How much coal would need to be burned to provide enough energy to meet a person's energy demands if the efficiency of energy production from coal is 38%? ☐g coal
Calculation of Energy saving We are given that Average energy use for waste water treatment = 652 KWh for 625,853 gallons Average energy use for 1 gallon waste water treatment = 652625,853 KWh Per day Average energy use for 29.522 Million gallon waste water treatment = 652625,853*29.522*106 Per day Average energy use for 29.522 Million gallon waste water treatment = 30753.29 KWh " Per day Energy saving = 30753.29 KWh " Finding How to come up with 30753.29KWh? If 652 KWh for 625,853 gallons 652,853*29.522*106 = ??
We have exposed 1 kg of water, 1 kg of brick, and 1 kg of concrete each to a heat source that puts out 100 J every second. Assuming that all of the supplied energy goes to each material and they were all initially at the same temperature, which one of these materials will have a greater temperature rise after 10 s? We can answer this question using Equation as shown . We will first look up the values of the specific heat for water, brick, and concrete, which are cwater = 4180 J⁄kg K, cbrick = 960 J⁄kg K and cconcrete = 880 J⁄kg K . Now applying as shown , Ethermal = mc(Tfinal Tinitial) to each situation, it should be clear that although each material has the same amount of mass and is exposed to the same amount of thermal energy, the concrete will experience a higher temperature rise because it has the lowest heat capacity value among the three given materials.
What is the best definition for non- renewable energy? O a. It is energy collected by humans that can be replaced after five to ten years. O b. It is energy from finite sources that cannot be replaced by natural means at a quick pace of time. O c. It is energy from finite sources that can be replaced after using them. O d. It can be measured in joules or kilowatts.