College Physics
1st Edition
ISBN: 9781938168000
Author: Paul Peter Urone, Roger Hinrichs
Publisher: OpenStax College
expand_more
expand_more
format_list_bulleted
Concept explainers
Textbook Question
Chapter 9, Problem 23PE
What force does the nail puller in Exercise 9.19 exert on the supporting surface? The nail puller has a mass of 2.10 kg.
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
A 55kg person rests on two crutches. They are in equilibrium. 25% of their weight is supported by the ground. Each crutch is at an angle of 105 degrees. Calculate the magnitude of the force each crutch exerts on the person.
Suppose the weight of the drawbridge in the figure is supported entirely by its hinges and the opposite shore, so that its cables are slack. The mass of the bridge is 2500 kg.
What percent of the weight is supported by the opposite shore if the point of support is at the very end of the drawbridge?
What is the magnitude, in newtons, of the force the hinges exert on the bridge under these circumstances?
A 15.7 m long board is supported from beneath at two locations. One is at the far left end of the board. The other is 1.2 m from the right end of the board. The board has a mass of 39.7 kg. What is the normal force (in newtons) applied by the right support?
Chapter 9 Solutions
College Physics
Ch. 9 - What can you say about the velocity of a moving...Ch. 9 - Under what conditions can a rotating body be in...Ch. 9 - What three factors affect the torque created by a...Ch. 9 - A wrecking ball is being used to knock down a...Ch. 9 - Mechanics put a length of Pipe over the handle of...Ch. 9 - A round pencil lying on its side as in Figure 9.13...Ch. 9 - Explain the need for tall towers on a suspension...Ch. 9 - When visiting some countries, you may see a person...Ch. 9 - Scissors are like a double-lever "Stem, Which of...Ch. 9 - Suppose you pull a nail at a constant rate using a...
Ch. 9 - Why are the forces exerted on the outside world by...Ch. 9 - Explain why the forces in our joints are several...Ch. 9 - Why are the forces exerted on the outside world by...Ch. 9 - Explain why the forces in our joints are several...Ch. 9 - Certain of dinosaurs were bipedal (walked on two...Ch. 9 - Swimmers and athletes during competition need to...Ch. 9 - If the maximum force the biceps muscle can exert...Ch. 9 - Suppose the biceps muscle was attached through...Ch. 9 - Explain one of the reasons why pregnant women...Ch. 9 - (a) When opening a door, you push on it...Ch. 9 - When tightening a bolt, you push perpendicularly...Ch. 9 - Two children push on opposite sides of a door...Ch. 9 - Use the second condition for equilibrium (net =0 )...Ch. 9 - Repeat the seesaw problem in Example 9.1 with the...Ch. 9 - Suppose a horse leans against a wall as in Figure...Ch. 9 - Two children of mass 20.0 kg and 30.0 kg sit...Ch. 9 - (a) Calculate the magnitude and direction of the...Ch. 9 - A person carries a plank of wood 2.00 m long with...Ch. 9 - A 17.0-m-high and 11.0-m-long wall under...Ch. 9 - (a) What force must be exerted by the wind to...Ch. 9 - Suppose the weight of the drawbridge in Figure...Ch. 9 - Suppose a 900-kg car is on the bridge in Figure...Ch. 9 - A sandwich board advertising sign is constructed...Ch. 9 - (a) What minimum coefficient of friction is needed...Ch. 9 - A gymnast is attempting to perform splits. From...Ch. 9 - To get up on the roof, a person (mass 70.0 kg)...Ch. 9 - In Figure 9.21, the cg of the pole held by the...Ch. 9 - What is the mechanical advantage of a nail puller...Ch. 9 - Suppose you needed to raise a 250-kg mower a...Ch. 9 - a) What is the mechanical advantage of a...Ch. 9 - A typical car has an axle with 1.10 cm radius...Ch. 9 - What force does the nail puller in Exercise 9.19...Ch. 9 - If you used an ideal pulley of the type shown in...Ch. 9 - Repeat Exercise 9.24 for the pulley shown in...Ch. 9 - Verity that the force in the elbow joint in...Ch. 9 - Two muscles in the back of the leg pull on the...Ch. 9 - The upper leg muscle (quadriceps) exerts a force...Ch. 9 - A device for exercising the upper leg muscle is...Ch. 9 - A person working at a drafting board may hold her...Ch. 9 - We analyzed the biceps muscle example with the...Ch. 9 - Even when the head is held erect, as in Figure...Ch. 9 - A 75-kg man stands on his toes by exerting an...Ch. 9 - A father lifts his child as shown in Figure 9.43....Ch. 9 - Unlike most of the other muscles in our bodies,...Ch. 9 - Integrated Concepts Suppose we replace the 4.0-kg...Ch. 9 - (a) What force should the woman in Figure 9.45...Ch. 9 - You have just planted a sturdy 2-m-tall palm tree...Ch. 9 - Unreasonable Results Suppose two children are...Ch. 9 - Construct Your Own Problem Consider a method for...
Additional Science Textbook Solutions
Find more solutions based on key concepts
Q8.1 In splitting logs with a hammer and wedge, is a heavy hammer more effective than a lighter hammer? Why?
University Physics with Modern Physics (14th Edition)
The proton is a composite particle composed of three quarks, all of which are either up quarks (u; charge +23e)...
Essential University Physics: Volume 2 (3rd Edition)
68. The horizontal pipe shown in Figure 13.45 has a cross-sectional area of 40.0 cm2 at the wider portions and ...
College Physics (10th Edition)
What differences between gliders M and N could account for their differences in behavior during the collisions?
Tutorials in Introductory Physics
40.(II) If 21.0 V is applied across the whole network of Fig. 19-63, calculate (a) the voltage across each capa...
Physics: Principles with Applications
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- A 20.0-kg horizontal plank 4.00 in long rests on two supports, one at the left end and a second 1.00 m from the right end. What is the magnitude of the force exerted on the plank by the support near the right end? (a) 32.0 N (b) 45.2 N (c) 112 N (d) 131 N (e) 98.2 Narrow_forwardA homeowner is trying to move a stubborn rock from his yard. By using a a metal rod as a lever arm and a fulcrum (or pivot point) the homeowner will have a better chance of moving the rock. The homeowner places the fulcrum a distance ?=0.288 mfrom the rock, which has a mass of 465 kg, and fits one end of the rod under the rock's center of weight. If the homeowner can apply a maximum force of 671 N at the other end of the rod, what is the minimum total length ? of the rod required to move the rock? Assume that the rod is massless and nearly horizontal so that the weight of the rock and homeowner's force are both essentially vertical. The acceleration due to gravity is ?=9.81 m/s2.arrow_forwardThere are four forces acting on a pole, A = 10i N, B = 20j N, C = -30j N, D = -40i N. What should be the magnitude of force E that must be exerted on the pole to maintain static equilibrium?arrow_forward
- A new art exhibit featuring mobile works is going up in the Holland, MI, area. One piece is shown in the figure. The 140-N uniform beam is pinned to the ground by a pivot. The beam is supported by a cable (attached to the center of the beam) to allow for each of the shoes to hang freely. Each individual shoe has a weight of 9.5-N. 1.If one shoe is attached two-fifths of the way up the beam and another shoe is attached and three-fifths of the way up the beam, with θc = 19.5° and θb = 33.5° as shown in the figure, what is the tension in the cable, in newtons?arrow_forwardA window washer is standing on a scaffold supported by avertical rope at each end. The scaffold weighs 200 N and is3.00 m long. What is the tension in each rope when the 700-Nworker stands 1.00 m from one end?arrow_forwardA 6.0 m plank with a mass of 50 kg is supported on both ends. An 80 kg worker stands on the plank 1.5 m away from the left end. What weight must each end of the plank support? Separate your answers by a comma (i.e. 340 N, 567 N - the first answer for the left end, the second answer for the right end). Express your answer as a whole number (no decimal). Add the appropriate units.arrow_forward
- A uniform, 8.0-m, 1500-kg beam is hinged to a wall and supported by a thin cable attached 2.0 m from the free end of the beam. The beam is supported at an angle of 30° above the horizontal. (a) find the tension in the cable and (b) how hard does the beam push inward on the wall?arrow_forwardA lightweight diving board is supported by two pillars. One is at the end of the board and the other is 1.05 m away. A 75-kg person is standing on the board at such a location that the pillar at the end (pillar #1) of the board exerts a 860-N force downward. Determine the following. (a) distance the person is standing from the end pillar (pillar #1)______ m(b) magnitude of the upward force exerted by the second pillar (pillar #2)______ Narrow_forwardA window washer is standing on a scaffold supported by a vertical rope at each end. The scaffold weighs 300 N and is 4.50 m long. What is the tension in each rope when the 600-N worker stands 1.30 m from one end? Make use of the situations in this scenario and tell us a story of your own that involves a similar type of static equilibrium. You may use approximate values to solve the problem that you come up with.arrow_forward
- A lightweight diving board is supported by two pillars. One is at the end of the board and the other is 3.55 m away. A 75-kg person is standing on the board at such a location that the pillar at the end (pillar #1) of the board exerts a 770-N force downward. Determine the following. a)distance the person is standing from the end pillar (pillar #1) b)arrow_forwardA window washer is standing on a scaffold supported by a vertical rope at each end. The scaffold weighs 300 N and is 4.50 m long. What is the tension in each rope when the 600-N worker stands 1.30 m from one end? Make use of the situations in this scenario and tell us a story of your own that involves a similar type of static equilibrium. You may use approximate values to solve your own problem.arrow_forwardA person places his hand palm downward on a scale and pushes down on the scale until it reads 96.0 N. The triceps muscle is responsible for this arm extension force. Find the force exerted by the triceps muscle. The bottom of the triceps muscle is 2.50 cm to the left of the elbow joint, and the palm is pushing at approximately 29.0 cm to the right of the elbow joint. P 96.0 N 2.50 cm and Q = 29.0 cm. where P =arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Physics for Scientists and Engineers, Technology ...PhysicsISBN:9781305116399Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningCollege PhysicsPhysicsISBN:9781305952300Author:Raymond A. Serway, Chris VuillePublisher:Cengage Learning
Physics for Scientists and Engineers, Technology ...
Physics
ISBN:9781305116399
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
College Physics
Physics
ISBN:9781305952300
Author:Raymond A. Serway, Chris Vuille
Publisher:Cengage Learning
What is Torque? | Physics | Extraclass.com; Author: Extraclass Official;https://www.youtube.com/watch?v=zXxrAJld9mo;License: Standard YouTube License, CC-BY