Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)
5th Edition
ISBN: 9781305084766
Author: Saeed Moaveni
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Question
Chapter 9, Problem 38P
To determine
Find the mass flow rate of water leaving at pipe 3 and calculate the average velocity of the water leaving the tank.
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
This circular tank of water is being filled from a pipe as shown. The velocity of flow of water from the pipe is 10 ft/s. What will be the rate of rise of the water surface in the tank?
Situation 3: An 8-in-diameter horizontal pipe
is attached to a reservoir as shown in the
figure. If the total head loss between the
water surface in the reservoir and the water
jet at the end of the pipe is 6 feet, what
are the velocity and flow rate of the water
being discharged from the pipe?
Water
15 ft
Water jet
8-in diameter
Mi
T
Determine whether the flow is turbulent or laminar if a fluid flows at 0.001?^3/? through a 100mm diameter pipe.
Chapter 9 Solutions
Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)
Ch. 9.3 - Prob. 1BYGCh. 9.3 - Prob. 2BYGCh. 9.3 - Prob. 3BYGCh. 9.3 - Prob. BYGVCh. 9.6 - Prob. 1BYGCh. 9.6 - Prob. 2BYGCh. 9.6 - Prob. 3BYGCh. 9.6 - Prob. BYGVCh. 9 - Prob. 1PCh. 9 - Prob. 2P
Ch. 9 - Determine the specific gravity of the following...Ch. 9 - Prob. 4PCh. 9 - Prob. 5PCh. 9 - Prob. 9PCh. 9 - Prob. 10PCh. 9 - Prob. 12PCh. 9 - Prob. 13PCh. 9 - Prob. 14PCh. 9 - Prob. 17PCh. 9 - Prob. 19PCh. 9 - Prob. 22PCh. 9 - Prob. 24PCh. 9 - Prob. 25PCh. 9 - Prob. 26PCh. 9 - Prob. 27PCh. 9 - Prob. 28PCh. 9 - Prob. 29PCh. 9 - Prob. 30PCh. 9 - Prob. 31PCh. 9 - Prob. 32PCh. 9 - Prob. 33PCh. 9 - Prob. 34PCh. 9 - Prob. 35PCh. 9 - A plugged dishwasher sink with the dimensions of...Ch. 9 - Prob. 37PCh. 9 - Prob. 38PCh. 9 - Prob. 39PCh. 9 - Prob. 40PCh. 9 - Prob. 41PCh. 9 - Prob. 42PCh. 9 - Prob. 43PCh. 9 - Lake Mead, near the Hoover Dam, which is the...Ch. 9 - Prob. 45PCh. 9 - Prob. 46PCh. 9 - Prob. 47PCh. 9 - Prob. 48PCh. 9 - Prob. 49P
Knowledge Booster
Similar questions
- The flow rate of water through a 10-cm-diameter pipe is to be determined by measuring the water velocity at several locations along a cross section. For the set of measurements given in the table, determine the flow rate.arrow_forwardA trough is 12 feet long and 3 feet across the top (see figure). Its ends are isosceles triangles with altitudes of 3 feet. 2 ft3 min 12 ft→\ 3 ft 3 ft (a) If water is being pumped into the trough at 2 cubic feet per minute, how fast is the water level rising when h is 1.5 feet deep? ft/min (b) If the water is rising at a rate of 3/8 inch per minute when h = 2.5, determine the rate at which water is being pumped into the trough. ft3/minarrow_forwardQ- In a laboratory, a flow experiment is performed over a hydraulic structure. The measured values of discharge and velocity are 0.05 m3/s and 0.25 m/s, respectively. If the full-scale structure (30 times bigger) is subjected to a discharge of 270 m3/s, then the time scale (model to full scale (model to full scale) value (up to decimal places) isarrow_forward
- The tank shown in the accompanying figure is being filled by Pipes 1 and 2. If the water level is to remain constant, what is the mass-flow rate of water leaving the tank at Pipe 3? What is the average velocity of the water leaving the tank? Pipe 1: di =1 in. V = 2 ft/s Pipe 2: d = 1.75 in. V = 1.5 fUs Pipe 3: d3 = 1.5 in. V = ?arrow_forwardWater flows steadily through a pipe junction as shown in the diagram. The velocities provided are cross sectional averages and water is leaked through a hole in the junction at a rate of 0.1 m³/s. What is the average velocity through section 2? A₁ = 0,2m² V₁ = 5m/s 2 Ne leak Q = 0.1m³/s 3 V3 = 12 m/s A3 0.15m² Az = 0.2m²arrow_forwardAssuming the conduit in the figure is a 36” wrought iron pipe flowing full, and that the outlet is at point B, calculate the head loss in the flow by the time it reaches point Barrow_forward
- Problem :Water is discharge from a 50 mm diameter nozzle which is inclined at a 30 angle above the horizontal. If the jet strikes the ground at a horizontal distance of 3.6 m and a vertical distance of 0.6 m from the nozzle as shown in the figure, what is the rate of flow?arrow_forwardGiven a portion of a water supply pipe network system below. Determine the actual flow in each pipe and the respective head losses. Assume flow in pipes AB and DE in loop I and II respectively equal to 0.10 m3/s clockwise for the first trial. Use Darcy-Weisbach Formula with f = 0.02. Pipes Length (m) Diameter (cm) AB 500 20 BC 600 15 CD 500 20 DE 400 20 EA 700 25 AC 1000 15arrow_forward. A Pitot tube in the pipe in which air s flowing is connected to a manometer containingwater as shown in the figure. If the difference in water levels in the manometer is 87.5mm,what is the velocity of the flow in the pipe, assuming a tube coefficient, CP = 0.99?arrow_forward
- Example A trough of water is 8 meters long and its ends are in the shape of isosceles triangles whose width is 5 meters and height is 2 meters. If water is being pumped in at a constant rate of 6 m'/sec. At what rate is the height of the water changing when the water has a height of 120 cm? At what rate is the width of the water changing when the water has a height of 120 cm? 8arrow_forwardFluid mechanics- Bernoulli's Equation along a streamline: The flow-metering device shown consists of a stagnation probe at station 2 and a static pressure tap at station 1. The velocity at station 2 is twice that at station 1. Air with a density of 1.2kg/m3 flow through the duct. A water manometer is connected between the stagnation probe and the pressure tap, and a deflection of 10cm is measured. What is the velocity at station 2?arrow_forwardA rectangular tank is divided by a portion into two chambers, as shown in the figure. A 6-in diameter orifice, for which C is 0.65, is located near the bottom of the partition. At a certain time, the water level in the chamber A is 10 ft higher than the chamber B. Find the time it will take for the water surfaces in the two chambers to be at the same time.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Engineering Fundamentals: An Introduction to Engi...Civil EngineeringISBN:9781305084766Author:Saeed MoaveniPublisher:Cengage Learning
Engineering Fundamentals: An Introduction to Engi...
Civil Engineering
ISBN:9781305084766
Author:Saeed Moaveni
Publisher:Cengage Learning