Fundamentals of Applied Electromagnetics (7th Edition)
7th Edition
ISBN: 9780133356816
Author: Fawwaz T. Ulaby, Umberto Ravaioli
Publisher: PEARSON
expand_more
expand_more
format_list_bulleted
Videos
Textbook Question
Chapter 1, Problem 10P
An oscillator that generates a sinusoidal wave on a string completes 20 vibrations in 50 s. The wave peak is observed to travel a distance of 2.8 m along the string in 5 s. What is the wavelength?
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
The main purpose of an oscilloscope is to graph an electrical signal as it varies over time. Most scopes
produce a two-dimensional graph with time on the x-axis and voltage on the y-axis. The voltage waveform
on the screen looks as shown in the figure below. Here, the vertical resolution of the oscilloscope is set
up to be 2 mV/division and the horizontal resolution is 2 ms/division.
Time
1. Determine the peak-to-peak amplitude of the wave.
Voltage
A double beam oscilloscope displays 2 sine waveforms A and B. The time/cm switch is on 150µs/cm and the volt/cm switch on 5 V/cm. The width of each complete cycle is 8 cm for both the waveforms. The height of waveforms A and B are 5 cm and 4 cm respectively. Determine their a) frequency, b) phase difference, and c) peak and d) r.m.s value of voltages. The difference between the two waveforms is 0.7 cm.
A double beam oscilloscope displays 2 square waveform G and H. The time/cm switch is on
2ms/cm and the volt/cm switch on 4 V/cm. The width of each complete cycle is 6.8 cm for both
the waveform. The Peak to Peak height of waveform G and H are 4.8 cm and 5.3 cm
respectively. The difference between the two waveforms is 0.5. Determine
a) frequency;
b) phase difference,
C) RMS value of G waveform
d) peak value of H waveform
a) frequency
b) phase difference
C) RMS value of G waveform
d)peak value of H waveform
(8)
Chapter 1 Solutions
Fundamentals of Applied Electromagnetics (7th Edition)
Ch. 1.3 - Prob. 1CQCh. 1.3 - What is Coulombs law? State its properties.Ch. 1.3 - What are the two important properties of electric...Ch. 1.3 - What do the electrical permittivity and magnetic...Ch. 1.3 - What are the three branches and associated...Ch. 1.4 - How can you tell if a wave is traveling in the...Ch. 1.4 - Prob. 7CQCh. 1.4 - Why does a negative value of 0 signify a phase...Ch. 1.4 - Consider the red wave shown in Fig. E1.1. What is...Ch. 1.4 - The wave shown in red in Fig. E1.2 is given by...
Ch. 1.4 - The electric field of a traveling electromagnetic...Ch. 1.4 - Prob. 4ECh. 1.4 - The red wave shown in Fig. E1.5 is given by...Ch. 1.4 - An electromagnetic wave is propagating in the z...Ch. 1.5 - What are the three fundamental properties of EM...Ch. 1.5 - What is the range of frequencies covered by the...Ch. 1.5 - Prob. 11CQCh. 1.6 - Express the following complex functions in polar...Ch. 1.6 - Show that 2j=(1+j). (See EM.)Ch. 1.7 - Prob. 12CQCh. 1.7 - How is the phasor technique used when the forcing...Ch. 1.7 - A series RL circuit is connected to a voltage...Ch. 1.7 - A phasor voltage is given by V=j5V. Find (t).Ch. 1 - A 2 kHz sound wave traveling in the x direction in...Ch. 1 - For the pressure wave described in Example 1-1,...Ch. 1 - A harmonic wave traveling along a string is...Ch. 1 - A wave traveling along a string is given by...Ch. 1 - Two waves, y1(t) and y2(t), have identical...Ch. 1 - The height of an ocean wave is described by the...Ch. 1 - A wave traveling along a string in the +x...Ch. 1 - Two waves on a string are given by the following...Ch. 1 - Give expressions for y(x, t) for a sinusoidal wave...Ch. 1 - An oscillator that generates a sinusoidal wave on...Ch. 1 - Prob. 11PCh. 1 - Given two waves characterized by...Ch. 1 - The voltage of an electromagnetic wave traveling...Ch. 1 - A certain electromagnetic wave traveling in...Ch. 1 - Prob. 15PCh. 1 - Prob. 16PCh. 1 - Complex numbers z1 and z2 are given z1=3j2z2=4+j3...Ch. 1 - Complex numbers z1 and z2 are given by...Ch. 1 - If z=2+j4, determine the following quantities in...Ch. 1 - Find complex numbers t=z1+z2 and s=z1z2, both in...Ch. 1 - Complex numbers z1 and z2 are given by...Ch. 1 - If z=3j5, find the value of ln(z).Ch. 1 - If z = 3 j4. find the value of ez.Ch. 1 - Prob. 24PCh. 1 - A voltage source given by s(t)=25cos(2103t30)(V)...Ch. 1 - Find the phasors of the following time functions:...Ch. 1 - Find the instantaneous time sinusoidal functions...Ch. 1 - A series RLC circuit is connected to a generator...Ch. 1 - The voltage source of the circuit shown in Fig....
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.Similar questions
- Good day! please help me determine the conduction angle here in my waveform. Please teach me also how you determine it and if you have easy techniques in determining it. Thank you!arrow_forwardThe peak to peak distance of a sinusoidal waveform displayed on a C.R.O. screen is 9 cm and the 'volts/cm' switch is on 45 V/cm. The peak voltage is given by 405.00 V 202.50 V 5.00 V O 286.33 Varrow_forwardA stringed instrument generates a complex waveform with the following components: 250 Hz with an amplitude of 5 Pa 500 Hz with an amplitude of 3 Pa What is the fundamental frequency? What other harmonic is represented? What equation would represent this complex waveform? Calculate the amplitude values every 45° (0°, 45°, 90°, etc.). Plot the resulting points on a graph of degrees vs. pressure, and connect them to see the shape of the complex waveform.arrow_forward
- Show the Analog Waveform Signal of the problem below. Please include the formula you will be using to get the waveform, also include what application you will be using to get the waveform. If you will use sine or cosine, please include the whole formula so I could just substitute it from the problem below. Problem: An oscilloscope's output is an analog signal that ranges only from 12.5mV to 50mV, while its highest frequency is 50kHz.arrow_forward20 Find, how to relate the frequency and time period in a square waveform? a. not related b. square proportional c. directly proportional d. inversely proportionalarrow_forwardThe time/div and voltage/div axes of an oscilloscope have been erased. A student connects a 1 kHz, 5 V P-P square wave calibration pulse to channel-1 of the scope and observes the screen to be as shown in the upper trace of the figure. An unknown signal is connected to channel-2 (lower trace) of the scope. If the time/div and V/div on both channels are the same, the amplitude (p - p) and period of the unknown signal are respectivelyarrow_forward
- Assignment 2: Complex Waveforms - due Jan 24 A stringed instrument generates a complex waveform with the following components: 250 Hz with an amplitude of 5 500 Hz with an amplitude of 3 750 Hz with an amplitude of 1 What is the fundamental frequency? What other harmonics are represented? What would be the equation for this waveform? (Hint: the equation only tells us the relationship between the harmonics, and not the actual frequencies represented.) Calculate the amplitude values every 10 degrees and graph the waveform. You are welcome to do this in a spreadsheet if you know how. Please complete this assignment on graph paper and scan or digitally photograph your work.arrow_forwardThe peak distance of a sinusoidal waveform displayed on a C.R.O. screen is 11 cm and the 'volts/cm' switch is on 38 V/cm. The peak to peak voltage is given by O 3.45 V 295.53 V 836.00 V O 209.00 Varrow_forwardThe waveform displayed on an oscilloscope is as shown in Figure The 'time/cm' switch is set to 1 ms/cm, and the 'volts/cm' switch is set to 1 V/cm. Determine the (i) amplitude of waveform Q, (ii) peak to peak value of waveform P, (iii) frequency of waveform P and (iv) phase angle difference between P and Q in Degrees. P Upload your Answers steps in the "Final Answer Submission" Link provided in the Moodle. (i) Amplitude of waveform Q = (ii) Peak to peak value of waveform P = (iii) Frequency of waveform P = (iv) Phase angle difference between P and Q in Degrees =arrow_forward
- A double beam oscilloscope displays 2sine waveforms A and B. The time/cm switch is on 100us/cm and the volt/cm switch on 2V/cm. The width of each complete cycle is 5cm for both the waveforms. The height of waveforms A and B are 2cm and 2.5cm respectively. Determine their a) frequency, b) phase difference, and c) peak and r.m.s value of voltages. The difference between the two waveforms is 0.5 cm.arrow_forwardA stringed instrument generates a complex waveform with the following components: 250 Hz with an amplitude of 5 500 Hz with an amplitude of 3 750 Hz with an amplitude of 1 What would be the equation for this waveform?arrow_forward7. A double beam oscilloscope displays 2 sine wave forms A and B. The time/cm switch is on 100 us/cm and the volt/cm switch is on 2V/cm.The width of each complete cycle is 5cm for both the waveforms. The height of waveforms A and B are 2 cm and 2.5 cm respectively. The distance between consecutive cross over of waveforms A and B is 0.5 cm .Determine (i) frequency (ii) peak and rms value of voltages (iii) phase difference.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Delmar's Standard Textbook Of ElectricityElectrical EngineeringISBN:9781337900348Author:Stephen L. HermanPublisher:Cengage Learning
Delmar's Standard Textbook Of Electricity
Electrical Engineering
ISBN:9781337900348
Author:Stephen L. Herman
Publisher:Cengage Learning
Digital modulation: ASK, FSK, and PSK; Author: Sunny Classroom;https://www.youtube.com/watch?v=qGwUOvErR8Q;License: Standard Youtube License