An air lossless transmission line is operating at frequency of 3 MHz and has a length of 1.75 A, characteristic impedance of 150 Q and terminated by a load of 75 Q. What is the wavelength on the transmission line in meters? What is the load reflection coefficient ?

An air lossless transmission line is operating at frequency of 3 MHz and has a length of 1.75 A, characteristic impedance of 150 Q and terminated by a load of 75 Q. What is the wavelength on the transmission line in meters? What is the load reflection coefficient ?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: The following lossless network is powered by a f=9 GHz microwave source. A matching circuit is…

Q: In a laboratory, we found that the static wavelength ratio was 2.0 as a result of an experiment…

A: Given :Z0 of T.L =50 ohm Standing wave ratio (s)=2.0The distance between succesive voltage minimum…

Q: The 50 ohm half wavelength lossless transmission line is terminated with a 60 ohm load impedance. If…

Q: Problem 1. A parallel-wire air-spaced transmis- sion line operating at 1910 Hz has a phase shift of…

A: Given a parallel wire air spaced transmission line operating at, Frequency, f = 1910 Hz Phase shift,…

Q: ) Given a transmission line with a characteristic impedance of Za = 50 Ohms, determine the…

Q: A single-phase antenna transmission line with a length of 40 km and the load supplying with a…

A: Given data, The value of the length of the line is 40 km, The supply voltage with load is 200kV, The…

Q: Derive the scattering parameters for each of the following networks by using the parameter def-…

A: In the question, network 1 is mention but it is not shown in the figure. hence we will consider the…

Q: An air lossless transmission line is operating at frequency of 4 MHz and has a length of 0.25 ),…

A: As per company guidelines we can solve only first three sub part kindly post the rest questions…

Q: Generate an 80 MHz signal. A signal source is connected to an unknown impedance, z1, by a lossless…

Q: A 100 MHz FM broadcast station uses a 300 2 transmission line between the transmitter and a…

Q: A coaxial cable is 10 meters long, and is filled with lossless Teflon, having a relative…

Q: Two identical pulses each of magnitude 12 V and width 2 us are incident at i = 0 on a lossless…

A: Wave is function of space and time. The mode at which waveguide have lowest frequency is said to be…

Q: The following characteristics have been measured on a lossy transmission line at 100 MHz: Zo = 50 +…

Q: A transmission line is not properly terminated thereby causing a a reflection coefficient magnitude…

A: In this question we need to find a impedance of the termination.

Q: The lossless network given below is excited with a microwave source having frequency f={frq_q1} GHz.…

A: Reflection coefficient

Q: A transmitter delivers 50 W into a 600 Ω lossless line that is terminated with an antenna that has…

A: Brief description : Transmission line is a medium where we can transmit electromagnetic waves…

Q: A transmission line has characteristic impedance of 75 Ω and it is connected to receiver with…

A: According to the question we have to find the value of i. Reflection Coefficient; ii. VSWR

Q: A 100Ω lossless line connects a matched signal of 100kHz to a load of 25Ω. Calculate the reflection…

A: Given: For a lossless transmission line, line impedance ZT/L=100 Ω, load impedance ZL=25 Ω.

Q: The following lossless network is powered by f = 8 GHz microwave source. If z, = 48 0\ (\epsilon_r V…

Q: An antenna with a load impedance ZL = (100 + j40)0 is connected to a transmitter Za = Zo through a…

A: we need to find out power delivered to antenna.

Q: The lossless network given below is excited with a microwave source having frequency f=4,8 GHz.…

Q: A 702 high-frequency lossless line is used at a frequency where 2 = 80cm with a load of 140+j91 2 a.…

Q: A lossless coaxial cable with L = 0.5 uH/ft and C = 100 pF/ft is terminated by a 100-ohm resistive…

A: Given that, L = 0.5 uH/ft C = 100 pF/ft ZL= 100-ohm impedance of cable is defined as…

Q: A 5.2cm long, lossless 100Ω transmission line was terminated with a load of ?? = 30 + 50Ω. With the…

A: The load reflection coefficient is: So, the magnitude of the reflection coefficient is: 0.617 And,…

Q: Q1) Consider the circuit shown below, with an ideal source connected to a lossless line. Assuming a…

A: Given: Consider the circuit shown below, with an ideal source connected to a lossless line. Assuming…

Q: A 120-22 lossless line is terminated with 40- and 20- resistors in parallel. The voltage a the input…

Q: A lossless air-filled transmission line with Z0 = 50Ω is terminated in a load with ZL = (150 - j100)…

A: Lossless air-filled transmission line with Zo=50Ω is terminated withZL=150-j100Ω.Reflection…

Q: The standing-wave ratio on a lossless 3002 transmission line terminated in an unknown load impedance…

Q: Question#01: A piece of RG-59B/U Coaxial cable has a nominal capacitance of 0.9 Farad/meter, and 8…

Q: A 100Ω lossless line connects a matched signal of 100kHz to a load of 25Ω. Calculate the reflection…

Q: Antenna with impedance 40 +j30 2 is to be matched to a 100 Q lossless line with a shorted stub.…

A: Antenna with impedance 40+j30Ω is to be matched to a 100 Ω lossless line with a shorted…

Q: If the load on a 50-ohm transmission line is 100-ohms resistive, what is the impedance at a point…

A: Expression of impedance

Q: -ohm resistive load and is operated at 100 MHz. At an electrical length of 0.4 wavelengths, what is…

Q: A 30-m-long lossless transmission line with Z, = 50 N operating at 2 MHz is terminated with a load…

Q: In a laboratory, we found that the static wavelength ratio was 2.0 as a result of an experiment…

A: Given :Zo= 50 ohm Standing wave ratio=2.0 The distance between successive voltage minima of 25 cm…

Q: The lossless network given below is excited with a microwave source having frequency f=7,1 GHz. For…

A: Characteristics impedance of the given lossless network is determined as shown below

Q: A 50Ω lossless transmission line is terminated in a load (50+j100) Ω. Using a smith chart, determine…

A: Given, Impedance, Z0=50ΩLoad Impedance, ZL =(50+j100)Ω

Q: A 300ᘯ transmission line is 0.8 m long and terminated with a short circuit. The line is operating in…

A: A 300ᘯ transmission line is 0.8 m long and terminated with ashort circuit.The line is operating in…

Q: QI/ A lossless coaxial cable of 170 mm long has the parameters L — 245 nWm andC — 200 pF/m. The…

A: To analyse the given statement

Q: 6. The standing-wave ratio on a lossless 300-2 transmission line terminated in an unknown ZL is S=…

Q: QUESTION.2. A lossless air transmission line with Z, = 50 N is connected to a complex load composed…

Q: An extra high voltage transmission line of length 300 km can be approximate by a lossless line…

A: Given, An extra high voltage transmission line of length= 300 km Propagation constant, β= 0.00127…

Q: The following lossless network is powered by a f=9,7 GHz microwave source. A matching circuit is…

A: Given, f = 9.7 GHz ZL = 34 L = 270,77835273601

Q: A 50-ohm lossless transmission line is terminated by a 100-ohm resistive load and is operated at 100…

Q: The line parameters of a lossless transmission line are L = 0.25 µH/m and C= 100 pF/m. If the…

Q: The lossless network given below is excited with a microwave source having frequency f=9,6 GHz. For…

A: The lossless network given below is excited with a microwave source having frequency f=9,6 GHz. For…

Q: Return loss for a transmission line in terms of its reflection co efficient is given by:

A: The return loss is a parameter that is used to measure the amount of energy that is reflected back…

Q: The lossless network given below is excited with a microwave source having frequency f=7,1 GHz. For…

Question

An air lossless transmission line is operating at frequency
of 3 MHz and has a length of 1.75 A, characteristic
impedance of 150 Q and terminated by a load of 75 Q.
What is the wavelength on the transmission line in
meters?
What is the load reflection coefficient ?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Transmission Line Parameter and Scattering Parameter (S-parameter)

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

4- The charactersitic and load impedances of a lossless transmission Line are to and Z₁ = // Z₁. 1 a- Determine the voltage reflection coefficient at the load. Determine the voltage at the load, determine the power Consumed by the load. b. what is the power reflection coefficient defined by the ration power reflected incident power
A piece of RG-59B/U Coaxial cable has a nominal capacitance of 0.9 Farad/meter, and 8 Henry/m inductance per meter. The diameter of the inner conductor as 0.8m, and the dielectric constant of the insulation as 4. Find the diameter of the outer conductor in cm. Assume the line is a lossless line?
The charactersitic and load impedances of a lossless transmission Line are to and Z₁ = = = = = ₁² a- Determine the voltage reflection coefficient at the load. Determine the voltage at the load, determine the power Consumed by the load. b. what is the power reflection coefficient defined by the ratio power reflected incident power
A 702 high-frequency lossless line is used at a frequency where 2 = 80cm with a load of 140+j91 2 a. Calculate the reflection coefficient and the SWR b. Determine the distance to the first voltage minimum from the load c. Determine the distance to the first voltage maximum from the load d. Calculate the impedance at the point where maximum voltages occur
A 105MHz, 90 v peak signal is incident on a 50-ohm transmission line. The line is 125m long and is terminated in 300-ohm load. What is the SWR for this situation? Find the reflection coefficient.
A loss-less transmission line with characteristics impedance of 600 ohms is terminated in a purely resistive load of 900 ohms. The reflection coefficient is?
A piece of RG-59B/U Coaxial cable has a nominal capacitance of 0.4F/m, and 7.5 H inductance per meter. The diameter of the inner conductor as 0.8m,and the dielectric constant of the insulation as 4.97. Find the diameter of the outer conductor in cm. Assume the line is a lossless line?
Question # 01: A piece of RG-59B/U Coaxial cable has a nominal capacitance of 0.5 F/m, and 6.5 H inductance per meter. The diameter of the inner conductor as 0.8m, and the dielectric constant of the insulation as 4.95. Find the diameter of the outer conductor in cm. Assume the line is a lossless line?
A lossless transmission with characteristic impedance of Z0 = 1002 and length = 52cm The line was terminated with a load of Zy= 30 + j502. According to what is given, a) The reflection coefficient in the load and the voltage standing wave ratio on the line (GDDO) Find out. b) Find the impedance and admittance at the line input. (for f = 750MHZ) c) For f = 750MHZ, the impedance and admittance values 2cm away from the load. (It will be assumed that = 20.)
A lossless transmission line terminated with a load ZL has characteristic impedance Zo. i. Express the voltage and current in the line in terms of the forward and backward travelling waves. ii. Derive an expression for the reflection coefficient.
A lossless 50Q transmission line was terminated with a load of = 17.7+ jl1.82. The length of the line is = 1/ 6. The reflection coefficients at the entrance of the line and at the load calculation.
2. At a frequency of 4 MHz a parallel wire transmission line has the following parameters: R-0.025 /m, L=2 uH/m, G-0, C-5.56 pF/m. The line is 100 meters long, terminated in a resistance of 300 2 Calculate the following: i. Characteristic impedance of the line. ii. Standing wave ratio. iii. Voltage reflection coefficient of the load. iv. Recalculate the characteristic impedance assuming the transmission line is lossless. V. Calculate the propagation constant of the line B.