The following statements are true for any chromatographic analysis except: The analyte component interacting most strongly with the stationary phase elute faster than those with weaker interactions. On the other hand, those with least interaction with the mobile phase elute the slowest. Interactions between mobile phase-analyte - stationary phase can be both chemical and physical in nature. Chromatography is a separation technique. Electromagnetic radiation source for XPS. Gamma ray X-ray UV-Visible Infra red Radiowave The part of SEM that is responsible for the production of electrons.* Electron guns Condenser lens Secondary detector Electron beam

The following statements are true for any chromatographic analysis except: The analyte component interacting most strongly with the stationary phase elute faster than those with weaker interactions. On the other hand, those with least interaction with the mobile phase elute the slowest. Interactions between mobile phase-analyte - stationary phase can be both chemical and physical in nature. Chromatography is a separation technique. Electromagnetic radiation source for XPS. Gamma ray X-ray UV-Visible Infra red Radiowave The part of SEM that is responsible for the production of electrons.* Electron guns Condenser lens Secondary detector Electron beam

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Chapter28: High-performance Liquid Chromatography

Section: Chapter Questions

Problem 28.7QAP

See similar textbooks

Similar questions

A method of quantitative determination of the concentration of constituentsof a sample analyzed by gas chromatography is area normalization. Thiscomplete elution of all sample constituents is required. Thearea of each peak is measured and corrected for the detector response to the diffe- renteseluatos. This correction involves dividing the area by an empiricalcorrection factorDetermined. The concen ration of the analyte is found from the ratio between itscorrected and the total corrected area of all peaks. For a chromatogram containing threerelative areas were determined as 16.4; 45,2; and 30.2, in the order ofincreased retention time. Calculate the percentage of each compound if therelative responses from the detector are 0.65, 0.73 and 0.85, respectively.
Which statements are true for molecular exclusion chromatography?I Molecular exclusion chromatography separates on the basis of size.II Small molecules that freely pass through the stationary phase, Kav = 0.III Small molecules can fit in the pores of the stationary phase and effectively pass through a larger volume, and elute last.IV The pores in the stationary phase are too small for large molecules to pass through, so large molecules elute last.V Molecular exclusion chromatography with a hydrophilic stationary phase and an aqueous solvent is called gel permeation chromatography. A. II and V B. I, II, and IV C. III, IV, and V D. No correct combinations given above E. I, III, and IV F. I, II, III, and V
True or False: Liquid-solid phase column chromatography is used to separate large up to multigram amounts of mixtures, based on their differences (however small) in polarity.
4.Consider the peaks for pentafluorobenzene and benzene in the gas chromatogram shown here. The elution time for unretained solute is 1.06 min. The open tubular column is 30.0 m in length and 0.530 mm in diameter, with a layer of stationary phase 3.0 μm thick on the inner wall. a) Measruing the width, w, at the baseline on the chromatogram, find the number of plates for these two compounds b) Use your answer to (a) to find the resolution between the two peaks c) Using the number of plates N=sqrtN1*N2 with the values from (a) calcuate what the resolution should be and compare your answer with the measured resolution in b
hree components in a mixture have varying distribution constants between the mobile phase and the stationary phass One of the components has a very low distribution constant, Would this component likely elute first or last and how would you design an experiment or modify the components of the separation to make it perform in the opposite manner?