In the following system, the flow rate of Q = 400 It / s is transmitted from the A chamber to the B chamber. There is a valve in the pipe where the diameter is large and there is a local loss due to the valve. Using the valve formula (K) as 10 (see formulas), calculate the distance H between the water face elevations of the two chambers. Draw the relative energy and piezometer lines AH A Vana L=20m D=0.2m f=0.02 В L=30m D=0.4m f=0.03

In the following system, the flow rate of Q = 400 It / s is transmitted from the A chamber to the B chamber. There is a valve in the pipe where the diameter is large and there is a local loss due to the valve. Using the valve formula (K) as 10 (see formulas), calculate the distance H between the water face elevations of the two chambers. Draw the relative energy and piezometer lines AH A Vana L=20m D=0.2m f=0.02 В L=30m D=0.4m f=0.03

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

6. An open tube is connected to a tank. The water rises to a height of 900 mm in the tube. A tube used in this way is called a piezometer. What are the pressures PA and Рв of the air above the water? Neglect capillary effects in the tube. PA Water PB Piezometer 200 mm B 400 mm- T 900 mm
Q1: Derie an epressin for the shear stress at the pipe wall when an incompressible faid flows draugh a pipe wnder pressure. Use dinmsional ana)sis witk the following siguißcant parameters: pipe diameter D, flow velociy V, and vicenity and density p of the fuid. Q2: : Use dinensional analysis to derive as epression for the power develaped by an engine in terms of the torque T and rotartive speed u.
Weter flows up a tapered pipe (figure). A differential mercury manometer is attached to the pipe at Wand B. The pipe has a diameter of 200 mm at A and 100 mm at B, the point B being 1 m above the alot A. Obtain the deflection in the manometer corresponding to a discharge of 50 L/s. Neglect the friction in the pipe. Relative density of mercury 13.6. %D 100 mm 1 m 200 mm
(a) Glycerine at 25 °C flows through a straight copper tube (D = 73.8 mm), at a flow rate of 180 L/min. Calculate the pressure difference between 2 points which are 25.8 m apart, if the first point is 0.68 m below the second point. Gven: At 25 °C density and dynamic viscosity for glycerine is 1286kg/ and 0.96 Pa.s respectively(b) If benzene at 50 °C is used in question (a) above instead of glycerine, evaluate the new pressure difference. ...
The discharge flowing down the pipe is 0.03 m3/s and the pressure at 2 is 20kPa. Assuming the losses in the pipe is negligible. A U-tube is connected between points 1 and 2 to determine the difference in their pressure, what would be the value of y. Liquid flowing in the pipe is water
. A solvent used for plastic manufacturing consists of cyclohexanol in tank A and ethyl lactate in tank B. Determine the pressure on the top of tank A if the mercury in the manometer is at the level shown, where h = 0.75 m. Take Sc= 0.953, SHg = 13.55 and Sel = 1.03. po A T 1.5 m B mercury 4.5 m
kerosene is placed inside a glass capillary tube having a radius of 0.5mm. the kerosene inside the tube is measured to have a standing height of 59mm. determine the true static height of the kerosene using the surface tension value if 0.035N/m and Sg=0.8 Final answer in mm.
12. A pipe contains an oil of sp. gr. 0.8. A differential manometer connected at the two points A and B of pipe shows a difference in mercury level as 20 cm. Find the difference of pressure at the two points (Ans. 25113.6 Nm] 13. A U-tube differential manometer connects two pressure pipes A and B. Pipe A contains carbon tetrachloride having a specific gravity 1.594 under a pressure of 11.772 N/cm and pipe B contains oll of sp. gr. 0.8 under a pressure of 11.772 N/em. The pipe A lies 2.5 m above pipe B. Find the difference of [Ans. 31.36 cm of mercury] 14. A differential manometer is connected at the two points A and B as shown in Fig, 2.25. At B air pressure [Ans, 6.91 Nicm) pressure measured by mercury as fluid filling U-tube. is 7.848 N/cm (abs.), find the absolute pressure at A. AIR WATER OIL Sp. gr.0.8 OIL Sp. gr. 0.8 50'cm I. 30'am 100 am 50 cm MERCURY Sp. gr.13.6 WATER Fig. 2.25 Fig. 2.26
(3) An open jet of water at 20 °C exits a nozzle into sea-level air and strikes a stagnation tube, as shown in the sketch. If the pressure at the centerline of section (1) is 11Okpa (abs), and losses are neglected, estimate: (a) the mass flow in kg/s, and (b) the height H of the fluid in the stagnation tube. (Atmospheric pressure =101.3 kpa) 4 cm Water 12 cm (1)- Sea-level air
In horizontal pipe, which of the following is constant? Pressure headElevation headVelovity head 12
The cylindrical tank with hemispherical ends shown contains a volatile liquid and its vapor. the liquid density is 0.87 and its vapor density is negligible. The pressure in the vapor is 119 kPa (abs), and the atmospheric pressure is 101 kPa (abs). (a.) Determine the gage pressure reading on the pressure gage in kPa. (b.) Determine hte height, h, of the mercury manometer in centimeters.
0.12 O -0.12 8.33 (1) Darcy Experiment A set-up of Darcy Experiment involves measuring the pressure head at two piezometers separated a distance, L. Given the set-up shown, determine the hydraulic gradient if the hydraulic head at (1) is 66 cm, hydraulic head at (2) is 54 cm, and the travel distance is 100 cm. O-8.33 -L h e - - - -