Modern Physics
2nd Edition
ISBN: 9780805303087
Author: Randy Harris
Publisher: Addison Wesley
expand_more
expand_more
format_list_bulleted
Concept explainers
Videos
Textbook Question
Chapter 4, Problem 12E
Analyzing crystal diffraction is intimately tied to the various different geometries in which the atoms can be arranged in three dimensions and upon their differing effectiveness in reflecting waves. To grasp some of the considerations without too much trouble, consider the simple square arrangement of identical atoms shown in the figure. In diagram (a), waves are incident at angle
with the crystal face and are detected at the same angle with the atomic plane. In diagram (b), the crystal has been rotated 45° counterclockwise, and waves are now incident upon planes comprising different sets of atoms. If in the orientation of diagram (b), constructive interference is noted only at an angle
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
Calculate the wavelength corresponding to an electron with the energy of 103 eV (kiloelectronvolt). Give your answer in Angstrom (10-10 m, for example, if the answer is 1.6x10-10 m, then write 1.6 as your answer). This should give you a good idea why one can use a crystal lattice with an average interatomic distance of around 10-10 m to observe electron diffraction.
Calculate the wavelength corresponding to an electron with the energy of 95 eV (kiloelectronvolt). Give your answer in Angstrom (10-10 m, for example, if the answer is 1.6x10-10 m, then write 1.6 as your answer). This should give you a good idea why one can use a crystal lattice with an average interatomic distance of around 10-10 m to observe electron diffraction.
(the answer 1.25 was incorrect that i found)***
At room temperature, the diffractogram of a cubic material with lattice parameter of 10Å presents a peak at 2θ = 20o. At a higher temperature, the lattice parameter has expanded 20%. Calculate the 2q value of the diffraction peak of the material at the high temperature. λλ is fixed. Do not assume a particular (hkl) set of values, nor a value for λ.
Chapter 4 Solutions
Modern Physics
Ch. 4 - Prob. 1CQCh. 4 - Prob. 2CQCh. 4 - Prob. 3CQCh. 4 - Prob. 4CQCh. 4 - Prob. 5CQCh. 4 - Prob. 6CQCh. 4 - Prob. 7CQCh. 4 - Prob. 8CQCh. 4 - Prob. 9CQCh. 4 - Prob. 10CQ
Ch. 4 - Prob. 11ECh. 4 - Analyzing crystal diffraction is intimately tied...Ch. 4 - The setup depicted in Figure 4.6 is used in a...Ch. 4 - Prob. 14ECh. 4 - Prob. 15ECh. 4 - Prob. 16ECh. 4 - Prob. 17ECh. 4 - Prob. 18ECh. 4 - Prob. 19ECh. 4 - Prob. 20ECh. 4 - Prob. 21ECh. 4 - Prob. 22ECh. 4 - Prob. 23ECh. 4 - Prob. 24ECh. 4 - Prob. 25ECh. 4 - Prob. 26ECh. 4 - Prob. 27ECh. 4 - Prob. 28ECh. 4 - Prob. 29ECh. 4 - Prob. 30ECh. 4 - Prob. 31ECh. 4 - Prob. 32ECh. 4 - Prob. 33ECh. 4 - Prob. 34ECh. 4 - Prob. 35ECh. 4 - Prob. 36ECh. 4 - Prob. 37ECh. 4 - (a) Experiment X is carried out nine times...Ch. 4 - Prob. 39ECh. 4 - Prob. 40ECh. 4 - Prob. 41ECh. 4 - Prob. 42ECh. 4 - Prob. 43ECh. 4 - Prob. 44ECh. 4 - Prob. 45ECh. 4 - Prob. 46ECh. 4 - Prob. 47ECh. 4 - Prob. 48ECh. 4 - Prob. 49ECh. 4 - Prob. 50ECh. 4 - Prob. 51ECh. 4 - Prob. 52ECh. 4 - Prob. 53ECh. 4 - Prob. 54ECh. 4 - Prob. 55ECh. 4 - Prob. 56ECh. 4 - Prob. 57ECh. 4 - Prob. 59ECh. 4 - Prob. 60ECh. 4 - Prob. 61ECh. 4 - Prob. 62ECh. 4 - Prob. 63ECh. 4 - Prob. 64ECh. 4 - Prob. 65ECh. 4 - Prob. 67ECh. 4 - Prob. 68ECh. 4 - Prob. 71CECh. 4 - Prob. 72CECh. 4 - Prob. 73CE
Additional Science Textbook Solutions
Find more solutions based on key concepts
The effect when a wave passes from one medium into another.
Glencoe Physical Science 2012 Student Edition (Glencoe Science) (McGraw-Hill Education)
(II) Show that Eq. 8–16 for gravitational potential energy reduces to Eq. 8–2. ΔU = mg(y2 − y1), for objects ne...
Physics for Scientists and Engineers with Modern Physics
Calculate the mass of a mole of dry air, which is a mixture of N2(78%byvolume),O2(21%), and argon(1%).
An Introduction to Thermal Physics
37.56 In the earth’s rest frame, two protons are moving away from each other at equal speed. In the frame of ea...
University Physics (14th Edition)
121. Does more current "flow" out of a battery than into it? Does more current "flow" into a light bulb than ou...
Conceptual Physical Science (6th Edition)
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- The below table lists diffraction angles for the first three peaks (second -order) of the X-ray diffraction pattern for some metal. Monochromatic x-radiation having a wavelength of (0.1234 nm) was used for BCC crystal ? (a) Determine the lattice constant. ( b) radius of atoms. Peak Number miller Diffraction indies Angle (2e) 1 111 80 101 96 3 200 102arrow_forwardIf a single crystal sample, such as a silicon wafer, is attached to a sample holder and analyzed using an X-ray diffractometer, given the constraints of XRD devices and experimental conditions, draw any two-dimensional reciprocal lattice and Ewald sphere to see what a valid reciprocal space will look like. Also explain why it can be expressed as the above.arrow_forwardWhich of the following is an advantage of using electrons in cryo-EM as opposed to X-ray electromagnetic radiation in crystallography. Check all that apply retain amplitude information V permit to obtain charge density distribution magnification of the signal due to lattice effects V retain phase information Which of the following are NOT important in post-image analysis. Check all that apply sufficiently large number of images for correct image reconstruction O determination of relative sample orientation back projection of your image O reconstruction of phase information similar to X-ray crystallography process Which of the following methods are NOT used for cryo-EM image reconstruction backprojection fourier inversion multiple rounds of refinement of your model use of a known homologous structure as a refererence splitting your data set in half ( or more) parts and working with each one individually to have a cross-check validation of your model O all of the choices are used in…arrow_forward
- The half value layer (HVL) of a material is defined as the thickness of the material needed to reduce the intensity of the incident x-ray beam to half its value. Assume that the x-ray beam is monochromatic, no scattering occurs and that material A (as shown in Figure 1) is. homogeneous and has a linear attenuation coefficient (u.). Material A has an HVL of 1.5 mm. Calculate the ratio l/lz as shown in Figure 1 if x-5 mm. lo HA=?? 2x Figure 1: Schematic diagram fr question 3.arrow_forwardQuestion 3 Consider the simple and close-packed hexagonal direct lattices. (a) Find out the general expression for the structure factor for each lattice type. In this context, what is the significance of a complex structure factor? (b) Without resorting to the structure factor, determine in which structure(s) X-ray Bragg reflections arise from the lattice planes (0001), (0002), and (1010). Justify your answer by the use of the above determined structure factor or otherwise and explain the meaning of the four indices describing the above cited lattice planes.arrow_forward5.3. A material of simple tetragonal Bravais lattice (a = 2.4 Å, c = 3.6 Å) is prepared in a plate shape so that the sample surface is parallel to (001). When the sample was symmetrically scanned in the 20 range from 20° to 100° using an X-ray beam at 1.54 Å, at which 20 positions will the diffraction peaks be observed? How will the diffraction pattern change if the sample is replaced by a crystal of body-centered tetragonal lattice? Assume that all the other condi- tions are the same.arrow_forward
- Problem 10: Two flat mirrors are connected to each other such that they make an angle of ψ. A laser enters the system and first reflects off the bottom mirror, then the top mirror. When the beam exits it makes an angle of θ = 107 degrees with respect to the initial beam (see figure). Part (a) Write an expression for the angle, ψ, between the mirrors. Part (b) Calculate this angle, ψ, in degrees.arrow_forwardQ. 1. An X-ray beam of wavelength 0.71 A is diffracted by a cubic KCL crystal of density 1.99x10^3 Kgm-3. Calculate the interplanner spacing for (200) planes and glancing angle for the second order reflection from these planes. The molecular weight of KCL is 74.6 amu and the Avagadro’s numberis 6.023x10^26 Kg-1 mole-1.arrow_forwardmetal with body centered cubic (bcc) structure shows the first (i.e. smallest angle) diffraction peak at Bragg angle of ( theta=30degree). The wavelength of ( X )-ray used is ( 2.1 A ). The volume of primitive unit cell of the metal isarrow_forward
- A beam of X-ray diffraction (XRD) with a CuKa radiation of wavelength, λ = 1.541 Å, falls on a powder of three samples (A, B and C) which crystallized in the following crystal structure: sample A: body center cubic (BCC) with lattice parameter a = 4 Å; sample B: tetragonal, with lattice parameters a = b = 4 Å and c = 6 Å and sample C: orthorhombic, with lattice parameters a = 4 Å, b = 6Å and c = 8 Å. 1. For the first order Bragg diffraction, which of the three sample will give the smallest Bragg angle on the plan (111)? 2. Explain clearly with some calculations, if there will be higher order reflections on the plan (111) for the three samples.arrow_forwarda) Problem 9.6 of Textbook: If the spot size at the mirror of a helium-neon laser is 0.5mm, what is the length of the laser cavity? The cavity is of the confocal-type and the wavelength is 633nm. b) For a semiconductor laser diode, the output power is 2mW and 4.5mW when the diode drive (injected) current is 50mA and 55mA, respectively. What is the threshold current (ith) of this laser diode? 4.arrow_forwardA thin-film polycrystalline solid has a preferential orientation with [001] perpendicular to its specimen surface. Which kind of [hkl] will exhibit the higher peak intensity and which kind of [hkl] will exhibit lower peak intensity than a standard spectrum of the same solid?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Modern PhysicsPhysicsISBN:9781111794378Author:Raymond A. Serway, Clement J. Moses, Curt A. MoyerPublisher:Cengage Learning
Modern Physics
Physics
ISBN:9781111794378
Author:Raymond A. Serway, Clement J. Moses, Curt A. Moyer
Publisher:Cengage Learning
Spectra Interference: Crash Course Physics #40; Author: CrashCourse;https://www.youtube.com/watch?v=-ob7foUzXaY;License: Standard YouTube License, CC-BY