btw 250 nominalization
.pdf
keyboard_arrow_up
School
University of Illinois, Urbana Champaign *
*We aren’t endorsed by this school
Course
250
Subject
Civil Engineering
Date
Apr 3, 2024
Type
Pages
2
Uploaded by ProfessorCobraPerson1022
1. Our expectation was to establish new tolerance levels.
We expected to establish new tolerance levels.
2. Attempts were made on the part of the engineering staff in regard to an assessment of the
project.
Engineering staff attempted to assess the project.
3. There were expectations by the governing committee that their report submission would meet
the deadline.
The governing committee expected to submit their report on the deadline.
4. The appearance of the candidate before the board was on June 30.
The candidate appeared before the board on June 30.
5. The governor’s refusal of the request is a necessity.
The governor needs to refuse the request.
6. A presidential appeal was made to the American people for the conservation of gasoline.
The American people received a presidential appeal for the conservation of gasoline.
7. More accurate measurements of the thorium half-life were conducted at that time by
independent investigators.
Independent investigators conducted additional accurate measurements of the thorium half-life.
8. Discussions by the participants in the future of the program were conducted amicably.
The participants in the future of the program conducted the discussions amicably.
9. There was no independent business sector analysis of the cause of the trade deficit.
No independent business sector analyzed the cause of the trade deficit.
10. Agreement as to the need for revisions in the terms of the treaty was reached by both sides.
Both sides agreed they needed to revise the terms of the treaty.
11. There was uneasiness among management over the results of the survey.
Management was uneasy over the results of the survey.
12. There must be thorough preparation of the specimen sections by the laboratory personnel.
Laboratory personnel must thoroughly prepare the specimen sections.
13. The discrepancy in the data demands checking by the insurer.
The insurer needs to check the discrepancy in the data.
14. The rejection of the application by the dean was unexpected.
The dean rejecting the application was unexpected.
15. The performance by the police of an investigation into the affair occurred without delay.
The police performed an investigation into the affair without delay.
16. There should be no hesitation in regard to saying no.
Saying no should have no hesitation.
17. The same principles of bilateral symmetry received study after the last report.
After the last report, researchers studied the same principles of bilateral symmetry.
18. A solution to the UFO problem will never be found by the Air Force.
The Air Force will never find a solution to the UFO problem.
19. It is my belief that there should be consultation among the administrators with the student
body before changes in rules are made.
I believe the administrators should consult with the student body before making changes in rules.
Your preview ends here
Eager to read complete document? Join bartleby learn and gain access to the full version
- Access to all documents
- Unlimited textbook solutions
- 24/7 expert homework help
Related Questions
Q.4 (a) A new concrete bridge is to be constructed near the sea and its design has to incorporate features protecting it from exposure to marine environments. Among these, a new coating system is being proposed for concrete. You have been awarded a six-month contract to evaluate this system and materials involved. Describe the major parts of your programme, assuming that you also have access to a structure on which the coating has recently been used.
arrow_forward
Describe the type of test conducted during waste water treatment along with the procedure.
arrow_forward
What is the major difference between high-risk respirable fraction (HRPM) and respirable fraction (RPM)?
arrow_forward
Q.1 Chemical admixtures have been used in the production of concrete to improve
its performance in both fresh and hardened states. Discuss the choice of
admixtures available to impart the specific properties mentioned below. For each
case, comment on the mode of action, including effects on chemical action,
hydration process and properties of the concrete:
(a)
Construction of heavily reinforced beams,
(b) Concreting in cold weathers.
arrow_forward
Please answer clearly
arrow_forward
Q2 bHow can you determine chloride content in a waste water sample?
arrow_forward
1. summarize the definition of the following items and give the formula.
① Specific surface area; ② Porosity; ③ Saturation and ④permeability
arrow_forward
sample of a work breakdown structure on construction of a single storey house.
arrow_forward
Make an outline discussion to the
following questions/ statements listed in the given. You may add illustrative examples, illustrations such as schematic diagrams or figures to support your answers.
a) Differentiate between unconsolidated undrained test and a drained test. Under
what conditions are these test results used for design purposes?
arrow_forward
1. Present two separate summaries for making and curing cylinder and beam sample in accordance with ASTM C31.
arrow_forward
Recommend and justify the potential usage of AR with BIM in construction
arrow_forward
Discuss any test done on the five different materials of wastewater treatment plant
arrow_forward
The following data is the result in performing the ASTM C128, Determine the Bulk Specific Gravity, (SSD)
Mass of Pycnometer
Mass of pycnometer filled with
water
250.00
1,160.00
Mass of SSD sample
900.00
Mass
specimen and water
Mass of oven-dried sample
of
pycnometer
with
1,724.00
895.00
(A) None of the above
B) 2.70
c) 2.68
2.66
arrow_forward
The average compressive strength of concrete paving blocks produced at ABC Company is measured by testing three blocks from each batch of production. The test results for 15 consecutive samples are given below.
a) Develop ‘mean’ and ‘range’ charts for three-sigma quality control.
b) Comment about the status of the process.
arrow_forward
When it comes to the procedure, what is the difference between the two laboratory permeability determinations?
What are the difference between the two laboratory determinations of permeability when it comes to the results?
arrow_forward
A BOD analysis was begun on Monday. Fifteen ml of waste with a DO of zero was mixed with 270 mL of dilution water with a DO of 9 mg/L. The sample was then put in the incubator. Since the 5th day fell on a long weekend (Friday) and lab personnel do not work on Saturday, the final DO did not get measured until Monday, the eighth day. The final DO was measured at 2.8 mg/L. However, it was discovered that the incubator was mistakenly set at 32 ºC. Assume k is 0.15 day-1 at 20 ºC and θ= 1.05. Determine the 5-day 20 ºC BOD of the sample. Also, what is the ultimate CBOD at 32 ºC and 20 ºC; Will it vary?
arrow_forward
Subject : Environmental science
Note: Don't copy from other websites and Internet.
Question : What the main source of total suspended solid during construction activities?
arrow_forward
What are the procedures, apparatus, and calculations needed for shrinkage limit test?
arrow_forward
Case4: A consulting engineering company was awarded the
contract for
designing, preparing the specifications, and providing "field
inspection services" (monitoring the construction) of a sewage
treatment plant being built for a small municipality. The
construction proceeded routinely to completion. The consulting
company employed Engineer A, an environmental engineer
experienced in wastewater treatment, to assist in the field
inspection. During the final commissioning of the plant,
Engineer A observed that the biochemical oxygen demand
(BOD) of the effluent was frequently above the acceptable limit.
Engineer A contacted the design office at his engineering
company, and after reviewing the case with an environmental
consultant, he soon realized that the plant had been designed for
average flows, but several food-processing industries in the
municipality occasionally fed "slugs" of raw sewage to the
plant. The biochemical oxygen demand would increase rapidly
when one of these slugs…
arrow_forward
What are the steps followed in testing?
arrow_forward
Q7) What is the difference between a design value and an allowable and how does variability in material properties impact this behavior?
arrow_forward
Define the minimum curing period ?
arrow_forward
V.
DATA AND TABULATION
1. Depending upon the form of the specifications for use of the material under test, the
report shall include the following:
1.1. Total percentage of material passing each sieve, or
1.2. Total percentage of material retained oneach sieve,
or
1.3. Percentage ofmaterial retained between consecutive sieves.
2. Report percentages to the nearest wholenumber, except if the percentage passing the
75-um (No. 200) sieveis less than 10 %, it shall be reported to the nearest 0.1%.
3. Report the fineness modulus, when required, to the nearest 0.01.
CUMULATIVE
CUMULATIVE
SIEV
AMOUNT
AMOUNT
PERCENT
PERCENT
RETAINED, g (b)
RETAINED, 9
(a)
RETAINED,
(c)=(b)*100/TÓT
E
PASSING
SIZ
(d)=100 - (c)
AL
1%
215
885
3/4
980
1/2
2350
3/8
1190
4.
2205
1985
10
1840
40
1650
100
980
200
660
PAN
60
15000
ТОTAL
[7]
arrow_forward
Why is a comparison made between the percent of the sample passing the No. 12 sieve after one-fifth of the Los Angeles Abrasion test and the percent passing at the completion of the test? Explain.
arrow_forward
A new water supply system was installed in a southern state. Part of the system was a large outdoor holding tank placed in the ground near a farm field. Shortly after installation, unacceptable levels of contamination were found. An investigation revealed that the contamination was caused by dead rats decaying in the holding tank. The problem statement that went out was find a way to keep the rats out of the tank. Prepare a Duncker diagram to analyze this situation.Please answer very soon will give rating surely
arrow_forward
please, I can't encourage chat
gpt answer properly
Discuss the importance of initial curing in concrete construction.
arrow_forward
List the given and required. Box the final answer.
arrow_forward
SEE MORE QUESTIONS
Recommended textbooks for you
Traffic and Highway Engineering
Civil Engineering
ISBN:9781305156241
Author:Garber, Nicholas J.
Publisher:Cengage Learning
Related Questions
- Q.4 (a) A new concrete bridge is to be constructed near the sea and its design has to incorporate features protecting it from exposure to marine environments. Among these, a new coating system is being proposed for concrete. You have been awarded a six-month contract to evaluate this system and materials involved. Describe the major parts of your programme, assuming that you also have access to a structure on which the coating has recently been used.arrow_forwardDescribe the type of test conducted during waste water treatment along with the procedure.arrow_forwardWhat is the major difference between high-risk respirable fraction (HRPM) and respirable fraction (RPM)?arrow_forward
- Q.1 Chemical admixtures have been used in the production of concrete to improve its performance in both fresh and hardened states. Discuss the choice of admixtures available to impart the specific properties mentioned below. For each case, comment on the mode of action, including effects on chemical action, hydration process and properties of the concrete: (a) Construction of heavily reinforced beams, (b) Concreting in cold weathers.arrow_forwardPlease answer clearlyarrow_forwardQ2 bHow can you determine chloride content in a waste water sample?arrow_forward
- 1. summarize the definition of the following items and give the formula. ① Specific surface area; ② Porosity; ③ Saturation and ④permeabilityarrow_forwardsample of a work breakdown structure on construction of a single storey house.arrow_forwardMake an outline discussion to the following questions/ statements listed in the given. You may add illustrative examples, illustrations such as schematic diagrams or figures to support your answers. a) Differentiate between unconsolidated undrained test and a drained test. Under what conditions are these test results used for design purposes?arrow_forward
- 1. Present two separate summaries for making and curing cylinder and beam sample in accordance with ASTM C31.arrow_forwardRecommend and justify the potential usage of AR with BIM in constructionarrow_forwardDiscuss any test done on the five different materials of wastewater treatment plantarrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Traffic and Highway EngineeringCivil EngineeringISBN:9781305156241Author:Garber, Nicholas J.Publisher:Cengage Learning
Traffic and Highway Engineering
Civil Engineering
ISBN:9781305156241
Author:Garber, Nicholas J.
Publisher:Cengage Learning