Concept explainers
(a) Assume that the maxima are halfway between the minima of a single-slit diffraction pattern. The use the diameter and circumference of the phasor diagram, as described in Intensity in Single-Slit Diffraction, to determine the intensities of the third and fourth maxima in terms of the intensity of the central maximum. (b) Do the same calculation, using Equation 4.4.
Want to see the full answer?
Check out a sample textbook solutionChapter 4 Solutions
University Physics Volume 3
Additional Science Textbook Solutions
College Physics
Tutorials in Introductory Physics
University Physics Volume 1
Physics: Principles with Applications
University Physics with Modern Physics (14th Edition)
College Physics: A Strategic Approach (4th Edition)
- The structure of the NaCl crystal forms reflecting planes 0.541 nm apart. What is the smallest angle, measured from these planes, at which X-ray diffraction can be observed, if X-rays of wavelength 0.085 nm are used?arrow_forwardWhat are the angular positions of the first and second minima in a diffraction pattern produced by a slit of width 0.20 mm that is illuminated by 400 nm light? What is the angular width of the central peak?arrow_forwardUsing the result of the problem two problems prior, find the wavelength of light that produces fringes 7.50 mm apart on a screen 2.00 m from double slits separated by 0.120 mm.arrow_forward
- How far would you place a screen from the slit of the previous problem so that the second minimum is a distance of 2.5 mm from the center of the diffraction pattern?arrow_forwardFor 600-nm wavelength light and a slit separation of 0.12 mm, what are the angular positions of the first and third maxima in the double slit interference pattern?arrow_forwardOn a certain crystal, a first-order X-ray diffraction maximum is observed at an angle of 27.1° relative to its surface, using an X-ray source of unknown wavelength. Additionally, when illuminated with a different, this time of known wavelength 0.137 nm, a second-order maximum is detected at 37.3°. Determine (a) the spacing between the reflecting planes, and (b) the unknown wavelength.arrow_forward
- Two slits of width 2 m, each in an opaque material, are separated by a center-to-center distance of 6 m. A monochromatic light of wavelength 450 nm is incident on the double-slit. One finds a combined interference and diffraction pattern on the screen. (a) How many peaks of the interference will be observed in the central maximum of the diffraction pattern? (b) How many peaks of the interference will be observed if the slit width is doubled while keeping the distance between the slits same? (c) How many peaks of interference will be observed if the slits are separated by twice the distance, that is, 12 m, while keeping the widths of the slits same? (d) What will happen in (a) if instead of 450-nm light another light of wavelength 680 nm is used? (e) What is the value of the ratio of the intensity of the central peak to the intensity of the next bright peak in (a)? (f) Does this ratio depend on the wavelength of the light? (g) Does this ratio depend on the width or separation of the slits?arrow_forwardChapter 36, Problem 017 (a) Find the equation of a at which intensity extrema for single-slit diffraction occur (Im - is maximum). What are the (b) smallest a and (c) associated m, the (d) second smallest a and (e) associated m, and the (f) third smallest a and (g) associated m? (Note: To find values of a satisfying this conditiion, plot the curve y = tan a and the straight line y = a and then find their intersections, or use a calculator to find an appropriate value of a by trial and error. Next, from a = (m+1/2)x, determine the values of m associated with the maxima in the single-slit pattern. These m values are not integers because secondary maxima do not lle exactly halfway between minima.) (a) = 0 2 Edit •1 (b) a = Number Units 2 Units (c) m = Number *3 Units (d) a = Number *4 Units (e) m = Number Units (f) a = Number Units (g) m = Numberarrow_forwardRecall from class that the resolution is limited due to the nature of light. More specifically, since light diffracts as it goes through a small opening, it becomes difficult to differentiate two light sources when the diffraction central peak from one source overlaps with the first minimum of the second source, as shown in the figure below. (a) The pupil of the human eye has an aperture of around 5mm, and visible light has wavelengths peaked around 500nm. Estimate the angular resolution of the human eye (that is, the smallest angle for which you could distinguish that light was coming from two different directions). (b) Suppose two point sources of light were separated by a distance x, and you are standing one meter away from them. Estimate the smallest distance x for which you could tell that there were two point sources (rather than just one).arrow_forward
- The analysis of any two-point source interference pattern and a successful determination of wavelength demands an ability to sort through the measured information and equating the values with the symbols in Young's equation. Apply your understanding by interpreting the following statements and identifying the values of y, d, m and L. Finally, perform some conversions of the given information such that all information share the same unit. Consecutive bright bands on an interference pattern are 3.5 cm apart when the slide containing the slits is 10.0 m from the screen. The slit separation distance is 0.050 mm. y= ________ d=________ m=_______ L=________arrow_forwardConsider the interference pattern produced by two parallel slits of width a and separation d, in which d = 3a. The slits are illuminated by normally incident light of wavelength λ. (a) First we ignore diffraction effects due to the slit width. At what angles θ from the central maximum will the next four maxima in the two-slit interference pattern occur? Your answer will be in terms of d and λ. (b) Now we include the effects of diffraction. If the intensity at θ = 0° is I0, what is the intensity at each of the angles in part (a)? (c) Which double-slit interference maxima are missing in the pattern?arrow_forwardIn an interference experiment using a monochromatic source emitting light of wavelength å, the fringes are produced by two long, narrow slits separated by a distance d. The fringes are formed on a screen which is situated at a distance D >> d. Write down an expression for the fringe width w. Please use Il * II for products (e.g. B*A), "/" for ratios (e.g. B/A) and the usual "+" and "-" signs as appropriate. Use "lambda" (without the quotes) for å in the equation box. For example, use d*lambda for d2. Please use the "Display response" button to check you entered the answer you expect.arrow_forward
- University Physics Volume 3PhysicsISBN:9781938168185Author:William Moebs, Jeff SannyPublisher:OpenStaxPhysics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningGlencoe Physics: Principles and Problems, Student...PhysicsISBN:9780078807213Author:Paul W. ZitzewitzPublisher:Glencoe/McGraw-Hill
- Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning