In the schematic below two batteries are in series and drive current through the circuit as shown. The first resistor has a voltage drop AV = 2.8 V, the middle resistor has a resistance of R = 154 Q, and the last resistor has a voltage drop AV2 = 1.6 V. Given these parameters, what is the magnitude of current flowing through the circuit in milli-amps (mA)? Giver your answer to 3 significant figures. %3D AV, 3.0 V 4.5 V ww

In the schematic below two batteries are in series and drive current through the circuit as shown. The first resistor has a voltage drop AV = 2.8 V, the middle resistor has a resistance of R = 154 Q, and the last resistor has a voltage drop AV2 = 1.6 V. Given these parameters, what is the magnitude of current flowing through the circuit in milli-amps (mA)? Giver your answer to 3 significant figures. %3D AV, 3.0 V 4.5 V ww

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

In the schematic below two batteries are in series and drive current through the circuit as shown. The first resistor has a voltage drop AV₁ = 1.2 V, the middle resistor has a resistance of R = 64, and the last resistor has a voltage drop AV₂ = 1 V. Given these parameters, what is the magnitude of current flowing through the circuit in milli-amps (mA)? Giver your answer to 3 significant figures. AV, ww 3.0 V 4.5 V ww ΔV, ww R
Consider the following circuit diagram. The potential difference across the battery is 40.0 volts, and it supplies a current of 5.00 amperes to the circuit. There is a current of of 2.70 amperes flowing through R1. Resistor R2 has a resistance of 5.50 ohms. What is the resistance of R3? Answer in ohms to two decimal places, but do not include units in your answer.
A set of current (I) and voltage (V) data is collected for a given circuit. The current is measured in mA and the voltage is measured in volts. If you plot a graph of I vs. V, what are the units on the slope? 1 kQ mV A mA V.s C V.s
In the last column in the data table, it says that it's about voltage(v) divided by current(A) is equal to ohms so V/A = ohms. So if it's V/A and if you divide them to get the slope it's (y2-y1)/(x2-x1) then shouldn't V be the y value and A be the x value? And can you also try to use a line of best bit instead of drawing the line through each dot?
mobile battery during a charge cycle are shown in 1.26 The voltage and current at the terminals of an auto- Fig. P1.26. a) Calculate the total charge transferred to the battery. b) Calculate the total energy transferred to the battery. Figure P1.26 v (V) bnohostib 24 Loiwollol sd lo 16 8- 8. 12 16 20 t (ks) i (A) maxi 24 16 8- the che 4 8. 12 16 20 t (ks)
When switch S in the figure is open, the voltmeter V of the battery reads 3.10 V. When the switch is closed, the voltmeter reading drops to 2.97 V , and the ammeter A reads 1.69 A . Assume that the two Part A meters are ideal, so they do not affect the circuit. (Figure 1) Find the emf E. Express your answer in volts to three significant digits. ? E = V Figure 1 of 1 Submit Request Answer V Part B Complete previous part(s) Part C Complete previous part(s) Provide Feedback A
The resistance R1 = 10 OHM and R2 = 25 OHM are one after another (in parallel) in a circuit. What is the total resistance of R1 and R2?
An electric device draws 6.10 AA at 240 VV. If the voltage drops by 25 %, what will be current, assuming nothing else changes? Express your answer to two significant figures and include the appropriate units. I final= If the resistance of the device were reduced by 25 %, what current would be drawn at 240 VV? Express your answer to two significant figures and include the appropriate units. I final=
What is the output voltage of a 3 V lithium cell in a digital wristwatch that draws 0.32 mA, if the cell's internal resistance is 1.8 Q? Hint: Draw a circuit diagram of the lithium battery in your notebook. Label all currents and voltages. Enter a value correct to 5 significant figures. V₂ = V
Two resistors are connected in parallel with an 96 volt battery. The resistors have values of R1 = 14 ohms and R2 = 96 ohms. What is the current in amperes for this circuit? Round your answer to two decimal places.
The resistance R1 = 10 OHM and R2 = 25 OHM are one after another (in seri) in a circuit. What is the total resistance of R1 and R2?
The combined electrical resistance R of two resistors R, and R. connected in parallel, is given by the equation below, where R, R₁, and are measured in ohms. R₁ and R, are increasing at rates of 0.5 and 2.0 ohms per second, respectively. 1 1 1 R₁+R₂ At what rate is R changing when R, 32 ohms and R₂ = 75 ohms? (Round your answer to three decimal places.) 0.573 xohm/sec Need Help? Read Watch It