last three digitas ................341 2. A generation station of 50MW supplied a region which has the following demands:FromТоDemand (kW)Midnight (12.00AM)5 AM1005 AM6 PM5006 PM7 PM8007 PM9 PM900Midnight (12.00 AM)Last three digits of your ID number9 РМNeglect transmission line losses and find the following:i) Plot the daily load curve and the load duration curve.ii) Find the load factor, the reserve capacity, plant capacity factor and the plant use factor.

Answered: Image /qna-images/answer/ef105f93-27d4-400c-ac61-bde17f57799d.jpg

2. A generation station of 50MW supplied a region which has the following demands: From То Demand (kW) Midnight (12.00AM) 5 AM 100 5 AM 6 PM 500 6 PM 7 PM 800 7 PM 9 PM 900 9 PM Midnight (12.00 AM) Last three digits of your ID number Neglect transmission line losses and find the following: i) Plot the daily load curve and the load duration curve. ii) Find the load factor, the reserve capacity, plant capacity factor and the plant use factor.

2. A generation station of 50MW supplied a region which has the following demands: From То Demand (kW) Midnight (12.00AM) 5 AM 100 5 AM 6 PM 500 6 PM 7 PM 800 7 PM 9 PM 900 9 PM Midnight (12.00 AM) Last three digits of your ID number Neglect transmission line losses and find the following: i) Plot the daily load curve and the load duration curve. ii) Find the load factor, the reserve capacity, plant capacity factor and the plant use factor.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.31P

See similar textbooks

Similar questions

Develop a small-scale equivalent transmission line pi model (per phase) of the transmission lines with the specification given in table 1. The conductors are placed with a flat horizontal spacing of 7.25 meters. Consider that the load connected against the line 125MW at 0.85 lagging power factor. You are required to develop an equivalent model for a maximum 220V (RMS) sending and receiving end voltage and a maximum of 5A load current. Sr. NTDC Transmission Line Length Conductor No. Туре 220 kV DG Khan-Loralai Transmission Line (227 km) 227km Pheasant TABLE AJ Electrical characteristics of bare aluminum conductors steel-relnforced (ACSR)+ Reniertance Reactance per conductor 1-ft apacing. 60 Ha Ae, 60 Ha Capaitive Aluminum ares, emil Layers of Outaide aluminum diameter, in a/1,000 ft soC, D/ml GMR Induetive Stranding AL/8t De, 20°C. 20C, a/mi Code word D. t Ma-mi Waswing Partridge Ostrieh Merlin Linnet Oriole Chickndee Ibin Pelienn Flicker Hawk 266,800 206,800 300,000 336, 400 336.400…
The p.u. impedance value of an alternator corresponding to base values of 13.2 kV and 30 MVA is 0.2 p.u. Then the p.u. impedance value of an alternator for the new base values of 13.8 kV and 50 MVA is......
Consider the 500 kV, three phase bundled conductor line as shown in the figure below. Find the line to neutral capacitance. 0.5 m 30 mm (0) (O to Ine 15 m 15 m
The per unit impedance of a generator on a 60 MVA, 20 kV base is j0.09 p.u. The per unit impedance to a 100 MVA, 20 kV base will be (a.) j0.054 p.u. (c.) j 1.5 p.u. (b.) j0.54 p.u. (d.) j0.15 p.u.
In the Transmission Line Simulator, the Transmission Line is composed of which parameter/s? O A. The Shunt Conductance Only O B. The Series Impedance and Shunt Capacitance O C. The Shunt Capacitance Only O D. The Series Impedance Only
7. In the circuit below write the loop equations and set up (not solve) the matrix equation for the load current. Wiso 150 75 28 100
Tam responsible for any violations with regard to this. A load of 135 MW at a power factor of 0.65 lagging can be delivered by a 3-phase transmission line. The voltage at the receiving end is to be maintained at 54 kV and the loss in the of transmission is 6 % of the power delivered. (Consider the line to be a short transmission line) Find ion Single phase Power delivered Per phase voltage snt flei
A three-phase, 60-Hz, untransposed transmission line runs in parallel with a telephone line for 20 km. The power line carries a balanced three-phase rms current of Ia = 3202 – 240°A. The line configuration is as shown in figure. Assume zero current flows in the ungrounded telephone wires. Find the magnitude of the voltage induced in the telephone line. = 32020°A, Ī, = 3204–120°A, and a 4 m 4 m 5 m d G2 mO
The capacitance of a single phase two-wire transmission line depends on: Select one: a. All the above O b. the material of cables c. the radius of cables d. the distance between the cables O e. None of above
Problem 3.1: Determine the rms value of voltage induced in an 80-turn coil on a 30 cm × 25 cm cross-section core with peak flux density 1.7 T alternat- ing at 60 Hz. Problem 3.2: Two parallel 1-phase rectangular bus bars 2 cm apart at their cen- ter lines experience 30,000 A,ms current when a load gets short-circuited. Determine the peak mechanical force per meter length of the bus bars. Assume the bus bar shape factor K = 0.85.
Question 1) A 154 kV transmission line has a length of 100 km. The line and the conductors are given in Figure 1. The line is operated at f= 50 Hz. For both old and new lines calculate; a. GMD and GMR. b. Inductance of the line in Henries (H). c. Series Impedance (Z) of the line in Ohms. d. *Compare the results for both lines and comment on the results. e. *If the distance between the two neighbouring conductors is increase from 13 meters to 15 meters what would be the parameters in part a.,b. and c. comment on the results. New Line's Conductors 13 m 13 m Old Line's Conductors d r = 2 cm d = 40 cm r = 2 cm Figure 1
H. W.: A 3-phase overhead transmission line is being supported by three disc insulators. The potentials across top unit and middle unit are 9 kV and 11 kV respectively. Calculate: a. The ratio of capacitance between pin and earth to the mutual capacitance of each unit. b. The line voltage. c. String efficiency. [Ans: a. 0.22 b. 61.35 kV c. 76%]