6. An inductive circuit of 50-2 resistance and 0.08-H inductance is connected in series with a capacitor across a 200-V, 50-Hz supply. The current taken is 3.8 A leading. Find the value of the capacitor.

6. An inductive circuit of 50-2 resistance and 0.08-H inductance is connected in series with a capacitor across a 200-V, 50-Hz supply. The current taken is 3.8 A leading. Find the value of the capacitor.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: PROBLEM 7.15 Determine VOUT versus vIN for the circuit shown in Figure 7.8 Assume that the MOSFET…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Consider a 9-cluster cellular GSM network having 7 cells per cluster. A total bandwidth of 25MHZ is…

A: Since you have posted a question with multiple subparts, we will solve the first three subparts for…

Q: 1- Three point charges (-1 nC, 4 nC and 3 nC) are located at (0,0,0), (0,0,1) and (1,0,0)…

A: This question belongs to electro magnetic field theory . It is based on the concept of calculation…

Q: For a silicon diode, calculate the current at room temperature if the forward voltage VF = 0.3 V and…

Q: 1. What is the phase relationship between VR and VL components in a series AC circuit? 2. Based on…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: [3] Consider the following circuit shown below which Ha 3 identical 1.50 volt batteries, each with…

A: As per company guidelines, we are supposed to answer the first 3 subparts of the question. Kindly…

Q: ropic) of 20 and 15 dB, respective d the maximum power delivered to ume that the antennas are…

Q: Q2: For the following roots of the prototype second order systems: System a S1 = -2,s2 =-2 %3D…

A: Note: If pole are in left half of the plane then system will be stable. If poles are on imaginary…

Q: With the basic circuit diagram, explain the restricted earth fault relay for a transformer.

Q: Find the transfer function

Q: Q6: Obtain the Thevenin equivalent for the circuit shown below , given that : iş(t) = 3cos(4 × 10*t)…

Q: Q1: consider the following control system R(s) K C(s) s(s + 2)(s + 5) Find: 1. Forward transfer…

Q: 2- A hollow cylinder of length 2 m has its cross-section as shown in the Figure below. If the…

A: Please refer the attached images for the complete answer..

Q: Label the parts of Lattice Steel Towers.

A: Lattice Steel Tower Lattice steel tower means an independent standing perpendicular steel tower.…

Q: A base station cellular communication systems lossless antenna has a maxin gain of 16 dB (above…

A: In this question we will find maximum radiated power density due to antenna using data given in…

Q: Two resistors, with resistances 40 Ω and 60 Ω, respectively, are located in a series connection,…

A: The series connection can be solved easily here.

Q: Para Vel R-c R-L 2-レ-C Cニ I. し: R= R Viclo sinwt レイ IR Find Iレ

A: Given circuit is shown below Given Vi=10sinωt and frequency f=10khz Thus, ω=20π×103

Q: II. Determine the direction of the induced current loop for each situation (upward or downward) and…

A: 1. For North type , it will form a "dot" inside the ring and current loop will be downward. 2. For…

Q: 6. Determine Vo and I for the network shown. 1 V Si GaAs oVo 1 k2

Q: Find the Transfer function of below circuit if : R=1kohm C= 2pf L= 3H R Vi

A: Given: R=1 kΩC=2 pfL=3 H

Q: P.1- The asynchronous motor and the other equipment or Fig 1 parameters are: = 0.016 Kgm D, motor =…

A: It is given that: Dmotor=0.005 Nms/radJmotor=0.016 kgm2 ηsf=92 %=0.92Dsf=0.003 Nm.s/radJsf=0.028…

Q: Q1. This is the FET relationship of a change in Ip to the corresponding change in VGs. a.…

A: In this question, we need to choose the correct option What is the FET relationship of a change in…

Q: A given FM transmitter is modulated with a single sinusoid, the output for no load power is 100W…

A: The solution is given below

Q: For the fixed-bias network in Figure 2, if the gain is 5, find the following: 1. RD 2. If V;=2mV,…

A: We need to find out the unknown resistance and output voltage for given circuit

Q: 피끼 = (0.25)"-1u[n- 1].

A: We need to find out Fourier transform of given sequence

Q: a. Given the Bode diagram in figure 2, obtain the following by showing horizontal and vertical line…

A: The required parameter can be analyzed by using the bode magnitude and phase plot.

Q: 2.) A vector is given in cylindrical coordinates as A = 2a, + 3a, - a. Describe this vector in…

Q: A Y-Y three-phase circuit is shown below. Solve for the following: Line current of phase b = Blank…

Q: 3.) The heat flow vector H = kVT, where T is the temperature and k is the thermal conductivity.…

A: The solution is given below

Q: Question 1 State Gauss's law. Deduce Coulomb's law from Gauss's law, thereby affirming that Gauss's…

Q: Given the circuit, compute for: 1. equivalent resistance of the circuit 2. total current on the…

Q: A phase modulator has kp=1.5 rad/V. What rms voltage of a sine wave would cause a peak phase…

A: The phase modulation can be shown here.

Q: Three point charges (-1 nC, 4 nC and 3 nC) are located at (0,0,0), (0,0,1) and (1,0,0) respectively,…

A: We will find out total energy for given system

Q: |Compute Qo and š for a simple parallel RLC network if (a) R = 1 k2, |C = 10 mF, and L = 1 H; (b) R…

A: In this question we will find q factor and damping ratio for parallel circuit...

Q: Which of the following is not a requirement for the Routh stability test? a. all coefficients…

A: In this question, We need to choose the correct option Which of the following is not a requirement…

Q: A phase modulator has kp=1.5 rad/V. What rms voltage of a sine wave would cause a peak phase…

Q: Elec w/m

Q: 6.41.1 The voltage across an inductor with 2 H capacitance is 12. (1 – e-dr) v, where a = 1.2. If…

A: Inductor doesn't allow Sudden change of current.

Q: 0/1 What is the current gain for a common-base configuration where IE = 4.2mA and IC = 4.0 %3D %3D…

A: Given, Common Base configuration has Emitter current (IE) = 4.2 mA Collector current (IC) = 4mA

Q: A digital system is described by the following difference equation: y(n)= 0.25x(n- 2) + 0.5 y(n–1) –…

Q: Statement I: Ck = CN+k+1 Statement II: ||Ck+2|| = ||CN-k-2|| Statement III: Zck+1 ZCN-k-1

Q: Find the Unknown Resistor value R1 and Currents 11, I2 & 13 on the circuit below. 1.0 kN 0.5 A R3 +…

A: In this question we will find unknown resistance R 1 and unknown currents I 1 , I 2 and I 3...

Q: What is an approach thats being investigated to mitigate the absorption losses in photovoltaics?

A: Solar cells are photovoltaics. Quantum efficiency and impedance spectroscopy tools are used for…

Q: 2. For the given network, find the equivalent resistance, Reg. Show detailed solution. 10 2 a o ww d…

A: The solution is given below

Q: 27: For the open loop poles shown in figure s-plane 1- Find the open loop transfer function 2-…

Q: 1. In the following figure: %3D R = 3 kN X; = 2 kM Xc = 1 kN + VR VL VC i e = 6 sin(314t + 60°) %3D…

Q: O Why the Ip-VD is not linear at low VD regime? Is this an intrinsic or extrinsic property? Is…

A: Solution- ID -VD is not linear at low VD regime because of intrinstic property of semiconductor ,…

Q: For the op-amp in Figure 4, find the value of V2.

A: Operational amplifier-An integrated circuit which amplifies weak electric signals into a strong…

Q: 36 G(s) = s2 + 8s + 36 R(s) E(s) C(s) G(s)

Q: Perform the indicated operations given that V, = 3+jl and V2 = 6226°. 1. V3 = V, + V2 2. V3 = V1 –…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

6. An inductive circuit of 50-2 resistance and 0.08-H inductance is connected in series with a capacitor
across a 200-V, 50-Hz supply. The current taken is 3.8 A leading. Find the value of the capacitor.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
An inductance coil consumes 500W of power at 10A and 110V and 60HZ. Determine the resistance and the inductance of the coil
Please explain this question properly A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
A capacitor in series with a 20-KO resistance across a 10 V ac source. What size C is needed for equal voltage across R and Xc at frequency of 100 Hz and 100 KHz.
An inductor and a resistor are in series with a sinewave voltage source. The frequency is set so that the inductive reactance is equal to the resistance. If the frequency is increased, then options: Voltage across the inductor= Source Voltage Voltage across the inductor> Voltage across the resistor Voltage across the inductor= Voltage across the resistor Voltage across the resistor > Voltage across the inductor
A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
A resistor & a capacitor are connected in series across 230V, ac supply. The current taken by the circuit is 4 A for 50 Hz frequency. The current is reduced to 2 A, when the frequency of supply is decreased to 40 Hz. Determine the value of resistor & the capacitor.
Show that the voltage division rule for two capacitors in series as in the figure
how do i calculate the inverse capacitance and its uncertainty if the capacitance value 1.8748+/- 0.0006. please show steps im using this example to do my other values.
A capacitor in series with a 200 ohms resistor draws a current of 0.3 ampere from 120 volts, 60 hz source. What is the value of the capacitor in microfarad? a. 8.7 b. 9.7 c. 6.7 d. 7.7
4. The current through a 10-mH inductor is 10e“²A. Find the voltage and the power at t = 3s. Ans.-11.16 mV and -24.89mW
A variable capacitance and a resistance of 290 ohm are connected in series across a 110-V; 60-Hz supply. Draw the complex or locus of impedance and current as the capacitance changes from 6uF to 32 uF. From the diagram, find the capacitance to give a current of 0.6 A and the current when the capacitance is 11 uF.