Answered: Draw a sketch of level rods (as seen…

Draw a sketch of level rods (as seen from the eyepiece of an engineer's transit) with the following measurements. i. 2.255 m 1.452 m ii. 3.515 m 0.250 m 2.518 m iii. iv. V.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 80 kN 10 kN/m B 8 m 2 m RA Rc FiFigure P-405

Q: A 90 degrees V notched weir installed at the end of a rectangular channel controls the flow of…

Q: Determine the values of 0A and vA. Clearly indicate both magnitude and direction. Answer: 0 = 135…

A: According to given dataWe need to calculate the asked Values which is solved below

Q: Water in a rectangular, finished-concrete channel, n = 0.017 overflows a dam, as shown in the figure…

A: An open channel is a deep hollow surface with the top surface normally exposed to the environment.…

Q: The head of water over an orifice of diameter 100 mm is 5 m. The water coming out from orifice is…

Q: Calculate magnitude, direction and location of the resultant force exerted by the water on this…

Q: A 1.5m base and 4m high rectangular plane is vertically submerged in water and the top of the plane…

A: Eccentricity is demonstrated by the letter e and is characterized as the proportion of the…

Q: determine the magnitude and direction of F3

A: We know: The summation of the components of each force in the horizontal direction is equal to the…

Q: DIFFERENTIAL LEVELING. In the following diagram, the elevation at BM-A is known, and we need to know…

A: Solution: Given Data: Elevation=820.00 ft

Q: A 90 degrees V notched weir installed at the end of a rectangular channel controls the flow of…

Q: Determine the slope at point B in the beam. E = 200 GPa and I = 450x10° mm". 50 kN/m 25 kN/m 4m

Q: From the given data of differential leveling as shown in the tabulation: ELEV. (m) 392. 25 STA B. S.…

A: To find out the elevation and difference between 6&5, 1&6 , 2&4.

Q: Draw a sketch of level rods (as seen from the eyepiece of an engineer's transit) with the following…

A: (I) 2.245

Q: Determine the magnitude OF reachions at A(Moment, Ray and Ron ond Ra), and directions 357 N!m 3

Q: Q.13.19 top of the opening is 0.61 m below the water level in the reservoir and the downstream water…

Q: An 80 m spiral is used to connect a 4o simple at both ends. 1. Compute the long tangent. a. 53.37 m…

A: Given, L = 80 m D = 4

Q: 2. Draw a sketch of level rods (as seen from the eyepiece of an engineer's transit) with the…

A: I). 2.275m : II). 1.772m :…

Q: A 600mm điameter pipeline carries water under a head of 30m with a velocity of 3m's. This water main…

A: It is required to determine the flow rate. Q=A×V=π4×6001000 m2×3 ms=0.848 m3s It is required to…

Q: th horizontal velocity v4, determine

A: Velocity at point 'A' = 8ft/s Acceleration due to gravity (g) = 32.2 ft/square second. e= 0.8 Height…

Q: Lw Trapezoidal section Q = 120 m³/s %3D S = 12 cm/km, Side slope 2 : 1, n= 0.0182 Compare the…

A: The most economical section of a trapezoidal channel is one which has hydraulic mean depth equal to…

Q: Three independent lines of levels are run from BM1 to BM2. Route A is 6 km long, route B is 4 km…

A: BM1 to BM2 there are the value A, B,C Route Lenth(L) Km Elevation BM1 to BM2 (E) LE A 6 82.27…

Q: A right-angled triangular notch is used for gauging the flow of a 140 cm wide, laboratory flume. In…

A: Given- Width of triangular Notch (b)=140 CmHead(h)=64 mmLength of Hydraulic Ring=45 cm

Q: A jet issues from the side of the tank under a head of a=4.36m. The orifice is positioned 5.94…

A: Determine the point it strikes a horizontal plane

Q: Determine the rate of flow in the channel of Prob. 14.84, knowing that b= 12 ft, d1 = 4 ft, and d2 =…

A: Given information: The width of the channel is b=12 ft. The depth d1=4 ft. The depth d2=4 ft.

Q: The staff reading taken on a workshop floor using a level is 0.645 m. The inverted staff reading…

A: given- staff reading from floor SRF=0.645 mInverted staff reading from bottom of beam ISR=2.960 mRL…

Q: Determine the value of the slope at C in degrees. Answer in decimals (1 degree 1rad*180/pi) 6kN 4KN…

Q: 91:50, calculate the depth of the channel if the bed slope is 1 in 3000 and C = 50.

A: To find : Ratio between maximum discharge and top width.

Q: Three independent lines of levels are run from BM1 to BM2. Route A is 6 km long, route B is 4 km…

A: To determine the probable difference in elevation between BM1 and BM2. Given, Difference in…

Q: Find the corrected level for point (A) if you know that the true level of (A) is 30 m according to…

A: Solution: Given Data: The true level of A=30 m Backsight reading=1.782 m Foresight reading=1.365 m…

Q: Problem 3 - 101 A vertical semi-circular area of radius r is submerged in a liquid with its diameter…

Q: Draw a sketch of level rods (as seen from the eyepiece of an engineer's transit) with the following…

Q: Compute for the Bend Allowance and K-factor. 1. 213.06 Leg Length 1 84.11 R30 BA - Leg Length 2

Q: Pr A triangular gutter with a side slope at an angle of 60° has a depth of 300 mm. Find the velocity…

Q: Q2/ Arwana canal with rectangular cross section. The wall of the channel (4-2) has a water depth of…

A: Given, Q = 360 m3/2 min = 3 m3/s y = 0.4 m B = 2(0.4) = 0.8 m

Q: 20 kN/m 8 m B 8 n 5 m

Q: Q2- Compute the factor of safety for Slope Number 2 using Janbu’s o = 0 charts (y = 15.77 kN/m³). Su…

A: From the given Data

Q: C.L Elev.=??m 17 m 5 m 3 m 7 m Elev.=15m 4 ?? m Elev.=13m

A: Schematic diagram of the given problem:

Q: Q-3 A glass tube is inserted into a flowing stream of water with one opening directed upstream and…

A: Given data- To find- Vertical height 'h'

Q: 17. A stone is dropped from a cliff and 2 sec later another stone is thrown down with a speed of 22…

Q: With the use of an engineer's level, the reading on a rod 80 m away was found to be 2.82 m. The…

A: What is the radius of curvature of the level tube

Q: What is the pressure drop along a circular tunnel (Diameter 6m) and 1550 n long tunnel if 25 m/sec…

Q: Draw a sketch of level rods (as seen from the eyepiece of an engineer's transit) v following…

A: Following is the sketch of level rods: i)2.265 m

Q: water flows at 12m^/s in a concrete trapezoidal channel n=0.015 bottom width 4m side slopes 2H:1V…

A: solution discharge Q=12m3secwidth b=4mts and side slopes 2H:1Vcosnider at depth of yo=0.8mso the top…

Q: Draw a sketch of level rods (as seen from the eyepiece of an engineer's transit) with the following…

A: As per Bartleby's guidelines, i have answered only first three questions. kindly repost the…

Q: A water tank is filled with Oil (SG = 0.87) to a height of 3.07 m. above the 10 mm Ø orifice which…

Q: ifference between the height of collimation and rise & fall method in engineering survey

Q: What reading of gage A will cause the glycerin to rise to level B? The specific weights of oil and…

A: The values and diagram given in the question are as follows Specific weight of oil(γo)=52 lb/ft3…

Question

Draw a sketch of level rods (as seen from the eyepiece of an engineer's transit) with the
following measurements.
2.255 m
1.452 m
3.515 m
0.250 m
2.518 m
i.
i.
iii.
iv.
V.
Example:
SDS

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step by step

Solved in 6 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Z1 Section 6 Statics of Rigid Bodies (CET 0214-6 - STATICS OF RIGID BODIES) Cle 1 C North a b 42.5° 63.8° East 280m B A surveyor sights a target at C from points A and B, recording the angles shown. Determine the magnitudes of the position vectors a and b. (Non-anonymous questionO) S (1 Point) TUpload file File number limit 2 Single file size limit: 100MB Allowed file types: Word, Excel, PPT, PDF, Image, Video, Audio
Evaluate eln (x) dx 2 0.01 2 T 34 TI O O
Evaluate the function: S 4ny(6+ y³/2)dy O 24ny? – * y7/2 +C O 12ry? + T y7/2 + C O 12ry³ + 3T y5/2 + C None of the choices. Please refer to my solution.
P₁₂ = ? 250mm 2 56 300mm P₁= 80 kPa Fx=? of Fy=?
PROBLEM 01 REFER TO FIGURE 01, DETERMINE THE INTERNAL FORCES ACTING ON THE FOLLOWING MEMBERS: (STATE COMPRESSION OR TENSION) o FG o FC GH CH
The pin-jointed space truss shown in Fig. P.15.14 is pinned to supports 0, 4, 5 and 9 and is loaded by a force P in the x direction and a force 3P in the negative y direction at the point 7. Find the rotation of the member 27 about the z axis due to this loading. All members have the same cross-sectional area, A, and Young's modulus, E. (Hint. Calculate the deflections in the x direction of joints 2 and 7.) Ans. 382P19AE.
3) vite the eqwations for shtar and momont betueen points D and E. select thhe anigin at Å- B 8 kips W= 3 kips /fA. CS Scanned with CamScanner
Question 39/50 Situation 39, 40 10 m/s Es=200 GPa E,=105 GPa 50kg Steel 15 mm-diaBrass k=25 kN/mm 1.5m 1.5m 0.5m O Zoom image Determine the stiffness of Spring, Steel and Brass assembly as shown. 8256.25 N/mm 9141.75 N/mm 2563.23 N/mm O5632.20 N/mm Previous Next
Determine the moment of inertia Ix of the shaded area about the y axis. as the following procedure: 3- find the moment of inertia Ix of the circle part (mm?) |-100 mm-100 mm--150 mm 150 mm 75 mm 150 mm Select one: O 422458309 O 450.06*106 O 24850488.76 O None
A. TACHEOMETRY 1. A transit is set up at a distance back of the zero end of a level base line 240 m. long. The base line being marked by stakes at every 30 m. A rod is then held at successive stations along the base line. The stadia intervals at each location of the rod are tabulated below. It is required to determine the stadia interval factor of the instrument. Distance Stadia Distance Stadia Intercept Intercept 30 0.297 150 1.482 60 0.591 180 1.776 90 0.885 210 2.073 120 1.188 240 2.367
B 7-8 (L) Determine the coordinates of station S, the point of intersection between lines AB and PQ. The coordinates of stations A, B, and P are shown in figure; the measured azimuth of PQ is 50°. yem N 1000 E 900 A Azimuth 50⁰ P N 650 E 1050 X 400 S Q B N 700 X, E 1400 line РФ Slop = fan yo ५० ya Y₁ =mi (x~x 6.50 10 N: Y = 802.1 E: XS 1230.
Kasus #3 D H A B 21 |VA Rg S5 HA A 21 R ΣΜ ΣV-0 ΣΗ-Ο POINT B=0 OR A ANALYZE COMPLETELY FROM THE BOTTOM OF THE SUBJECT REACTION B. COUNT S1, S3, S5 COMPLETELY