(a)
Interpretation:
For the given set of samples of matter it should be determined that whether they constitute a gas or not with reasons.
Concept introduction:
Ideal gas Equation:
Any gas can be described by using four terms namely pressure, volume, temperature and the amount of gas. Thus combining three laws namely Boyle’s, Charles’s Law and Avogadro’s Hypothesis the following equation could be obtained. It is referred as ideal gas equation.
Under some conditions gases don not behave like ideal gas that is they deviate from their ideal gas properties. At lower temperature and at high pressures the gas tends to deviate and behave like real gases.
Boyle’s Law:
At given constant temperature conditions the mass of given ideal gas in inversely proportional to its volume.
Charles’s Law:
At given constant pressure conditions the volume of ideal gas is directly proportional to the absolute temperature.
Avogadro’s Hypothesis:
Two equal volumes of gases with same temperature and pressure conditions tend to have same number of molecules with it.
Molar mass: The molar mass of a substance is determined by dividing the given mass of substance by the amount of the substance.
Partial pressure: The partial pressure for any gas can be obtained by multiplication of total pressure of the gas with the mole fraction of the gas present in that total mixture.
Mole fraction: It defines the amount of particular species present in the mixture. It is obtained by dividing the mole of gas by the total mole of gas present in the mixture.
(b)
Interpretation:
For the given set of samples of matter it should be determined that whether they constitute a gas or not with reasons.
Concept introduction:
Ideal gas Equation:
Any gas can be described by using four terms namely pressure, volume, temperature and the amount of gas. Thus combining three laws namely Boyle’s, Charles’s Law and Avogadro’s Hypothesis the following equation could be obtained. It is referred as ideal gas equation.
Under some conditions gases don not behave like ideal gas that is they deviate from their ideal gas properties. At lower temperature and at high pressures the gas tends to deviate and behave like real gases.
Boyle’s Law:
At given constant temperature conditions the mass of given ideal gas in inversely proportional to its volume.
Charles’s Law:
At given constant pressure conditions the volume of ideal gas is directly proportional to the absolute temperature.
Avogadro’s Hypothesis:
Two equal volumes of gases with same temperature and pressure conditions tend to have same number of molecules with it.
Molar mass: The molar mass of a substance is determined by dividing the given mass of substance by the amount of the substance.
Partial pressure: The partial pressure for any gas can be obtained by multiplication of total pressure of the gas with the mole fraction of the gas present in that total mixture.
Mole fraction: It defines the amount of particular species present in the mixture. It is obtained by dividing the mole of gas by the total mole of gas present in the mixture.
(c)
Interpretation:
For the given set of samples of matter it should be determined that whether they constitute a gas or not with reasons.
Concept introduction:
Ideal gas Equation:
Any gas can be described by using four terms namely pressure, volume, temperature and the amount of gas. Thus combining three laws namely Boyle’s, Charles’s Law and Avogadro’s Hypothesis the following equation could be obtained. It is referred as ideal gas equation.
Under some conditions gases don not behave like ideal gas that is they deviate from their ideal gas properties. At lower temperature and at high pressures the gas tends to deviate and behave like real gases.
Boyle’s Law:
At given constant temperature conditions the mass of given ideal gas in inversely proportional to its volume.
Charles’s Law:
At given constant pressure conditions the volume of ideal gas is directly proportional to the absolute temperature.
Avogadro’s Hypothesis:
Two equal volumes of gases with same temperature and pressure conditions tend to have same number of molecules with it.
Molar mass: The molar mass of a substance is determined by dividing the given mass of substance by the amount of the substance.
Partial pressure: The partial pressure for any gas can be obtained by multiplication of total pressure of the gas with the mole fraction of the gas present in that total mixture.
Mole fraction: It defines the amount of particular species present in the mixture. It is obtained by dividing the mole of gas by the total mole of gas present in the mixture.
(d)
Interpretation:
For the given set of samples of matter it should be determined that whether they constitute a gas or not with reasons.
Concept introduction:
Ideal gas Equation:
Any gas can be described by using four terms namely pressure, volume, temperature and the amount of gas. Thus combining three laws namely Boyle’s, Charles’s Law and Avogadro’s Hypothesis the following equation could be obtained. It is referred as ideal gas equation.
Under some conditions gases don not behave like ideal gas that is they deviate from their ideal gas properties. At lower temperature and at high pressures the gas tends to deviate and behave like real gases.
Boyle’s Law:
At given constant temperature conditions the mass of given ideal gas in inversely proportional to its volume.
Charles’s Law:
At given constant pressure conditions the volume of ideal gas is directly proportional to the absolute temperature.
Avogadro’s Hypothesis:
Two equal volumes of gases with same temperature and pressure conditions tend to have same number of molecules with it.
Molar mass: The molar mass of a substance is determined by dividing the given mass of substance by the amount of the substance.
Partial pressure: The partial pressure for any gas can be obtained by multiplication of total pressure of the gas with the mole fraction of the gas present in that total mixture.
Mole fraction: It defines the amount of particular species present in the mixture. It is obtained by dividing the mole of gas by the total mole of gas present in the mixture.
Want to see the full answer?
Check out a sample textbook solutionChapter 10 Solutions
Chemistry & Chemical Reactivity
- Zn reacts with hydrochloric acid to give zinc chloride and hydrogen gas. A sample of 5 g of a Zn mineral requires 10 mL of commercial HCl of 37% purity, by weight and density 1.19 g/mL, to react completely. Find: a) The mass of zinc contained in the sample. b) The purity of the zinc mineral. c) The pressure exerted by the hydrogen gas collected in a 2 L container and at a temperature of 20ºC.please use conversion factors and mark the solutionsarrow_forwardA cylinder with a movable piston contains 2.00 gg of helium, HeHe, at room temperature. More helium was added to the cylinder and the volume was adjusted so that the gas pressure remained the same. How many grams of helium were added to the cylinder if the volume was changed from 2.00 LL to 3.50 LL ? (The temperature was held constant.) Express your answer with the appropriate units.arrow_forwardWhat volume of hydrogen sulfide is required to produce 162 liters of sulfur dioxide according to the following reaction? (All gases are at the same temperature and pressure.) hydrogen sulfide (g) + oxygen(g) → water (1) + sulfur dioxide (g) Volume= Larrow_forward
- P1A.10 Ozone is a trace atmospheric gas which plays an important role in screening the Earth from harmful ultraviolet radiation, and the abundance of ozone is commonly reported in Dobson units. Imagine a column passing up through the atmosphere. The total amount of O3 in the column divided by its cross-sectional area is reported in Dobson units with 1 Du =0.4462 mmol m−2. What amount of O3 (in moles) is found in a column of atmosphere with a cross-sectional area of 1.00 dm2 if the abundance is 250 Dobson units (a typical midlatitude value)? In the seasonal Antarctic ozone hole, the column abundance drops below 100 Dobson units; how many moles of O3 are found in such a column of air above a 1.00 dm2 area? Most atmospheric ozone is found between 10 and 50 km above the surface of the Earth. If that ozone is spread uniformly through this portion of the atmosphere, what is the average molar concentration corresponding to (a) 250 Dobson units, (b) 100 Dobson units?arrow_forwardA cylinder with a movable piston contains 2.00 gg of helium, HeHe, at room temperature. More helium was added to the cylinder and the volume was adjusted so that the gas pressure remained the same. How many grams of helium were added to the cylinder if the volume was changed from 2.00 LL to 2.90 LL ? (The temperature was held constant.) Express your answer with the appropriate units. THE ANSWER IS NOT 0.725 MOLESarrow_forwardItem 4 4 of 16 I Review I Constants I Periodic Table Gases are different from solids and liquids. In a sample of gas, the molecules are far apart. The gas molecules also move around and collide with each other as well as with the walls of the container. These collisions generate pressure. The pressure of a gas can be measured in different units. One convenient unit of measure is called the atmosphere (atm) because it is based on atmospheric pressure. At sea level, the average pressure is 1 atm. As you get higher in altitude, the pressure steadily drops until you leave the atmosphere, where the pressure is very close to 0 atm. Part C The table below shows the different commonly used units of measuring gas pressure. Use this table in the pressure unit conversions. High-pressure liquid chromatography (HPLC) is a method used in chemistry and biochemistry to purify chemical substances. The pressures used in this procedure range from around 500 kilopascals (500,000 Pa) to about 60,000 kPa…arrow_forward
- 5. An experiment is performed to measure the mass percent of CaCO3(s) in eggshells. Five different samples of CaCO3(s) of known mass react with an excess of 2.0M HCl(aq) in identical sealed, rigid reaction vessels. The pressure of the gas produced is measured with a pressure gauge attached to the reaction vessel. Since the reaction is exothermic, the reaction system is cooled to its original temperature before Cooling the HCl(aq) to a lower temperature than it was in the original experiment the pressure is recorded. The experimental data are used to create the calibration line below. Using eggshells that are more finely powdered than those used in the original experiment 0.10- 0.09 0.08- Using 2.0M CH3COOH(aq) instead of 2.0M HCl(aq) 0.07 * 0.06- Reducing the volume of the reaction vessel 0.05 0.04 CLEAR ALL 0.03- 0.02- 0.05 0.10 0.15 0.20 Mass of CaCO3(s) (grams) The experiment is repeated with an eggshell sample, and the experimental data are recorded in the table below. Mass of…arrow_forwardThe physical fitness of athletes is measured by “VO2 max,”which is the maximum volume of oxygen consumed by anindividual during incremental exercise (for example, on atreadmill). An average male has a VO2 max of 45 mL O2>kgbody mass/min, but a world-class male athlete can have a VO2max reading of 88.0 mL O2>kg body mass/min. (a) Calculatethe volume of oxygen, in mL, consumed in 1 hr by an averageman who weighs 185 lbs and has a VO2 max reading of 47.5mL O2>kg body mass/min. (b) If this man lost 20 lb, exercised,and increased his VO2 max to 65.0 mL O2>kg body mass/min,how many mL of oxygen would he consume in 1 hr?arrow_forwardQ1.A glass vessel was filled with an unknown quantity of nitrogen gas and the pressure at 28°C was 4.2 x 10⁴Pa. Oxygen gas was introduced at the same temperature until the pressure was to 1.013 ×10⁵Pa. (I) calculate the partial pressures of nitrogen gas and oxygen gas (II) calculate the mass ratio of the two gases. ( N=14, O=16) Q2. When temperature is increased by 10K, what happens to the rate of reaction? Why is it so?arrow_forward
- Solid ammonium chloride, NH,Cl, is formed by the reaction of gaseous ammonia, NH,, and hydrogen chloride, HCI. NH; (g)+HCl(g) NH, CI(s) A 6.75 g sample of NH, gas and a 6.75 g sample of HCl gas are mixed in a 1.50 L flask at 25 °C. Identify the limiting reagent. NH,C1 HCl NH, How many grams of NH, Cl will be formed by this reaction? mass: What is the pressure in atmospheres of the gas remaining in the flask? Ignore the volume of solid NH,Cl produced by the reaction. P = atmarrow_forwardUsing stoichiometry, you calculate that you will create 0.43 moles of carbon dioxide when you react baking soda with vinegar to fill up a balloon. After doing the experiment you calculate the volume of the balloon by using water displacement to be 16 cups. If the temperature in the room is 25 °C and the pressure is 1 atm, what is the percent error between the volume the balloon should be and the volume it reached. 1 cup = 236.6 ml.arrow_forward5. (optional) Blue turquoise is an example of a hydrate mineral containing copper; the chemical formula is CuAl6(PO4)4(OH)8•4H2Ó. What is the percent water in this semiprecious stone?arrow_forward
- Chemistry for Engineering StudentsChemistryISBN:9781337398909Author:Lawrence S. Brown, Tom HolmePublisher:Cengage LearningIntroductory Chemistry: A FoundationChemistryISBN:9781337399425Author:Steven S. Zumdahl, Donald J. DeCostePublisher:Cengage Learning