network A.10.What is the total delay (latency) for a frame of size 10 million bits that is being sent on a link with 20 routerseach having a queuing time of 3 ps and a processing time of 1 us. The length of the link is 2000 km. Thespeed of light inside the link is 2×10ª m/s. The link has a bandwidth of 5 Mbps. Which component of the totaldelay is dominant? Which one is negligible?

Frame Size: 10 million bits = 107 bits Length of the link = 2000 Km = 2000 * 103 m Speed of the…

A.10.What is the total delay (latency) for a frame of size 10 million bits that is being sent on a link with 20 routers each having a queuing time of 3 ps and a processing time of 1 ps. The length of the link is 2000 km. The speed of light inside the link is 2×10ª m/s. The link has a bandwidth of 5 Mbps. Which component of the total delay is dominant? Which one is negligible?

A.10.What is the total delay (latency) for a frame of size 10 million bits that is being sent on a link with 20 routers each having a queuing time of 3 ps and a processing time of 1 ps. The length of the link is 2000 km. The speed of light inside the link is 2×10ª m/s. The link has a bandwidth of 5 Mbps. Which component of the total delay is dominant? Which one is negligible?

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter9: Computer Networks

Section: Chapter Questions

Problem 19VE

See similar textbooks

Similar questions

Frames of 1000 bits are sent over a 106 bps duplex link between two hosts. The propagation time is 25 ms. Frames are to be transmitted into this link to maximally pack them in transit (within the link). 1.1 What is the minimum number of bits (1) that will be required to represent the sequence numbers distinctly? Assume that no time gap needs to be given between transmission of two frames.
2. Consider a bus-topology network with five stations. A reservation access method is used. Each station has infinite data to transmit. Each reservation slot has 10 microseconds (note that 1 microsecond = 106 second). For each station, one data transmission sends 1000 bits. The transmission rate over the medium is 10 Mbps. For a station, which is its throughput (in unit "Mbps")?
Consider a full-duplex 256 Kbps satellite link with a 240 millisecond end-to-end delay. The data frames carry a useful payload of size 12,000 bits. Assume that both ACK and data frames have 320 bits of header information, and that ACK frames carry no data. What is the effective data throughput When using sliding windows with a sender window size of W = 5 data frames?
Consider two hosts S and R connected directly by a link. A link has a transmission speed of 107 bits/sec. It uses data packets of size 400 bytes. Data needed to transmitted is 400 bytes. Length of the link is 600 km and the propagation speed are 3 × 108 meter per second. T is the transmission delay and P is the propagation delay. The propagation delay in millisecond and transmission delay in microsecond respectively are
Consider a full-duplex 512 kbps link with length 36,000Km connecting two hosts. The data frames carry a useful payload of size 6000 bits. Assume that both ACK and data frames have 400 bits of header information, and that ACK frames carry no data. The propagation speed along this link is 3×108 m/sec. a) What is the RTT on this link? b) What is the effective useful data throughput, in kbps, when using Stop-and-Wait?
A link has a transmission speed of 106 bits/sec. It uses data packets of size 1000 bytes each. Assume that the acknowledgment has negligible transmission delay, and that its propagation delay is the same as the data propagation delay. Also assume that the processing delays at nodes are negligible. The efficiency of the stop- and-wait protocol in this setup is exactly 25%. The value of the one-way propagation delay (in milliseconds) is
3.4-8 Channel utilization with pipelining. Suppose a packet is 10K bits long, the channel transmission rate connecting a sender and receiver is 10 Mbps, and the round-trip propagation delay is 10 ms. What is the channel utilization of a pipelined protocol with an arbitrarily high level of pipelining for this channel?
In cdma2000 reverse link, a user stream of 9.6kbps is sent to an encoder r = 14 (4 coded bit for every 1 information bit), K = 9. and then through a symbol repetition (2x) (repeats the encoded bits twice). What coded data rate after repetition is obtained? What Walsh code length should you use to spread that stream into a typical 1.2288Mcps CDMA channel?
Let the two host X and Y connected via a packet switch with 107 bits per second links. Switch is placed at 50 km from X. X and Y are located at 100 Kilometer apart also the propagation speed along the link is 2 × 108 m/s. The switch begins forwarding a packet after 0.1 milliseconds it receives the packet. If 1000 bytes of File are needed to be transmitted and each packet size is 500 bytes, the time elapsed between the transmission of the first bit of data and the reception of the last bit of the data in millisecond is
Consider a half-duplex point-to-point link using a stop-and-wait scheme, in which a series of messages is sent, with each message segmented into a number of frames. Ignore errors and frame overhead. A. What is the effect on line utilization of increasing the message size so that fewer messages will be required? Other factors remain constant. B. What is the effect on line utilization of increasing the number of frames for a constant message size? C. What is the effect on line utilization of increasing frame size?
If a two port bridge was used in a heavy load standard Ethernet network such that the traffic is going through it. If each station is theoretically given a capacity of5Mbpsand the number of stations in each LAN segment is equal, then the number of stations in each LAN is:
Consider a network connecting two systems located 4000 kilometers apart. The bandwidth of the network is 500 x Mbps. The propagation speed of the media is 4 × 106 meters per second. It is needed to design a Go-Back-N sliding window protocol for this network. The average packet size is 107 bits. The network is to be used to its full capacity. Assume that processing delays at nodes are negligible. What is the minimum size in bits of the sequence number field?