ει R1 a R1 w R2 R1 www R1 As shown in the figure, the resistances are R1 = 3.0 2 and R2 = 6.0 2, and the ideal batteries have emfs E₁ = 5.0 V, and E2 = E3 = 10.0 V. What is the size and direction of the current in battery 1 (ta positive current as that flowing through the battery from - to +)? Submit Answer Tries 0/10 What is the size and direction of the current in battery 2 (take positive current as that flowing through the battery from to +)? Submit Answer Tries 0/10 What is the size and direction of the current in battery 3 (take positive current as that flowing through the battery from - to +)? Submit Answer Tries 0/10 What is the potential difference Va - Vb? Submit Answer Tries 0/10

ει R1 a R1 w R2 R1 www R1 As shown in the figure, the resistances are R1 = 3.0 2 and R2 = 6.0 2, and the ideal batteries have emfs E₁ = 5.0 V, and E2 = E3 = 10.0 V. What is the size and direction of the current in battery 1 (ta positive current as that flowing through the battery from - to +)? Submit Answer Tries 0/10 What is the size and direction of the current in battery 2 (take positive current as that flowing through the battery from to +)? Submit Answer Tries 0/10 What is the size and direction of the current in battery 3 (take positive current as that flowing through the battery from - to +)? Submit Answer Tries 0/10 What is the potential difference Va - Vb? Submit Answer Tries 0/10

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 55P: A 20.00-V battery is used to supply current to a 10-k resistor. Assume the voltage drop across any...

See similar textbooks

Similar questions

An ECG monitor must have an KC time constant lessthan 1.00102s to be able to measure variations involtage oversmall time intervals, (a) If the resistance of the circuit (duemostly to that of the patient's chest) is 1.00kTwhat is the maximum capacitance of the circuit?(b) Would It be difficult in practice to limit the capacitance to less than the value found in (a)?
In the figure resistor 1 = 126 2, resistor 2 = 81 N, and the ideal batteries have emfs ɛ1 E2 = 5 volts, and ɛ3 = 7 volts. Find the current through resistor 1. = 29 volts, Round off answer up to 3 decimal places. Consider absolute value. Include the unit (A for ampere, V for volt and ohm for ohm). Rz RI ww
connected con sist of five resis tors 7.a A circit as below. Determine the effective Tesistance in the circuit. RI RS- R2 R+ Ginen R, = sor, Rz=25Jr, R3= 30r, R¢=60r, Rs= 70r iD Wlhat is Hhe current is Hhe circuit iç the potential the resistors is 24 V? CICcross What is the potential that ccin be tapped across Rs? b.A circuit consist sisc capacitors connicted as below, detemine the effective capacitalnce. (3 G= SmF, G= Smf, G= 6mF, C4 = 6mF, Gaigg fo Cs= 8mF, C6 = 8 mF. What is the energy stored in the capacitors in ;circuit if the potential across %3D the the capacitors is 24V? C- lwo charges +3C and t 5C are placed 20Cm from in Yacuum- Wlhat magnitude of force will. their Centres they ebcert on each other, If Hhe sccond charge hes its polacity changed to negative (-sc). Inlliat would be the nature of the force ? Will there be a change in magnitude ? LPermitivity of free space a 8.8sx 10 -12
In the following Figure, the current in resistance R, is i,= 14A and the resistances are R, =R, = R; = 20 ohm, R, = 1.6 ohm, R; = 80 ohm, and R, = 4.00 ohm. What is the emf of applied voltage of the ideal battery? R
QU5 a). A circuit consist of five resistors connected as below, determine the effective resistance in the circuit. R3 R5 R2 R4 Given that R1, R2,R3,R4 and R are given respectively as 500, 250, 300, 600 and 700Q, what is the current in the circuit if the potential across the resistors is 24 V?
3. In Fig. 3, the resistances are R1 = 20.0 W and R2 = 40.0 W, and the ideal batteries have emfs E3=E1 = 10.0 V and E2 = 20.0 V. What is the potential difference Va - Vb? (Fig.3) ) (Show step by step solution)
Using Kirchhoff's rules, find the following. (E, = 71.0 V, E2 = 62.0 V, and E, = 79.8 V.) 4.00 ka |E, |E. Ra R$ 3.00 kN 2.00 kN R (a) the current (in mA) in each resistor shown in the figure above IR2 mA mA (b) the potential difference between points c and f (Give the magnitude of your answer in volts and select the point of highest potential.) magnitude of potential difference point at higher potential --Select--- v (c) What If? If all of the resistors in the circuit were decreased in value by a factor of 1,000, would the current in each resistor simply increase by a factor of 1,000? Explain your answer.
In (Figure 1), the total resistance is 20.0 k2, and the battery's emf is 33.0 V. The time constant is measured to be 12.0 us Figure He Take Test: PHY1200-1... + R ww E S C: 1 of 1 https://www.prometric... Submit ▼ Part B ✓ Correct y pearson login - Yahoo... Previous Answers Calculate the time it takes for the voltage across the resistor to reach 16.0 V after the switch is closed. Express your answer to three significant figures and include the appropriate units. Provide Feedback μA 6 t= 7.968 10 S Xb b MacBook Air Submit Previous Answers Request Answer X.10" X Incorrect; Try Again; 3 attempts remaining X Pearson Course Home y cunyfirst login - Yaho. Review I Constants Copyright © 2022 Pearson Education Inc. All rights reserved. Terms of Use | Privacy Policy | Permissions Contact Us | Next >
Wire C and wire D are made from the same material of resistivity p- 2.0 x 10 am. The length and radius of wire Care Le 1.0m and re 2.00 mm, and those of wire D are Le- 0.50.m and ro-0.75 mm. The wires are joined as shown in the figure. What is the resistance R between points 1 and 2?
Ris the total resisteance of three resistors, connected in parallel, with resistances R1, R2, R3. then R1 R2 R3 If the resistances are measured in ohms as R1 = 45N, R2 = 40N, and R3 = 302, with a possible error of 0.4% in each case, estimate the maximum error in the calculated value of R. N. AR =
Ex. 68 : The length of potentiometer wire is 4 m and its resistance is 18 Q . A battery if e.m.f. 2 V and internal resistance 2 Nis connected across the wire. Calculate the potential gradient. If the balancing length for a cell of e.m.f. E1 200 cm, calculate E1
In the schematic below two batteries are in series and drive current through the circuit as shown. The first resistor has a voltage drop AV = 2.8 V, the middle resistor has a resistance of R = 154 Q, and the last resistor has a voltage drop AV2 = 1.6 V. Given these parameters, what is the magnitude of current flowing through the circuit in milli-amps (mA)? Giver your answer to 3 significant figures. %3D AV, 3.0 V 4.5 V ww