Assuming that a 4-bit ADC channel accepts analog input ranging from 0 to 5 volts, determine the following: a. number of quantization levels; b. step size of the quantizer or resolution; c. quantization level when the analog voltage is 3.2 volts; d. binary code produced by the ADC; e. quantization error.

Assuming that a 4-bit ADC channel accepts analog input ranging from 0 to 5 volts, determine the following: a. number of quantization levels; b. step size of the quantizer or resolution; c. quantization level when the analog voltage is 3.2 volts; d. binary code produced by the ADC; e. quantization error.

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter8: Data And Network Communication Technology

Section: Chapter Questions

Problem 3VE

See similar textbooks

Similar questions

The information in an analog waveform, with maximum frequency f = 3 kHz, is to be transmitted over an M-ary PAM system, where the number of pulse levels is M = 16. The quantization distortion is specified not to exceed t 1% of the peak-to-peak analog signal. (a) What is the minimum number of bits / sample, or bits / PCM word that should be used in digitizing the analog waveform? (b) What is the minimum required sampling rate., and what is the resulting bit trans-mission rate? (c) What is the PAM pulse or symbol transmission rate? (d) If the transmission bandwidth (including filtering) cquals 12 kHz, determine the bandwidth efficiency for this system.
Question 1: A. Given an 8 bit ADC, find its resolution (step size) for producing a digital signal for an analog input ranging 260 - 516 V. Draw the first and last 3 steps of a table with 3 columns showing the analog ifiput-digital output numeric relationship. B. The frequency of an analog signal is 23 MHz. What is the minimum sampling frequency for representing it in digital form, according to the Nyquist theorem? Explain with the help of a diagram what happens if Nyquist theorem is not obeyed.
. Find the analog output voltage of a 5-bit digital to analog converter for any five inputs. Assume the value of K = 1. . What is the percentage resolution of a 8-bit digital to analog converter (DAC).
In a certain digital waveform, the period is four times the pulse width. The duty cycle is(a) 25% (b) 50% (c) 75% (d) 100%
Draw the waveforms of PSK if the modulating data signal is 1 0 0 1 1 0 0.Assume that two bits are represented by signals with a phase difference of 180 degrees.(Draw the modulating data signal and PSK waveform one below the other)
1. Design a combinational circuit for DECODERS with ENABLE line a EN 2. Design a circuit that has a 3-bit input and a single output (F) specified as follows: ·F = 0, when the input is less than (5)10 ·F = 1, otherwise 3. Write a HDL code for 2bit binary DECODER.
Q. Determine the binary output code of a 3-bit flash ADC for the analog input signal in figure below, consider the Vref = 8 [V]. V 9 8 7 6 5 4 t (us) 0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170 180 190
02/ Assuming that a 2-bit ADC channel accepts analog input ranging from 0 to 5 volts, determine a. The number of quantization levels L) b. The step size of the quantizer or resolution;D c. The quantization level when the analog voltage is 2.3 volt; R e. Determine the quantization error when the analog input is 2.3 volts OiConrider the analog signal x.ft) = est: Suppose that x. (t) is sampled at(T, D 0.005, eg
In QAM, the parameters that are varied are(a) amplitude and frequency (b) phase and frequency(c) amplitude and phase (d) pulse width and position
Question 4: A data signal has a frequency >1MHz, but there is unwanted signal at about 100Hz. i) Design a high-pass filter (the circuit is as shown in Figure 3) that attenuates the unwanted signal by 98%. ii) What is the effect of the measurement signal at its minimum of 1MHZ?
Question 3d Recall that the maximum input voltage for a 12-bit ADC on the TM4C is 3.3 V. If the input voltage on analog input channel 2 (AIN2) is 0.75 V, what is the value of the digital result after conversion? Possible answers are given in decimal. 930 930.9 232 931 3072
Add these Binary numbers: 10101010 + 101 = O 10101111 O 11110101 O 01010101 O 101