1.What is the differences between a normal diode and a zener diode? 2. If you are going to design a regulator circuit, what are the important parameters that should know about the Zener?

Q: Ventricular late potential analysis in the ST segment of the ECG requires analysis in the frequency ...

A:

Q: Question. Find Vy, V, and V, in the circuit below if V, = 9 V. Assume an ideal op-amp. 50 ka 20 ka V...

A:

Q: What is the maximum power that can be transferred to the marked variable (in watts)? Ans. cannot be ...

A:

Q: List and discuss at least two factors that impact on the Nadir of the frequency response after loss ...

A: If generation and demand will be balanced then the rotor will store a fixed amount of kinetic energy...

Q: GENERAL SAFETY RULES FOR ELECTRICITY AND ELECTRONICS Safe practices will protect you and your fellow...

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you ar...

Q: A 60 Hz, single-circuit, three-phase transmission line is 150 mi long. The line is connected to a lo...

A:

Q: Subject:Electronics Engineering A 50Ω load resistance is connected across a half wave rectifier. The...

A: In this question,  We need to determine the dc output voltage, peak- to-peak ripple in the output vo...

Q: Calculate the equivalent impedance of three branches parallel in which the following individual valu...

A:

Q: The Inverse Fast Fourier Transform (IFFT) produces a _____ from a _____ :   a. spectrum, time doma...

A:

Q: Find the average value of a half-wave rectified signal with a peak value of 20 mV.

A: We need to find average value for half wave rectifier

Q: Question 2 Refer to the circuit in Figure Q2: R,=62 10V C=5F R,=42 R,=20 Figure Q2 a) When the switc...

A: As per our company guidelines we are supposed to answer. We need to find out voltage across the capa...

Q: O ind RT X I2KA for cet shown? shoun? 2kA IV 23kR SA 3KA

A:

Q: b) Determine the value of the capacitor and inductor of a series resonance circuit exhibiting the fo...

A:

Q: If a cable has a velocity factor of 0.75, what length of cable is required for a 90° phase shift at ...

A: Given : velocity factor(Vf)=0.75 Phase shift=90 degrees Frequency =100Mhz

Q: HWR circuit is transformer fed from the 220 V line. If the circuit provides a peak output voltage of...

A: We need to find out effective voltage for half wave rectifier

Q: (A) Determine the steady state error for the following system shown in Fig.1 for unit- ramp input. R...

A:

Q: inches. The center conductor is copper, and the dielectric material is polyethylene with relative pe...

A:

Q: A current of 5 A flows through a series circuit consisting

A:

Q: Suppose an amplifier has an open-loop voltage gain of 20, an input impedance of 100Ω, and an output ...

A: Use basic circuit law , voltage division rule to find out the output voltage. 

Q: Find I Using Norton's theorem 360 80V

A: Norton and Thevenin are the two important electrical circuits theorem which reduce the conplex circu...

Q: Since the construction of DC generators and Alternators are similar, you can convert a DC generator ...

A:

Q: OFDM signal is made up of twelve sub-carriers. If the symbol rate is 25kBaud and 64-QAM is used for ...

A: Given data : Symbol rate = 25k Baud For 64 QAM, the total bit per symbol is 6. there are 12 subcarri...

Q: Note: All question solutions should be based on Ohm's Law and/or Kirchhoff's laws. A: Determine vo a...

A:

Q: write node-voltage equations: one for each input terminal of the op amp. R4 R3 Vo O41 R2 R1 + RL Vin...

A:

Q: totype AI robot for industry that will be supplied by a 12V dc. This AI robot as they envision has a...

A: Solution- The model can be designed as- From the question, load resistance will be varies as 250 oh...

Q: It is required to generate a single pulse wavefom (Vr) of 4 Volts amplitude (peak-to peak) and 6 ms ...

A: Op-amps are used to generate pulse by using positive feedback concept. When an op-amp is dominated p...

Q: Determine vỵ in the circuit of Fig. 3.10a. 5 A 60 V 10 Ω (a)

A:

Q: What is the power factor (P.F) in this circuit? 80mH 60H2

A: This question belongs to circuit theory . It is based on the concept of calculation of power factor ...

Q: Q10/ A 3-phase, 6-pole induction motor is connected to a 60 Hz supply. The voltage induced in the ro...

A:

Q: A. Consider the Common-Source (CS) amplifier shown below. Vo He Cc Rsig CG RL Cs Sketch/draw and pro...

A:

Q: Determine Vout for fig. 2 VEE -5V D1 R1 D2 1.5kQ silicon diode Germanium Diode Vout R2 1.5kQ in

A:

Q: QUESTION 28 A three-phase balanced delta connected power system has a line current of 50 amps. What ...

A:

Q: Find the TFS and the EFS coefficients of the following f(t): A T,

A: As per our guidelines we are supposed to be answer only the first question. Kindly repost the other ...

Q: An AC voltage v(t)=431 sin(376t)V is applied to an SCR half-wave rectifier. If the SCR has a forward...

A:

Q: • T or F, modify the wrong part if False, please underline twice your answer if True or False. S...

A: FALSE The given statement is FALSE for the given synchronous motor or generator synchronous motors a...

Q: Three generators connected in parallel are rated as follows: Generator 1: 100 MVA, 33 kV, reactance ...

A: Given    Generator 1:Sbase old=100 MVAVbase old=33 kvReactance Zold=10 %New base quantitiesSbase new...

Q: Find the acive and reactive components of no-load current, and the no-load current of a 440/220 v si...

A:

Q: What should be the value of RL so that it will receive the maximum average power?

A:

Q: In the given circuit, Vx = 6.5 V and Rx = 50. R 0.1V 3.32 V2 Referring to the given circuit, determi...

A:

Q: The x-y plane at z =0 is a charge-free boundary separating two dielectric media with permittivities ...

A:

Q: Given that the lightbulb is rated 230 V, 0.5 A. Find the current across the 40 Q resistor and 80 Q r...

A: The given circuit diagram is shown below: It is given that: Rated voltage ofbulb=Vb=230 VRated bulb...

Q: The switch that is moved by a long metal or plastic actuator that extends out of the switch package ...

A: A statement is given and it is asked that which switch is moved by a long metal or plastic actuator ...

Q: Assume a three phase induction motor is connected to a three phase system and the shaft is coupled w...

A: Three-Phase induction motor is a device which is used to convert 3-phase electric input power into m...

Q: 13. Find the rms values of the following sinusoidal waveforms: a. v= 10 millivolts sin (377t + 60) b...

A:

Q: Use superposition to find i, in the circuit. 4 A 42 3Ω ww ww 12 V 10Ω ) 2 A

A:

Q: a) Consider the circuit shown in figure 3. i) Determine what type of filter is shown in Figure 3 i) ...

A: Note: As per the policy we can solve only one question, please re-upload the remaining part as a sep...

Q: Problem 2: Class E Amplifier Design A schematic of class E amplifier is shown in the figure 2 given ...

A: We are authorized to answer three sub-parts at a time, since you have not mentioned which part you a...

Q: A differential amplifier has a common-mode gain of 0.2 and a common-mode rejection ratio (CMRR) of 3...

A: CMRR=Ad/Acm=(DIFF. MODE GAIN)/(COMMON MODE GAIN)

Q: 20. Determine the level of , for the gate of 10 V Si 10 V Si 1 ΚΩ 610 V

A: Use the silicon diode equivalent model As 0.7 V voltage source Assume that the diodes as ON  Now fin...

Q: The carrier signal of amplitude 10V is frequency

A: