Answered: For non-inverted low pass filter, the…

For non-inverted low pass filter, the cut off frequency is 100Hz and the impedance resistor is 25KQ. Compute the capacitor value when the input resistor is 15 KQ and the voltage gain is 15.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 23 Consider the parallel RLC circuit of Fig. 16.57. Find v(t) and i(t) given that v(0) 5 and i(0) =…

Q: 2. Given ID= -4mA at VGs=-2V, determine loss if Vp=-5V. a.11.11mA b.22.22mA c.33.33mA d.44.44mA

A: We need to select correct option for given current and voltage

Q: Q4/Compare between Microprocessor and Microcontroller for the following: 1. Internal Architucture 2.…

A: 1. Internal Architecture: Microprocessor consists of only CPU whereas Microcontroller consists of…

Q: Suppose that each diode in the circuit shown in figure 2 has a turn-on voltage of Vy= 0.7 volts.…

A: A conventional diode with a significantly greater maximum current rating is called a rectifier or…

Q: 37. Zener diode allows .......electric current than the normal p-n junction diodes. O a. Less. *

A: Zener diode : A Zener diode is a special type of semiconductor device which allows the current to…

Q: Complete the following table with its corresponding values and draw a graph.

A: a) The circuit diagram is given as When the diode will be forward biased, It will replace with its…

Q: 1.For the circuit shown in the figure, determine the value of RL. What will make the Zener diode…

A: Zener diode is similar to a diode, it has a heavily doped semiconductor region that will operate in…

Q: Find the Current lo

Q: A 50 MVA, 11 KV three-phase alternator was subjected to a different types of faults. The fault…

Q: Find the Current Io. In figure (2). YmA 2mA m Ika Iy 2K² m Is Ik Is Elka 6mA

A: Current: It is the time rate of the change of the charges. It is also known as the flow of the…

Q: Determine the value current supply (IT) in figure (1). Fig.1 lon { lon; 55 lon Slove IT 24V VT

A: To find the value of current flowing through supply (IT)

Q: (b) Figure 1(b) shows a type of oscillator. Given T=3ms and the duty cycle is 50%. i) Name this…

A: Given: Consider the following figure shows a type of oscillator. Given T=3ms and the duty cycle is…

Q: For 3G cellular data networks, what function does the RNC (Radio Network Controller) play?

A: RNC represents Radio Network Controller. The function RNC plays in this architecture is to control…

Q: Equipment for immersion cooling of electronic components has an installed value of $182,000 with an…

A: Immersive cooling is a method used for cooling electronic components, they are immersed in a…

Q: A 5V voltage source is connected at port 1 and a 500 resistor is connected at port 2. Find the port…

A: The given circuit is shown below. We need to determine the port currents I1 and I2.

Q: find the inverse laplance tranformation of s^2/(s^2+9)(s^2+25) using convalutionn theorem

A: In this question, We need to determine the inverse Laplace transform of the given system.

Q: 2) In an n-channel enhancement type MOSFET if VGS = Ov and VDs > Ov then ID> 0 A. a) True. b) False.…

Q: 2) For the bi-stable multivibrator circuit using BJT transistors, if the trigger waveform frequency…

A: Given here a question about bi-stable Multi vibrator. Given triggering wave form frequency and asked…

Q: 47. In NPN BJT, .......current is lowest current. O a. Base. O b. Collector. O O d. Drain. O e.…

A: A BJT is a current controlled Device in which base current control the mode of operation of BJT.…

Q: hot matter! [Q2] The probability distribution for the discrete random variable in the table below.…

Q: Q3 Evaluate the integral 00 8 (t-) 6 sin(t) dt

Q: If the magnitude of a transfer function is given to be 2000 in linear scale, |H| = 2000 , what would…

A: Given: Magnitude of transfer function on linear scale, H=2000

Q: What is the velocity of an electromagnetic wave in free space?

A: In this case, the velocity of an electromagnetic wave in free space is to be determined.

Q: A single phase full-wave controlled rectifier using center-tap transformer is fed from a 230 V, 50…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: (a) Describe in diagrams the practical Analog filter specifications. (b) Explain the design process…

A: Given The practical Analog filter specifications and the design process of digital filters are…

Q: Consider an a.c circuit supplied by 220V at 50Hz. The circuit consists of only two inductors, L1 and…

A: Capacitive reactance inversely propotional to frequency Inductive reactance directly proportional…

Q: 10V, 1kHz signal is applied to a 10mH coil with negligible winding resistance. Determine Q (Reactive…

A: We need to find reactive power for given circuit

Q: 2. Dip-coating process is one of the methods for electrode surface modification.

A: Answer : True The above statement is correct.

Q: connected

Q: Apply Norton theorem to calculate the current in 6 2 resistance for the circuit in figure 3 2000 + 5…

A: In this questions we need to calculate the current through 6ohm resistance by Norton theorem.…

Q: For the circuit shown in the figure, determine the value of RL. What will make the Zener diode reach…

A: The given circuit is

Q: If the unit step response of a network is (1 - e-at), then Find its unit impulse response

Q: Consider the circuit in Fig. 16.12(a). Find the value of the voltage across the capacitor assuming…

A: here only one independent source so we can't apply the superposition theorem. According to…

Q: U₁ 2 ΚΩ m Check 250 mH P13.49c_7ed Find the s domain transfer function H(s) = Vo/V₁ for this…

Q: Find the Current Io. In figure (2). 4mA 2mA II, Ika wm 12, Ika Iy 2km 4 Io lkn Is Fig.2 6V lkn (1)…

Q: find transfer function YS/RS for this blok diagram

Q: Apply Norton theorem to calculate the current in 62 resistance for the circuit in figure 3 2001 55…

A: According to the question, the given circuit is To find Norton's current we will short-circuit the…

Q: 1. In the given triangle, charges Q1= 50x10^-9 C and Q2= -40 X10^-9 were placed as shown. Find the…

Q: For a filter works with high frequency 150KHz, the Vin is 25V and the resistor is 8.2KQ. Compute the…

A: The passive high pass filter can be with the help of capacitor and resistor. The capacitor will…

Q: Determine the voltage V, in the circuit shown below

A: It is given that:

Q: Find the current I if: V₁=2V, V₂=1.5 V, R₁=20 KM2, R₂-10 K and R3=5 KM. V₂ V₁ R₁ R₂ ww R3 R₂ R₁

A: Given data :

Q: 50........is a photodetector that need lower biased voltage. O a. PIN. O b. Traditional Diode. O c.…

A: Photodetectors

Q: The reactance data for the given power system is as follows: Item X¹ X2X G₁ G₂ Ti T2 Line 1-2 0.10…

A: Per unit system is the provide the unit of the power, current, voltage, and admittance and two unit…

Q: Find the Current Io. In figure (2). Чта 2mA ↑ IT Ika wm 122 Ika Iy 2km m Io lkn, Is GV I кл 16mA

Q: A variable capacitor is connected in parallel with an impedance coil having a resistance of 30 ohms…

A: 1) Given a variable capacitor connected in parallel with an impedance coil havin resistance and…

Q: Determine the current supplied by each voltage source (8 V,12 V). using superposition theorem in…

A: Given circuit, To determine current supplied by each voltage source using superposition.

Q: A series DC motor has a resistance of 5 0 between its terminals. The motor runs at 1,210 rpm at. 230…

Q: 5/ For the Circuit Shown, Find V1 and V2 1020⁰ A -j2.5 Ω 0000 4Ω Η Ω 31,

A: KCL states states that algebraic sum of current at a node must be equal to zero. It is also called…

Q: Q4) Find the Y-parameters of the network shown below and then from the Y-parameters find h-…

A: y-parameter matrix: this matrix is also known as the admittance matrix. this matric can also be…

Q: Simplify the following block diagram. 63 G, ܣܩܟ H1 G4 H 62

A: Given data, Block diagram is given as,

Concept explainers

Filter

A filter is a device or process which removes some of the unwanted features or components like frequencies from a signal in signal processing. The feature of filters is the complete or partial suppression of some part of the signal, and filtering is a class of signal processing. This most often means removing some frequency bands or some frequencies. In the frequency domain, the filters do not exclusively act, especially in the image processing field many other targets for filtering exist. Without having to act in the frequency domain, the correlations can be removed for certain frequency components and not for others. The filters are widely used in electronics and telecommunication, in television, radio, radar, audio recording, music synthesis, control systems, computer graphics, and image processing.

Question

For non-inverted low pass filter, the
cut off frequency is 100HZ and the
impedance resistor is 25KQ.
Compute the capacitor value when
the input resistor is 15 KQ and the
voltage gain is 15.
0.63662 nF
0.010610 nF
106.10 nF
63.662 nF

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

3. Show how a series RLC filter, its type depends on the output voltage terminal as follows: Low pass filter the output voltage across ... High pass filter the output voltage across . Band pass filter the output voltage across Band reject filter the output voltage across ...... ......... ........
How & Find the transfer function, Center frequency, and bandwidth in figure. what type of filter?, Q, H(jWo), H(jo), H(jas) How:- repeat the previous H-W in the figure below. R 7 Vi + REVO RL
The mask shown in the figure below belongs to which type of filter : Median filterSharpening frequency filterSharpening spatial filterSmoothing spatial filter
(B2) The magnitude characteristic of this filter is equiripple in the passband and monotonic in the stopband.
Design a low pass active filter with a dc gain of 4 and a comer frequency of 500Hz ?
Q3/ Determine the centre frequency, maximum gain, bandwidth and type filter for the circuiting figure. 1 kOhm 0.022 UF HH 0.047 uF 0.047 UF 1 kOhm 1 kOhm Vo HH HH 560 Ohm 560 Ohm 0.022 UF 1 kOhm 1 kOhm Kohm
Calculate the cutoff frequency for the opamp Sallen-Key 2nd order highpass filter
What are magnitude and frequency scale factor will transform the prototype high pass filter into a high pass filter with a 0.5 capacitor and a cutoff frequency of 10 kHz
Explain why it is necessary to add capacitor in High Pass filter, draw circuit diagram and explain w.r.t combination of Capacitor and RL.
Q3/ Determine the centre frequency, maximum gain, bandwidth and type filter for the circuiting figure. 1 kOhm 0.022 UF HH 0.047 uF 0.047 UF 1 k Ohm 1 kOhm vo HH HH 560 Ohm 1 Hohm 560 Ohm 0.022 UF 1 k Ohm 1 kOhm
How & Find the transfer function, Center frequency, and bandwidth in figure what type of filter ?, Q, H(jwo), H(jo), H(joo) Foror + REV
In the circuit in the figure, Vin=30Vrms and Vout are taken from the C1 capacity. Accordingly, a) Filter find the type b) Find the cutoff frequency (fc) of the circuit c) A=Vout/Vin for f=100, 800 and fc values draw the curve?