(a)
Interpretation:
Based on the information given in the question statement, the three liquids, kerosene, linseed oil and water has to be listed in order of increasing density.
Concept Introduction:
Density:
The ratio of mass of a sample to its volume is said to be the density.
(b)
Interpretation:
If
Concept Introduction:
Refer to part (a).
(c)
Interpretation:
If
Concept Introduction:
Refer to part (a).
Trending nowThis is a popular solution!
Chapter 1 Solutions
Chemistry: The Molecular Science
- Methanol (CH3OH) is a liquid at room temperature with a density of 7.91 ×102 kg/m3.In a certain experiment, from the reaction of 2.91 mL of methanol with 2.88 g of oxygen, 2.27 gof carbon dioxide was obtained.(a) What type(s) of chemical reaction is (are) occurring in this experiment?(b) What equipment do you think was used to measure the volume of methanol in thisexperiment?(c) Calculate the percent yield of the carbon dioxide in this experimentarrow_forwardIf a solution is made by adding 8g of (NH4)2SO4 to a 100 ml volumteric flask and enough water is added to bring the total volume to 100ml, what would the density of the solution be? This is a straightforward question but I just wanted some clarification. When we bring the total volume to 100ml, does that mean we added 100ml of water? Will the mass of the water be 100 g regardless of the amount of solute added?arrow_forwardChemistry (b) A sampling plan is necessary to ensure that a laboratory sample is truly a representative of the entire population. (i) Describe the goals of the sampling plan. "It is possible to determine whether the population is homogeneous or heterogeneous if a single sample is collected and analyzed." Comment on this statement. (ii)arrow_forward
- Calculate the number of Kilograms of NaF per year of 100,000people if the daily consumption of water per person is 132.0 gallons (Sodium Fluoride is 45.0 percent Fluorine by mass. 1 gallon =3.79L, 1year+365 days,density of water+1.0g/larrow_forward1. (a) How many kilometers/min does a car go if it goes 52 miles/hour? (b) What number of inches is 0.09 miles? (c) What number of μm are in 1.116 cm?arrow_forwardUsing your knowledge of metric units, English units, and theinformation on the back inside cover, write down the conversionfactors needed to convert (a) μm to mm, (b) ms tons, (c) mi to km, (d) ft3 to L.arrow_forward
- High-density lipoprotein (HDL) cholesterol is the “good” cholesterol because adequate levels reduce the risk of heart disease and stroke. HDL levels between 40. and 59 mg/dL are typical for a healthy individual. What is this range of HDL cholesterol in units of mol/L?arrow_forward8. Carry out the following conversions: (a) 1.42 lightyears to miles (a light-year is an astronomical measure of distance—the distance traveled by light in a year, or 365 days; the speed of light is 3.00x108 m/s), (b) 32.4 yd to centimeters, (c) 3.0 3x1010 cm/s to ft/s. With solutionarrow_forwardA pediatrician writes a prescription for “diphenhydramine 7.5 mg PO Q 6 hours × 7 days” for a child who experienced an allergic reaction. If each teaspoon of the commercially available syrup contains 12.5 mg of diphenhydramine, what volume of syrup should be dispensed, in milliliters? Round UP to the nearest 5-mL increment.arrow_forward
- Calculate these masses.(a) What is the mass of 6.00 cm3 of mercury, density = 13.5939 g/cm3?(b) What is the mass of 25.0 mL octane, density = 0.702 g/cm3?arrow_forwardQUESTION 2 (a) 0.250 ug/um³ mg/mL (Show your calculations) What method did you use to perform the calculation? (b) 37 °C = K = oF (Show your calculations) (c) In an experiment, a student determined the mass of iron in an unknown biological sample. From the experiment, the student found 49.90 mg of iron. (i) What type of balance do you think the student used? (ii) In general, what are the two common methods of measuring mass in the laboratory? and (iii) If the % experimental error was 0.20%, What was the actual mass of the iron in the sample? (Assume that the actual mass was larger than the mass determined by the student). Show your calculations. (d) Consider a 15.0-g sample of a potassium salt. This compound is 32.86% by mass of potassium. Calculate the number of potassium ions present in this sample.arrow_forwardA student measures that the mass of a sugar solution is 5.70 g and the volume of the solution is 5.0 mL. (a) Calculate the density of the solution. (b) Calculate the concentration (mass/mass %) of the solutionarrow_forward
- Introductory Chemistry: An Active Learning Approa...ChemistryISBN:9781305079250Author:Mark S. Cracolice, Ed PetersPublisher:Cengage Learning