Servicing

Finally, place the 96 well plates in a CO2 incubator (37ºC) for 24 hours and read on a florescent

1. Move the lid of the container up or down. Record the resulting volume and pressure

If a specific piece of equipment is necessary for patient care, the manager must have the long-range plan for the life of the instrument and then plan annually to account for the costs associated with the equipment. The manager should present the budget using both qualitative and quantitative

In Figure 2, the lower meniscus lies below the 3 mL line and 4 minor gradations that signify 0.1 values. Estimating the uncertain digit to be 0.04 mL, the reading we record for this particular buret is 3.44 mL.

Max’s SBR level of 300mmol/L at 60 hours old requires phototherapy treatment according to the SAPPG hour specific bilirubin chart (Image 2) (SAMNCN 2010). Following the recommendation of the ISBAR, phototherapy using a bilibed is to be commenced on the early shift. Seeing as Max is otherwise well, it is appropriate for him to remain in the open bassinet with correct monitoring whilst receiving phototherapy treatment via a bilibed (Flinders Women & Children Division 2014; QMNCGP 2012). Important points to consider when caring for a baby receiving phototherapy treatment include: ensuring correct skin care – washing with water only, no oils or creams used on exposed skin, ensuring the neonate is naked aside from a nappy and eye protection pads to maximise skin exposure to the lights and ensuring adequate hydration by monitoring fluid intake, urine output and observing stool consistency (RPAHNC 2005; Maisels, J 2006). Max’s SBR should be rechecked according to local protocol but generally 6 hours after phototherapy was commenced to assess the effectiveness of the phototherapy (QMNCGP 2012). It is vital to ensure phototherapy lights are

· I set up the apparatus as shown in the diagram. I then placed a

P- What is the technique utilized during IM injection and the incidence of blood aspiration?

Follows efficient, logical sequence; balances screening/diagnostic steps for problem; informs patient; sensitive to patient’s comfort, modesty.

1 ml of water should be added to the first test tube and make a note. In the second test tube, 1 ml of methyl alcohol should be added. In the third test tube, 1 ml of hexane must be added. Lastly, the fourth test tube will be a control.

Remove foam plug from the inoculate flask and pour it into a cuvette. Incubate it at 37°C and the optical density readings at 600nm every 10-15 mins. Pour into the

The leveling bulb must be leveled with the amount of water in the buret at all times. Timing should begin after 2 ml of oxygen has been produced and must be recorded at 2 ml intervals until 14 ml of oxygen has accumulated. After recording the time, the first part of the experiment is now complete.

1. Maintain a constant water level (head) difference between the two sides of the tank as shown in the diagram by allowing water to overflow through the overflow and outflow tubes. Measure the water level (head) difference.

equilibration period, immerse all six respirometers into the water completely. Water will enter the pipette for

8.After 5 minutes, remove test tubes from the water bath set in test tube holder and record results. Also turn off hot plate.

5.Wait 5 minutes. During these 5 minutes, set all 4 of the syringe plungers on the gas measuring mechanism at 2mL.