Find the position of the intrinsic Fermi level with respect to the center of the bandgap in silicon at T-400 K. [where m.*= 1.08mo and m,*= 0.56mo].

Find the position of the intrinsic Fermi level with respect to the center of the bandgap in silicon at T-400 K. [where m.= 1.08mo and m,= 0.56mo].

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter16: Inductance In Ac Circuits

Section: Chapter Questions

Problem 2PP: What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?

See similar textbooks

Related questions

Q: 1)A schematic of an absorption curve is shown to the right for an indirect band-gap semiconductor.…

A: Because direct band-gap semiconductors do not involve lattice vibration in electron band-to-band…

Q: Problem 2. In a typical MOSFET structure with a p-Si body, the Drain/Body and Source/Body regions…

A: MOSFET- Metal oxide semiconductor Field effect Transistor. It is basically a semiconductor…

Q: In which of the following, the number of electrons in the conduction band and the number of holes in…

A: In intrinsic semiconductor the number of electrons and holes are equal.

Q: 1-If you know that the Fermi level is below the conduction band by 0.25eV and that the energy gap of…

Q: A pure silicon is doped with 1019 boron per cm at room temperature if m, = 0.8mo calculate %3D (0)…

Q: At 300 K, for a diode curret of 1 mA, a certain germanium diode requires a forward bias of 0.1435 V,…

A: The conductivity of semiconductor is lies in between conductor and insulator. The conduction in…

Q: 1. The Fermi level in n-type silicon at for T = 300 K is 245 m eV below the conduction band and 200…

A: NOTE: We’ll answer the first question since the exact one wasn’t specified. Please submit a new…

Q: Consider a silicon pn junction solar cell at 300 K with a reverse saturation current of 1x10-7…

A: Solar cell convert light energy in to electricity. Solar cell junction diode is different from p-n…

Q: What is the value of p0 if the Fermi energy in silicon at T=300K is 0.22 eV above the valence band…

A: The solution can be achieved as follows.

Q: A certain semiconductor laser diode has a length of 0.5 mm and has a high reflection coating on the…

A: In this section, I have done only one part. Electrical current passing via a p–n junction or (more…

Q: The reverse current of diodes of silicon is equal to (30nA) at (25°C), if you know that the…

A: The leakage current is given by IS2=IS1 2(T2-T1)/10 T1=25°C T2=75°C…

Q: From the given semiconductor diodes which will act as a source of microwave

Q: Q4: Determine the position of the intrinsic Fermi level with respect center of the bandgap in GAAS…

Q: how much is the nominal current with which a LED diode with semiconductor material (wavelength) LED…

A: (LED)light emitting diode is an electric component which emits light if the electric current flows…

Q: Q4: Determine the position of the intrinsic Fermi level with respect to the center of the bandgap in…

A: Where k is the boltzman constant and T is temperature in kelvin For GaAs KT = 0.0259 eV

Q: Figure shows the parabolic E versus k relationship in the conduction band for an electron in two…

Q: Which of the following has the maximum Energy gap between conduction band and valence band? O None O…

A: The bandgap is the energy gap between the valence band and conduction band or between the free state…

Q: |Q2:- Determine the values of no and po for silicon at T = 400 K, if the Fermi energy is 0.22eV…

Q: Question one: no Drive the following expression for the position of Fermi level: Ef¡ = Ef – KT In º…

Q: Assume that the mobility of electrons in silicon at T = 300 K is Uz= 1300 cm?/V-s. Also assume that…

A: Given : Brief description: In the above given question they have mentioned mobility of the electron…

Q: 1. Given that the effective masses of electron and holes in silicon, calculate the position of the…

A: Semiconductor are the material made of pure Si or Ge or compound . They have conductivity in between…

Q: In a very high quality homo-junction pn" LED made of a direct band gap semiconductor, the internally…

Q: The modified work function of an n-channel MOSFET is -0.85 V. If the interface change is 3*10-4 C/m2…

A: Given: Modified work function, Wc =-0.85 V Interface charge, q = 3×10-4 C/m2 Oxide capacitance, C =…

Q: When the energy gap value of the semiconductors between the valence band and the conduction band is…

A: Answer is GaAs>Si>Ge

Q: The electron concentration in pure silicon is 1.5x1016 m-3 at 300°K. The silicon was doped with…

Q: When a photon (light) with hv energy falls on a semiconductor material, it radiates at the 650 nm…

Q: 7. At 300 K, Silicon is doped with NA = 6.0 x 1016 cm3. Find n, and po. Draw the energy band diagram…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: In a P-type semiconductor, the Fermi level is 0.3 ev above the valance band at a room temperature of…

A: Fermi level in P-Type semiconductor lies near to valence band. Fermi level EF in P-Type…

Q: Assume the energy state is 0.02 eV above the Fermi level. Determine the probability of state being…

Q: (b) Compare and construct the band energy diagram of conductor, insulator and semiconductor…

A: In conductors, insulators, and semiconductors, the " Band theory " explains the electronic…

Q: The modified work function of an n-channel MOSFET is -0.85 V. If the interface charge is 3 × 104…

A: Given: Modified work function, Wc=-0.85 V Interface charge, q=3×10-4 C/m2 Oxide capacitance, C=300…

Q: Semiconductor LED's have a slow response time and hence a low frequency operation and low band width…

A: LED's are optoelectronic devices that convert electrical current into electromagnetic radiation…

Q: semiconductor is transparent to light with a wavelength longer than 0.87 μm, determine its band gap…

Q: A silicon pin photodiode with an intrinsic layer, or i-layer, has a width of 10 (µm) and a reverse…

A: It is given that: W=10 μm=10×10-6 mηe=0.9E=35 fJ=35×10-15 J

Q: For a given type of semiconductor material with the band gap energy of 1.5eV, find the maximum…

Q: In a very high quality homo-junction pn* LED made of a direct band gap semiconductor, the internally…

Q: Calculate the effective state densities Uc and Uv for the semiconductors InAs and InSb and their…

A: For InAs: Basic Parameter Eg=0.354ev (1): Effective state density in Uc Nc=22πme*kTh232 (2):…

Q: If there is an energy gap of 5eV between conduction band and the valence band in a material, such…

A: The conductivity of any material is determined by the gap between the valence band and the…

Q: 5. In a P-type germanium, nį = 2.1 × 1019 m-³density of boran 4.5 x 1023 atoms /m³. The electron and…

A: (a) Calculate the conductivity before the addition of boron atoms.…

Q: Consider a silicon crystal at 27° C doped with atoms at a concentration of Na= 107cı 1- Calculate…

Q: Calculate the temperature at which there is 1% probabailty that a state with an energy 0.5eV, above…

A: The temperature at 1% probability is as follows: F(E)=1%=1/100E-EF=0.5 evFE=11+expE-EF/KBTAs…

Q: At the Fermi temperature TF, EF = kTF . When T = TF, what is the probability that a state with…

A: The Fermi-Dirac distribution f(E) gives the probability that a state with energy E is occupied with…

Q: 1. Given that the effective masses of electron and holes in gallium arsenide, calculate the position…

Q: Consider a silicon crystal at 27° C doped with atoms at a concentration of Na = 10" cm 1- Calculate…

A: Here this is n type si semiconductor. I have found the value of conductivity and the difference of…

Q: The fermi level of a n-type material is located near the band. The fermi level of a p-type material…

Q: Determine the probability that the energy state is empty if the state is below the Fermi level by…

A: Probability of non existing of electrons is nothing but the probability that the energy state is…

Concept explainers

Electric field

A physical field present around an electrically charged particle that exerts a force on all other charged particles is called an electric field. The charged particles present in the field either repel or attract. From electric charges or time-varying magnetic fields, the electric field originates. One of the manifestations of electromagnetic force which is one of the four fundamental forces present in nature are the electric fields and magnetic fields.

Question

Find the position of the intrinsic Fermi level with respect to the center of the bandgap in
silicon at T=400 K. [where m,*= 1.08mo and m,*= 0.56mo].

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Which of the following is not a practical type of inductor? O a. SMD Chip Inductor O b. AM Radio Antenna O c. Curie Temperature O d. Toroidal Core Inductor
Assume that the Fermi level is near the valence band. Which of the following is true? Select one: O a. Non of the answers. O b. n+p=ni. O C. p>n. d. n=p=ni. O e. n>p.
The forward biased diode has an admittanice (inverse of impedance) shown below. At what freguency in MHz will the admittance of the resistor (G) be 6.1 times the magnitude of the capacitor's admittance? You can assume the ideal diode has a forward bias of 0.65 V, a characteristic current of 6.2 fA (fempto = 1015), and a minority carrier lifetime of 2.9 microseconds. You can assume that you can use equation 7.29 of the text, Under what conditions would the magnitude of the capacitor's admitance be 5.1 times the admittance óf the resistor (G? Three significant digits and fixed notation. Diode admittance Rs G
Consider more realistic situation, silicons intrinsic Fermi level isn't at the midgap. Please find the energy differences between real Fermi level and midgap Please give some explanations.
Question A sinusoidal signal with a peak voltage of 10V is input into a frequency dependent circuit. What is the peak voltage at its -6dB frequency?
QUESTION 6 A PIN produces an average photocurrent of 1 mA, when exposed to a constant flow of photons. The diode is operating under a bandwidth of 100 MHz. What is the signal-to-noise ratio? (Assume shot noise is dominating and the dark current is negligible). Oa. 35 dB Ob.57 dB Oc. 75 dB O d. 89 dB
Determine the capacitance of diffused junction varactor at a reverse potential of 4.5 V. if C(0) = 85 pF and V₁ = 0.7 V. Also determine the value of K.
Design a 15v full wave power supply that will deliver a 1.5A of DC current to a load of 1kohms Given: Solution: Diagram
If we assume the peak voltage Vmax across the capacitor is 16V and the capacitor discharges into the resistor for 12msec, what is the time constant (in milliseconds) of the circuit during the discharge?
2.24 InP is doped with ND = 2.0 × 10 15 cm³ and NA = 1014 cm³. Draw the energy band diagram and calculate the location of the Fermi level.
Determine the transition capacitance of diffused junction varicap diode at a reverse potential at 5.2 V if C(0) = 90 pF and VT = 0.7 V.
Provide your complete solution and formula. Sample Problem: [EE Board April 2003 ] An alternating current of rectangular wave shape has amplitude of 10 and a frequency of one (1). What is the RMS current?