Consider an a.c circuit supplied by 220V at 50Hz. The circuit consists of only two inductors, L1 and L2 with inductive reactances of 8 Ohms and 13 Ohms respectively. Calculate the current flowing around the circuit for two cases: (1) L1 and L2 are connected in series, (2) L1 and L2 are connected in parallel Enter the higher of these two current values as your answer in Amps, to two decimal places.

Consider an a.c circuit supplied by 220V at 50Hz. The circuit consists of only two inductors, L1 and L2 with inductive reactances of 8 Ohms and 13 Ohms respectively. Calculate the current flowing around the circuit for two cases: (1) L1 and L2 are connected in series, (2) L1 and L2 are connected in parallel Enter the higher of these two current values as your answer in Amps, to two decimal places.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.20P: A circuit consists of two impedances, Z1=2030 and Z2=2560, in parallel, supplied by a source voltage...

See similar textbooks

Similar questions

A circuit consists of two impedances, Z1=2030 and Z2=2560, in parallel, supplied by a source voltage V=10060volts. Determine the power triangle for each of the impedances and for the source.
An inductance coil consumes 500W of power at 10A and 110V and 60HZ. Determine the resistance and the inductance of the coil
A resistor of 20 Ohms and a capacitance of unknown value when connected in in parallel across a 100V, 50Hz supply, take a current of 6A. The combination is now connected across a 100v supply of unknown frequency and the current falls to 5.5A. What is the frequency?
A resistor and a capacitor are connected in series across a supply of 250 V. When the supply frequency is 50 Hz the current in the circuit is 5 A. When the supply frequency is 60 Hz, the current is 5.8 A. Find the value of the resistance.
A capacitor C is connected in parallel with a resistor R across a 120 V, 200 Hz supply. The supply current is 2 A at a power factor of 0.6 leading. Determine the values of C and R.
A resistor of 20ohms and a capacitance of unknown value when connected. In in parallel across a 100V, 50Hz supply take a current of 6A. The combination is now connected across a 100V supply of unknown frequency and the current falls to 5.5A . What is the frequency?
An alternating voltage is applied to a series circuit consisting of a resistor and iron-cored inductor and a capacitor. The current in the circuit is 0.5 A and the voltages measured are 30 V across the resistor, 48 V across the inductor, 60 V across the resistor and inductor and 90 V across the capacitor. Find (a) the combined copper and iron losses in the inductor (b) the applied voltage.
25. Two cells, two resistors and two capacitors are connected as shown in figure. The charge on 2 uF capacitor is 3uF 18V 15V 12 22 2pF (a) 30 uC 26. In the cimuit (b) 20 uC (c) 25 uC (d) 48 uC www www
An alternating voltage is applied to a series circuit consisting of a resistor and iron-cored inductor anda capacitor. The current in the circuit is 0.5 A and the voltages measured are 30 V across the resistor,48 V across the inductor, 60 V across the resistor and inductor and 90 V across the capacitor.Find (a) the combined copper and iron losses in the inductor (b) the applied voltage Answer: [(a) 3.3 W (b) 56 V]
L VL VR + E An L-R series circuit consists of an inductor with inductance, L, connected in series with a resistor with resistance, R. The resistance, R, is a circuit parameter that opposes the current, I, and causes a drop in potential given by Ohm's Law while inductance, L, is a circuit parameter that opposes a change in current. Both the resistor and inductor cause the total drop in electric potential and is equivalent to the total electromotive force, E, which is produced by a voltage source such as batteries. dl I + R E = L dt As soon as the switch is opened, the current, I, passing through the circuit varies through time, t. In the given differential equation above, the current I and the time t are the dependent and independent variables, respectively. The electromotive force E, the resistance R, and the inductance L are constants. Using A as the constant of integration, find the general solution in explicit form I = f(t). Knowing that there is no current passing through the…
Find the resultant system of converging forces in the 500 N figure. Below 20ON 30ON
An inductor and a resistor are in series with a sinewave voltage source. The frequency is set so that the inductive reactance is equal to the resistance. If the frequency is increased, then options: Voltage across the inductor= Source Voltage Voltage across the inductor> Voltage across the resistor Voltage across the inductor= Voltage across the resistor Voltage across the resistor > Voltage across the inductor