Concept explainers
Perform the following calculations and retain the appropriate number of significant figures in
each result.
a.
b.
c.
d.
(Hint: The significant figure rule for the extraction of a root is the same as for multiplication.]
Want to see the full answer?
Check out a sample textbook solutionChapter 1 Solutions
GENERAL CHEMISTRY-MOD.MASTERINGCHEM.
- What is the difference in surface area between two circles, one of radius 7.98 cm, the other of radius 8.50 cm? The surface area of a circle of radius r is r2. Obtain the result to the correct number of significant figures.arrow_forwardThe label on a bale of mulch indicates a volume of 1.45 ft3. The label also states that the mulch in the bale will cover an area of a garden 6 ft 6 ft to a depth of 1 in. Account for the discrepancy in the given volumes.arrow_forwardFor the pin shown below, why is the third digit determined for the length of the pin uncertain? Considering that the third digit is uncertain, explain why the length of the pin is indicated as 2.85 cm rather than, for example, 2.83 or 2.87 cm.arrow_forward
- The first measurement of sea depth was made in 1840 in the central South Atlantic, where a plummet was lowered 2425 fathoms. What is this depth in meters? Note that 1 fathom = 6ft, 1 ft = 12 in., and 1 in. = 2.54 102 m. (These relations are exact.)arrow_forwardHow many significant figures are in each measurement? (a) 3.1416 degrees (b) 0.00314 K (c) 1.0079 s (d) 6.022 1023 particlesarrow_forward1.89 Imagine that you place a cork measuring 1.30cm4.50cm3.00cm in a pan of water. On top of this cork, you place a small cube of lead measuring 1.15 cm on a side. Describe how you would determine if the combination of the cork and lead cube will still float in the water. Note any information you would need to look up to answer the question.arrow_forward
- Obtain the difference in volume between two spheres, one of radius 5.61 cm, the other of radius 5.85 cm. The volume V of a sphere is (4/3) r3, where r is the radius. Give the result to the correct number of significant figures.arrow_forwardA sample of a bright blue mineral was weighed in air, then weighed again while suspended in water. An object is buoyed up by the mass of the fluid displaced by the object. In air, the mineral weighed 7.35 g; in water, it weighed 5.40 g. The densities of air and water are 1.205 g/L and 0.9982 g/cm3, respectively. What is the density of the mineral?arrow_forwardFor these questions, be sure to apply the rules for significant figures. a You are conducting an experiment where you need the volume of a box; you take the length, height, and width measurements and then multiply the values together to find the volume. You report the volume of the box as 0.310 m1. If two of your measurements were 0.7120 m and 0.52145 m, what was the other measurement? b If you were to add the two measurements from the first part of the problem to a third length measurement with the reported result of 1.509 m, what was the value of the third measurement?arrow_forward
- Gold leaf, which is used for many decorative purposes, is made by hammering pure gold into very thin sheets. Assuming that a sheet of gold leaf is 1.27 105 cm thick, how many square feet of gold leaf could be obtained from 28.35 g gold? The density of gold is 19.3 g/cm3.arrow_forwardA person weighed 15 pennies on a balance and recorded the following masses: 3.112 g 3.109 g 3.059 g 2.467 g 3.079 g 2.518 g 3.129 g 2.545 g 3.050 g 3.053 g 3.054 g 3.072 g 3.081 g 3.131 g 3.064 g Curious about the results, he looked at the dates on each penny. Two of the light pennies were minted in 1983 and one in 1982. The dates on the 12 heavier pennies ranged from 1970 to 1982. Two of the 12 heavier pennies were minted in 1982. a. Do you think the Bureau of the Mint changed the way it made pennies? Explain. b. The person calculated the average mass of the 12 heavy pennies. He expressed this average as 3.0828 g 0.0482 g. What is wrong with the numbers in this result, and how should the value be expressed?arrow_forwardTwo students were assigned to determine the mass of a sample of an unknown liquid. Student A used an ordinary laboratory balance that could determine mass to ±0.01 g. Student B used an analytical balance that could measure mass to ±0.1 mg. Each made four measurements, giving the following results: Student A: 8.19 g, 8.22 g, 8.21 g, 8.25 g Student B: 8.2210 g, 8.2210 g, 8.2209 g, 8.2210 g 2. Which student is more precise? A Barrow_forward
- Chemistry: The Molecular ScienceChemistryISBN:9781285199047Author:John W. Moore, Conrad L. StanitskiPublisher:Cengage LearningChemistryChemistryISBN:9781305957404Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCostePublisher:Cengage Learning
- Chemistry: Matter and ChangeChemistryISBN:9780078746376Author:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl WistromPublisher:Glencoe/McGraw-Hill School Pub CoGeneral Chemistry - Standalone book (MindTap Cour...ChemistryISBN:9781305580343Author:Steven D. Gammon, Ebbing, Darrell Ebbing, Steven D., Darrell; Gammon, Darrell Ebbing; Steven D. Gammon, Darrell D.; Gammon, Ebbing; Steven D. Gammon; DarrellPublisher:Cengage Learning