Patient is recovering after a tonsillectomy she is sleeping but you notice that she swallow every few seconds she has an IV line of normal saline solution running at 100ml/hr How do you respond What should you be vigilant for? At how many gtts / min should her IV run if the tubing has a drop factor of 15?

Patient is recovering after a tonsillectomy she is sleeping but you notice that she swallow every few seconds she has an IV line of normal saline solution running at 100ml/hr How do you respond What should you be vigilant for? At how many gtts / min should her IV run if the tubing has a drop factor of 15?

Curren'S Math For Meds: Dosages & Sol

11th Edition

ISBN:9781305143531

Author:CURREN

Publisher:CURREN

Chapter12: Ratio And Proportion

Section: Chapter Questions

Problem 21SST

See similar textbooks

Similar questions

A client is prescribed 1 g potassium phosphate IV to be infused continuously over 6 hr. Available is 1 g potassium phosphate in 250 mL dextrose 5% water. The nurse should set the IV pump to run at how many mL/hr? (round to nearest whole number)
Which of the following intravenous administration set are you going to use for a 30 y /o client ? Macrodrip set Minidrip set Microdrip set Keep vein open set
The physician ordered 1,200 Units of heparin every hour IV continuously. The solution is 3,500 Units of heparin in 1L D5 ½ NS start at 8:00 AM. Drop factor 20 gtt/mL. What is the flow rate by IV pump?
The nurse is preparing to infuse a liter of normal saline over 4 hours IV to a patient who experienced a hemolytic reaction to blood. The drop factor is 15 gtt/mL. Calculate the drip factor. Enter the numeral only. Round to the nearest whole number.
A nurse started an IV flowrate at 100 microgtt/min, After 2 hours the nurse recalculated the IV flowrate and got a rate of 83 microgtt/min. What is the percent of change?
The physician ordered 1,200 Units of heparin every hour IV continuously. The solution is 3,500 Units of heparin in 1L D5 ½ NS start at 8:00 AM. Drop factor 20 gtt/mL. What is the flow rate by IV pump, considering the drop factor?
A 30 year-old policeman is brought to the ER due to the bleeding from his abdomen from a gunshot wound injury. He feels light headed, palpatations and cold sweat. Uon examination, his heart rate is around 130 beats per minute while blood pressure is maintained at normal. His extremities were cold and clammy. An immediate blood transfusion was done and brought to the OR for an operation. 1. What would explain the symptoms of the patient? 2. Is this an example of a reflex? Why or why not? 3. How would you explain the blood pressure being maintained at the normal level? 3. If his BP goes down, what neurotransmitter is likely to be elevated?
One characteristic of a secondary IV administration set is: Select one: O a. O b. O d. Longer tubing than primary IV sets Each set has a luer-lock connection at each end of the tubing A secondary set does not require a back-check valve Used to piggyback intermittent IV medications
A nurse is caring for a toddler and is preparing to administer 0.9% sodium chloride 100 mL IV infused over 4 hr. The drop factor of the manual IV tubing is 60 gtt/mL. The nurse should set the manual IV infusion to deliver how many gtt/min? (Round the answer to the nearest whole number and use a leading zero if applicable. Do not use a trailing zero.)
The nurse finds that an intravenous (IV) solution ordered to infuse over 8 hours fails to infuse at the intended rate. There is 240 mL of solution remaining, and only 2 hours are left to infuse the solution. There is a drop factor of 10 gtt/mL. What should the regulated rate be to complete the solution in time? Record your answer using a whole number. microgtt/min Confident Not Sure
Upon receiving the client, the intravenous insertion site needs to be inserted to the other site. The remaining IV fluid In the infusion bag is 750 milliliters. If the doctor order to administer 125 ml/hr, what time do you expect the remaining IV fluid to be consumed if it is reinserted at 7 am? 1 PM 2 PM 11 AM 3 PM
Recall from the video the steps for determining the hematocrit. Place the steps in the correct order from left to right. View Available Hint(s) Hint 1. What is the last step in determining the hematocrit? • Hint 2. What does a centrifuge do? Reset Help Centrifuge the blood for 4 to 5 minutes. Place the tube in a Fill the tube three-quarters full with blood. Seal the end with capillary tube sealer or clay. Place heparinized capillary microhematocrit tube into the blood. centrifuge. Determine the percent of RBCS. Submit Request Answer