control system Consider the total harmonic distortion of a closed loop system is 5%. Distortion without feedback is 10%. Calculate the sensitivity of the closed loop system.

Q: 2. Find the value of R for maximum power transfer of the circuit below. Determine also the maximum…

A: It is given that:

Q: Assume that the generator's field current is adjusted so that the generator supplies rate voltage at…

A: If the field current is held constant, then the magnitude of EA will be constant, although its angle…

Q: Consider the following circuit in which Vs = 6V, Is = 0.0125 A, R₁ = 100 S2, R₂ = 200 S2, R3 = 300…

A: The required parameters can be calculated by using the superposition theorem. The superposition…

Q: 2. for the following circuit sketch the output voltage vo. 100 V A -100 V Ideal diodes 2.2 ΚΩ

A:

Q: -1V 2V 3V 1kΩ ww 1kΩ ww 1kΩ ΣΚΩ 5.0V 5.00 Find output voltage, assume ideal parameters

A:

Q: For n-type silicon at 300K with N-5E15cm-³ and excess carrier lifetime of 2E-7s find a) The hole…

A: Given data: Nd=5×1015 cm-3τp= τn= 2×10-7 s Intrinsic concentration of silicon at 300K, ni=1.5×1010…

Q: Use Kirchhoff's Law to solve for the current passing through each resistor. Compare it with what you…

A: Given,

Q: Qy Find II, Ir, and I3 for Figure below. Qu R₁ R3 fer Ri=1K2 R2=2KR R3=3KR Ru гка R5=5KR R6 = 6K2 11

A: We need to find out the current for given circuit, first we will find out node voltage then we will…

Q: 1₁ a. Find the value of V. Answer: R₁ Answer: V₁ + b. Find the current (down) through R3. Answer: c.…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Q2 The full-bridge inverter has a switching sequence that produces a square wave voltage across a…

A: A type of H-bridge inverter used to convert DC power into AC power is called a full-bridge inverter.…

Q: A three phase 6000 V Alternator gave the following open circuit characteristic at normal speed. ted…

A: Given data: 3-ϕ , 6000 v alternator If=16 A The open circuit voltage is 4700 v The phase O.C.…

Q: Please redraw the circuit wherein KVL and voltage division would be easy.

A: In this question,  We need to redraw the circuit.  We are solving this problem using the voltage…

Q: Describe how the SR Latch works in your own words. 6. What kind of applications can this latch…

A:

Q: In this ideal op-amp circuit, it is given: R1 = 8 ohms, R2 = 98 ohms, R3 = 6 ohms, R4 = 21 ohms, and…

A: Both the opamps act as inverting amplifiers. So the corresponding formula is used as shown below.

Q: 5.33 Refer to the op amp circuit in Fig. 5.69. Calculate ix and the power dissipated by the 3-k2…

A: We need to find out the voltage, current and power for given circuit .

Q: = 5. Determine the output voltage vo in the circuit below if vs 2V. Hint: There is a voltage divider…

A:

Q: An op amp (20 dB drop in gain/decade), has an open-loop gain of 100 dB and a unity- gain frequency…

A: An op amp (20 dB drop in gain/decade), has an open-loop gain : AOL=100 dBunity gain frequency: UGB=2…

Q: Question 5: Calculate the reactance of a coil of inductance 0.32 H when connected to a 50 Hz supply.…

A:

Q: A solid specimen of dielectric has a dielectric constant

A: Given data: εr = 4tan δ = 0.0001f = 60 HzE = 100 kV/cm

Q: Oscilloscope-XSC1 T2 T2-T1 Time 0.000 s 0.000 s 0.000 s Timebase Scale: 10 ms/Div X pos.(Div): 0 Y/T…

A: Angle of conduction is the angle when the circuit is in ON state, no matters which components are…

Q: Identify the type of Transformer referred to K=0.7

A: It is given that: k=0.7

Q: 7.-Let h=[ 0, -1, -2, -3, -4, -3, -2, -1, 0 ] be the impulse response of an LTI system Obtain the…

A:

Q: 4. For the following circuits sketch the output vo +8 V لسوري 2.2 ΚΩ 3V

A:

Q: H₁w/ give me an me an example of Yeal time applications ( non Causal System. (2) Linear and non…

A: 1) Example of non causal system  Missile tracking and guidance systems are two examples of…

Q: 7. Calculate ₁, ₂, and is from the following circuit. 60 20 12V 40 6V

A: Mark the node and redraw the given circuit as:

Q: 3. Determine ID1, ID2 and V4 for the given circuit below by using constant voltage model for the two…

A:

Q: Find the Q-point for the diode in Fig. P3.63 using (a) the ideal diode model and (b) the constant…

A: As per the bartleby guideline for more than 3 subpart, only first three are to be answered, please…

Q: 3. Give five (5) examples of Emerging technology and give its advantages and disadvantages.

A: Given: Name 5 emerging technologies and their advantage and disadvantage.

Q: Find the Q-points for the diodes in the four cir- cuits in Fig. P3.68 if the values of all the…

A: since you have posted the questions with multiple questions so we are supposed to answer the 1st…

Q: A 2 kHz audio signal modulates a 50 MHz carrier causing a frequency deviation of 2.5 kHz. Determine…

A: Frequency of audio signal ∆f = 2 kHz Frequency of carrier fc = 50 MHz Frequency deviation = ∆f

Q: For the signal given below, check whether it is a power signal or an energy signal or neither. X(t)…

A: We need to check whether the given signal is energy signal or power signal.

Q: 7.13 p-Channel FETS 32. For the network of Fig. 7.101, determine: a. Ipo and VGSQ b. VDs. c. VD- 33.…

A: "Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: 8.11 Find Z in the network in Fig. P8.11. 2 Ω Μ 1Ω ww z— j2Ω Figure P8.11 'ΖΩ ΖΩ Η -j1 Ω j2 Ω

A:

Q: A parallel resonant network, C-360 pF. 4,300 pl. Q-100, L, 50 pl, w-N, N, -10, calculate resonant…

A: The given circuit is shown below. Given values are Turns ratio N1N2=10. C=360 pF=360×10-12 F.…

Q: Draw power triangle and  phasor diagram of the circuit Compare the values measured in software…

A:

Q: Ans: Vo = 10 mV 20 mV + 50 mV παλαι 100 mV +. – 120 mV R1 25 ΚΩ R2 20 ΚΩ Μ R3 10 ΚΩ Μ R4 50 ΚΩ Μ RF…

A:

Q: The circuit below has a 4-input priority encoder connected to a 2-to-4 decoder with enable. The…

A: Given: Priority encoder truth table and diagram.  Output of Priority encoder connected to 2:4…

Q: Find ix. 4mA (4) Μ 6 ΚΩ 3 ΚΩ 12 ΚΩ ww 6ΚΩ + Vo

A:

Q: Question 3 a) The conductors of a three-phase transmission line are arranged in the form of an…

A: Given that, R=2.07Ω, L=310.8mH, C=1.477μF, f=50Hz We have to find here is sending end voltage and…

Q: 12=2 7. Use source transformation to find the Norton equivalent circuit at terminals a and b in the…

A:

Q: C(s) Given G(s) = = R(s) 1 s+5 Find the response c(t) with an input r(t) = u(t) is a unit step.…

A: G(s) = C(s)R(s)=1s(s+5) We have to find the response with initial conditions zero.

Q: for 9VR2 + VR2 20 how u get 10VR2VR2? Did you divide 20v into 2 base on vr2vr2

A: If you take common as VR2 and on addition of 9 and 1 we get 10. I,e VR2(9+1)  And then by dividing…

Q: 2. An adaptor is designed to convert the AC 600-V(rms), 60-Hz input signal to a nearly DC output of…

A:

Q: Consider the network to the right, with the following values: R₁ = 50 R₂ = 30 R3 = 40 R4 = 80 R5 =…

A: We first find the current I in the loop using Ohm's law. Current I is marked. Then find the voltage…

Q: Determine the transfer functions, Ha(N) = Ya(N)/X (N) and H₂(N) = Y()/X(), for the digital system…

A:

Q: Illustrate the instantaneous frequency for the following FM modulated waveforms: kHz S fm (t) = A…

A:

Q: 6. Determine the output voltage vo in the circuit below. Hint: Begin with a node equation at the +…

A: In this question,  We  need to determine the output voltage Vo  as shown the circuit.  We are…

Q: A 3-phase, star-connected alternator generates 6,360 V per phase and supplies (514) kW at a pf…

A: As we know that the transformer works on the principle of electromagnetic induction where the input…

Q: a. Draw the logic diagram of the Boolean function. Use the function as given in the question, do not…

A: As per Bartleby guideline we need to answer the first three questions only. Kindly repost the rest…

Q: R3 M Rs. lo -Vss For the current source above, R 3 =158Kohm, R 4 -194Kohm, Rs-6Kohm. If the…

A: