Differentiate the poles and zeros on a first-degree order system and on a second-degree order system in feedback control system.
Q: A pattern detector which gives 1 at its 1-bit output when the last four values of its 1-bit input…
A: Given: A pattern detector that gives 1 at its 1-bit output when the last four values of its 1-bit…
Q: logic circuit diagram for fabinaaci counter that gives output in fabinaaci sequence
A: Combinational logic circuit is a circuit whose input is dependent on the output,
Q: Briefly explain the working of following power plants a) Thermal Power plant b) Hydel power plant
A: thermal power Plant coverts heat energy to electric power / Energy. The basic principle of these…
Q: A 8-stage impulse voltage generator is connected to a test object of load capacitance of 5000pF with…
A: Give information about an impulse voltage generator is, Number of stages N=8. Wave tail time…
Q: Determine α (DC) for a transistor where Ib = 75 μA and Ic = 4 mADetermine α (DC) for a transistor…
A:
Q: A dc series motor drives a load a 30rev/s and takes a current of 10A when the supply voltage is…
A: In this question, We need to efficiency of the DC series motor? If input current I= 10A Supply…
Q: An L-R-C series circuit has L = 0.800 H, C = 5.00 μF, and R = 340.0 2. At t = 0 the current is zero…
A: It is given that: L=0.8HC=5μFR=340Ωq0-=2.80×10-4C
Q: What will happen if proper polarity is taken for granted in paralleling transformer? If voltages are…
A: The polarity of the transformer means the instantaneous direction of the second induced emf. If the…
Q: Q3 The approximate far zone normalized electric field radiated by a resonant linear dipole antenna…
A: Given: The approximate far zone normalized electric field radiated by a resonant linear dipole…
Q: 1. One millivolt is one millionth of a volt. a) True (b) False
A:
Q: Determine the current flowing through an element if the charge flow is given by (a) q(t) = (3t+ 8)…
A: In this question we will find current I with related to given charge..... Note :- as per our…
Q: 2. Explain electrical contact resistance. Holm model of electrical contact resistance. Contact…
A: It is asked to explain contact resistance and the Holm model of contact resistance. Also it is asked…
Q: Q2) A parallel-plate waveguide is known to have a cutoff wavelength for the m= 1 TE and TM modes of…
A: Given Cutoff wavelength of a parallel plate waveguide.we need to determine the no of modes possible…
Q: Obtain the Differential Equation of the given system R(s) 54 +35³ +25² + s +1 55+ 454 +35³ +25² +3s…
A: here we have to find the differential equation for the given block. we know that theL r t =R s…
Q: Sketch vo for the network and determine the dc voltage available. 100 V Si Ge 4.7 ΚΩ • 2.2 ΚΩ 2.2 ΚΩ…
A: Brief description: For the given question we need to calculate dc voltage and output voltage…
Q: Determine the voltage gain for a NPN Emitter follower stage driven by a finite source impedance…
A: Brief description: In the above given question we need to calculate voltage gain expression of the…
Q: Fuente a Párrafo 30 N:N espa... Título 1 Título 2 Estilos 7c Za Puesto Subtitulo Enfa Zb
A:
Q: parallel different KVA
A: Transformer- A device that transfers the electrical energy between two electrical circuits which are…
Q: he value of 1₁ and 1₂? E,= 10V 201 R 40 60 80 E₂40 V 60°
A:
Q: 5. For the system shown in figure. State the given system type also find steady state position error…
A: A system is carrying a feedback when the output from it's own circuit is passed to the input of the…
Q: Using mesh analysis, find the voltage and current flowing through each of the resistive elements.…
A:
Q: A metal rod is 2m long and 8mm in diameter. Compute its resistance if the resistivity of the metal…
A: Resistance- The electrical resistance, R of this simple conductor is a function of its length, L and…
Q: Calculate the voltage across the capacitor v(t) and current through the inductor i(t) fo t>0 for the…
A:
Q: Determine the true power and reactive power of the circuit shown. rms 2V |f=2 kHz с 0.01 μF
A: Given: The voltage source of 2 V The frequency of 2 kHz The capacitance of 0.01 uF
Q: VIN 0- R₂ W Rc Vcc 15V 2 ΚΩ
A:
Q: The switch has been in position a for a long time. At t=0, the switch moves from position a to…
A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…
Q: Example 33.19. Two single-phase furnaces working at 100 V are connected to 3300-V, 3-phase mains…
A: The scott connection is the most common method of connecting two single-phasetransformers to perform…
Q: a. b C. d. Given parameters: R₁ = 20 MS2 R2 = 5 ΜΩ RD = 3.3 ΚΩ Rs = 2 kΩ Rsig = 10002 RL = 1.5 kΩ…
A: We need to find out transconductance, input and output impedance and voltage gain for given circuit
Q: In Figure 3.3 shows the circuit diagram of a typical n-channel JFET common source amplifier. If ac…
A: The circuit parameter are given…
Q: 2. Draw and explain the Successive approximation type Analog to Digital Converter.
A: The successive approximation type Analog to Digital converter is shown below: It is a type of…
Q: LAPLACE AND INVERSE LAPLACE TRANSFORM. 1. L {t² sin 3t}
A:
Q: Problem 5: The Spectrum of a certain signal is illustrated below. Write the equation for the…
A: In this question we need to find a signal x(t).
Q: Vi = SV m 10kr joke in // skr 10k un loker m Eskr ↑ Vo ↓ Find Vout
A:
Q: What is the purpose of polarity testing in order to properly perform paralleling of transformers?
A: Polarity test define the direction of the current. it helps the interconnecting the primary and…
Q: Figure 9.2 R2 b 4. Referring to Figure 9.2, if the generator phase voltage is 230 volts and the load…
A: To solve this question we analysis the given system on per phase basis
Q: the single-phase ac voltage controller has a 240 V rms 50 Hz source. The load resistance is 20002…
A:
Q: A 60-cycle synchronous motor is coupled to, and drives, a 50-cycle alternator. How many poles does…
A: An AC motor is an electrical machine which takes AC electrical input energy and produces mechanical…
Q: Determine the voltage gain for a NPN CB stage with base resistance (without early effect) (You must…
A:
Q: a) The n-channel JFET and the D-MOSFET have very similar I-V output characteristics. Which of these…
A: a. n-channel JFET can be operated in enhancement mode. If JFET has a small doped channel that is…
Q: a) Define Guide wavelength with the formula?
A: According to the Bartleyby guidelines “Since you have asked multiple question, we will solve the…
Q: QUESTION 1 In the figure V=47 volts, and R=117 ohms. Determine the current (in unit of mA) in the…
A: Given, The circuit is, And V=47 voltsR=117 Ω
Q: Q4) Channel 1 of a two-channel system handles (0-3) kHz signals; the second channel handles (0-5)…
A:
Q: Find the impedance at w = 1 Mrad/sec of: a) a 2 kΩ resistor in parallel with a 1 mH inductor; b) the…
A:
Q: A modulating signal f(t) is bandlimited to 5 kHz is sampled at a rate of 15000 samples/ sec. The…
A:
Q: Q5: Compute the magnetic field intensity B of a long straight wire that has a circular loop with a…
A: Disclaimer As per the Bartleby guidelines we are allowed to answer only one question at a time Since…
Q: ower plant has a capacity factor of 40.9% and a plant use factor of 45.2%. How many hours per year…
A: A power is a place where electrical power is produced to supply the demand of its customers.
Q: 1. How are encoders used in the measurement of speed? Explain the encoder with a neat diagram.
A: An encoder is a transducer that is used to measure angular displacement. The encoder can be used to…
Q: Kindly find the Vout and show complete solutions
A: In this question, We need to determine the output voltage Vo ? We are solving this problem using…
Q: The TE10 mode is propagated in rectangular waveguide of dimensions 6 cm x 4 cm. By means of a…
A: Given Dimensions of a rectangular waveguide, we need to determine the frequency of the wave. Please…
Q: +V₂ BB RB Rc [+Vcc
A:
Differentiate the poles and zeros on a first-degree order system and on a second-degree order system in feedback control system.
Step by step
Solved in 2 steps
- control system Consider the total harmonic distortion of a closed loop system is 5%. Distortion without feedback is 10%. Calculate the sensitivity of the closed loop system.Explain the difference between feedforward concurrent and feedback controlFeedback Control 3. Consider Automatic Voltage regualtion system from Figure c) Given KA = 40, find the closed loop transfer function of the system.
- Discuss merits and demerits of feedback in control system . Give 5 points for each brief onlyConsider the total harmonic distortion of a closed loop system is 5%. Distortion without feedback is 10%. Calculate the sensitivity of closed loop system.Explain how poles and zeros are important in a feedback control system and the differences between them.
- Explain with block diagrams the difference between Positive Feedback and Negative Feedback Closed-Loop Control Systems.Can you state one condition under which the error signal of a feedback control system would not be the difference between the input and the output? If yes, discuss it.What is negative feedback system?
- What is positive feedback system?1. Among the advantages of the control system, what specific advantage addresses that most electrical devices has not enough power to produce the desired output and need a special circuitry that will increase the output signal? 2. A type of control system that has a unidirectional process that the signal travels from input to output? 3. What is the other term for a type of a feedback system that feeds power to the input signal that will result to increase in the output? 4. A type of electrical signal that has two states? 5. A part of DCS system that shows information on the operator about the condition and state of a process? 6. A part of DCS system that measures different quantity such as temperature, flow and pressure. 7. Write True or False about the following statement: There is a closed loop system in a SCADA. 8. Write True or False about the following statement: SCADA is used in chemical and power generating plants and factories. 9. Among the advantages of the control system,…1. Among the advantages of the control system, what specific advantage addresses that most electrical devices has not enough power to produce the desired output and need a special circuitry that will increase the output signal? 2. A type of control system that has a unidirectional process that the signal travels from input to output? 3. What is the other term for a type of a feedback system that feeds power to the input signal that will result to increase in the output?