Which of the following statements is true of a shorted component in a series circuit? a. The resistance of the component will be higher than normal. b. The voltage drop across the component will be higher than normal. c. The current through the component will be lower than normal. d. The voltage drop across the component will be lower than normal.

Which of the following statements is true of a shorted component in a series circuit? a. The resistance of the component will be higher than normal. b. The voltage drop across the component will be higher than normal. c. The current through the component will be lower than normal. d. The voltage drop across the component will be lower than normal.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 1RQ: 1. What is the relationship of voltage and current (concerning phase angle) in a pure resistive...

See similar textbooks

Similar questions

Which of the following statements is true of an open component in a series circuit? a.. The circuit current will be higher than normal. b. The voltage drop across the component will be lower than normal. c. The voltage drop across the component will be higher than normal. d, The resistance of the component will be lower than normal.
Define ohms law
Using the rules for parallel circuits and Ohmslaw, solve for the missing values. ETE1E2E3E4ITl1I2l3l4RTR182kR275kR356kR462kPT3.436WP1P2P3P4
5. Determine RL voltage waveform for the circuit as shown in Figure 4.
3. The secondary voltage can rise above its rated value when the load is a. resistive. b. capacitive. C. inductive. d. an RL series combination.
Ferromagnetic materials have this characteristic. A. A relative permeability slightly less than one. B. A relative permeability slightly greater than one. C. A very high resistivity. D. A high relative permeability.
After the determination of the currents references, can we connect the ammeter terminals in any way that in order to measure the current of a component ?
20/ Which Arc Extinction Method operates by keeping the Arc Resistance low until the Current becomes zero? A. High Resistance Method B. High Inductance Method C. Low Resistance Method D. Low Inductance Method
The principle operation of LVDT is based on the variation of Select one a. Self inductance b. Reluctance c. Mutual inductance d. Permanence
1- spark gaps testing method is applicable for testing 2- the electrical circuit that we use to measure high voltages and is not affected by frequency change 3- We can say high voltages if exceed ------------ V (Alternating voltages) 4- Transient voltages which are caused over voltages be in two forms 5- High voltages can be generated for testing in three ways ------
FIGURE B
1. Describe the difference between regular (ohmic) resistors and non-linear/negativecomponents. How would the presence of a non-linear or negative component changehow you might analyze a circuit?