1-71 Consider a U-tube whose arms are open sphere. Now water is poured into the U-tube fr and light oil (p = 790 kg/m³) from the other. One 70-cm-high water, while the other arm contain with an oil-to-water height ratio of 4. Determine each fluid in that arm. %3D

solve this please on ANSYS and give me screenshots how you did it, please

I asked for problems 6 and 7 to be answered, but I did not get a properly structured answered as the example shows on problem number 1. Here is the link to the questions I already had answered, could you please rewrite the answer so its properly answered as the example shows (Problem 1)?   https://www.bartleby.com/questions-and-answers/it-vivch-print-reading-for-industry-228-class-date-name-review-activity-112-for-each-local-note-or-c/cadc3f7b-2c2f-4471-842b-5a84bf505857

Topic/s: Force System of a Force, Moment of a Force, Moment of a Force-Scalar Formulation,Moment of a Force-Vector Formulation, and Principle of Moment.   Reminder: Kindly show the complete step-by-step solution. Please make sure that your handwriting is understandable and the picture of the solution is clear. I will rate you with “like/upvote” after.   Thank you.

I am confused because on my homework i got marked wrong for this, unless I used to many sig figs.

An electric hot water heater consumes 3.1 kilowatts of electricity and converts it to heat. How long will it take the water heater to heat a 67 gallon tank of water from 10 degrees Celsius to 50 degrees Celsius? (1 kilogram of water is 0.37 gallons, 1 Calorie = 4200 J).  It may be helpful to refer back to the weekly handout for guidance on this problem. Your final answer should be in minutes (rounded to the nearest 10 minutes).

help[

Hello sir, I want to solve in a clear beautiful font that will be a manual line with a pen I know a strange request and don't forget my name and thank you sir, God bless you

[Chapter 2: Drawing in AutoCAD®] P2-8) May be attempted after completing the Object Snap Tutorial in section 2.20. Draw the following object in AutoCAD using object snap commands where necessary. Put your name on the drawing and then print it using a Window and the Scale to Fit option. Dimensions are in inches. 3.00 4.00 3.25 Perpendicular Tangent #3.00

It is still saying that is not correct. I have tried this practice problem over and over and that is the only part that it keeps saying is incorrect. the negative and units are correct. I appreciate your help.