Question 7 A 30 Ohm resistor is in series with a 80 Ohm Inductive reactance. If they are connected to a 25 Volt a.c. source, what is the magnitude of the phase shift between the supply current and voltage (in Degrees)? **Only give the magnitude. If you believe the current is lagging OR leading, give a positive value for the angle ww

Question 7 A 30 Ohm resistor is in series with a 80 Ohm Inductive reactance. If they are connected to a 25 Volt a.c. source, what is the magnitude of the phase shift between the supply current and voltage (in Degrees)? **Only give the magnitude. If you believe the current is lagging OR leading, give a positive value for the angle ww

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter7: Symmetrical Faults

Section: Chapter Questions

Problem 7.2P

See similar textbooks

Similar questions

An alternating current of 5A and a direct current of 10A flow simultaneously in the same conductor. What will an AC ammeter indicate when inserted in the circuit? A. 15A C. 7.5A B. 11.18A D. 10A
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor? Answer is 80uF. What is the minimum AC voltage rating of each capacitor? Answer is 1200 volts. What is the current flow through the circuit? And what is the minimum kVAR rating of each capacitor?
DC/AC MOTOR (UPVOTE WILL BE GIVEN. PLEASE WRITE THE COMPLETE SOLUTIONS LEGIBLY. NO LONG EXPLANATIONS NEEDED. ANSWER IN 2 DECIMAL PLACES. BOX THE FINAL ANSWER.) A current of (120-j150) A flows through a circuit when applied voltage is (8 + j12) V. A. What is the magnitude of the circuit impedance: a. 0.0635 ohm b. 0.0256 ohm c. 1.52 ohm d. 1.325 ohm B. What is the reactive power? a. 825.75 VAR b. 525.68 VAR c. 639.75 VAR d. 438.72 VAR
5.) Find the percent overshoot, settling time and peak time for 0.04 T(s) == 240.002s +0.04
What should be the capacitance of a capacitor in series with 250 ohms resistor that will limit the current to 1.2 amperes when the circuit is connected to 600 volts 60 cycle source? Calculate also the power and pf. Under this condition
Please show you detailed solution Number 10 A voltage of 250 volts at 50 Hz is impressed on a circuit having a 60-ohm resistor, 35-?F capacitor, and a 0.25-henry inductor in series. Determine power factor. A. 0.979 C. 0.924 B. 0.862 D. 0.707
Draw rough sketches showing the following:a. A current which lags the voltage by 60 degreesb. A current which leads the voltage by 60 degreesc. A current which lags the voltage by 180 degrees
The current in a circuit known to consist only of resistance and inductance in series is 8.31Amps when the circuit is connected across 120V 25 hz. When connected across 120V 60 hz mains, the current is 5.3Amps. Determine the resistance and inductance.
4. A resistor and inductor are connected in parallel to a 277 volt, 60 Hz line. The resis- 12. tor has a current of 12 amperes flowing through it, and the inductor has a current flow of 8 amperes flowing through it. What is the total current flow in the circuit? m bas vlaqua
Problem 5 For two electrical system shown in Figure 5, use cyclic currents to derive a complete mathematical model for each of the electrical systems. Ri. Rz ca) Cz (6) ERZ RI
Which of the following statements is true of a shorted component in a series circuit? a. The resistance of the component will be higher than normal. b. The voltage drop across the component will be higher than normal. c. The current through the component will be lower than normal. d. The voltage drop across the component will be lower than normal.
Calculate the RMS current through R2 in the diagram IR1 = 6.06mA peak, R2 = 2.7 kohms, total current is 9.522mA RMS 3.25mA RMS 5.24mA RMS 7.41mA RMS 9.0mA RMS