0.7500 t.0008 1.1808 1.1800 Calculate the diameter limits for the shaft, 'ØW', to have a total tolerance of .0014 and a minimum clearance, i.e., allowance, of .0006. (Dimensions are in inches.) ØWmax = ØWmin = Calculate the diameter limits for the bushing, 'ØY', to have a total tolerance of .0006 and a minimum interference of zero (0). (Dimensions are in inches.) ΟΥmax ΟΥmin

Define the term work of force?

Question 1 An engineer first draws a circle in a plane and uses a tool to convert the circle to a disk that is 3 mm thick in SOLIDWORKS. The engineer most likely used the feature. Chamfer Fillet Hole Extrude

Dari gambar di atas gambarlah diagram bebas untuk semua batang.Kemudian carilah gaya reaksi tumpuan pada titik A dan G , serta gaya padatitik-titik sambungan semua batang(Cari dulu gaya reaksi pada tumpuannya, lalu gaya pada titik-tiksambungannya)

Question 4 a) Each cylinder in a four-cylinder car engine has a bore diameter of 63.53 mm and the stroke for each piston is 175.00 mm. Calculate the cubic capacity of the engine in cm? and calculate the clearance volume per cylinder for a compression ratio, r, of 6.25. b) The bore diameter of each cylinder in a six-cylinder four-stroke internal combustion engine is 32 mm and the stroke of each piston is 125 mm. During testing., the engine runs at 1450 revolutions per minute (rpm) with a pressure-volume indicator diagram showing a mean net area of 2.90 cm and a diagram length of 0.85 cm. The pressure scale on the indicator diagram is set to 165 kN/m per cm. Calculate the mean effective pressure (m.e.p) and the indicated power in kilowatts (kW) developed by this six-cylinder four-stroke engine. Give your answer to 2 decimal c) A hollow connecting rod has an inner diameter of 26.25 mm and is subjected to an axial tensile load of 500 MN. If the maximum allowable stress for this hollow rod…

2. What is the mechanical advantage of a claw foot hammer having a handle with a length of 45 cm and head length of 10 cm?

Power is supplied at the rate of 0.40 hp for 2 min in drilling a hole in a 1.0 lb brass block. (a) How much heat is generated? (b) What is the rise in temperature of the brass if 75% of the heat generated warms the brass? What happens to the other 25%? (don't change the hp, lb)

2) A washer is going to be manufactured by cutting operation out of 2024ST aluminum alloy sheet that has a thickness of 2.5 mm. The outside diameter of the washer is 25.0 mm, and the inside diameter is 12.0 mm. Make a rough sketch, define the geometries to be used and determine a. The punch and die size for the blanking operation b. The punch and die size for the punching operation c. The force required performing the blanking and punching operation simultaneously. The aluminum has a tensile strength = 300 MPa.

I was given this image for the purpose of studying for an upcoming exam. No additional info was given. Any suggestions on how to study for potential questions that could be asked about this image?

Why is your Reynold's number 1400 instead of 2300?