Z Fy = 100 N Fx = 100 N F₂ = 500 N a = 500 mm b = 1000 mm Figure 2: Schematics for problem 3. 1. Draw the moment (M), axial (N), and shear (S) diagrams. Please note that this is a 3D problem and you will have moment (M) and shear (S) along two different axes. That means that you will have a total of 5 diagrams.

Hi, can you please help me with these diagrams? Please be as clear as possible with the FBDs.

A guy who works out at your gym found out that you are an engineer and has hired you do an analysis comparing two versions of a similar exercise: lateral raises. He wants to compare using dumbbells (as in Fig 1) versus using a cable machine (as in Fig 2). Develop an equation for each case for the moment about the shoulder as a function of angle. (0 to 90 horizontally) You will use your own dimensions for this analysis. You will need to measure: Arm length from shoulder joint to palm of your hand Height from shoulder joint to the ground Wingspan with arms held horizontally (palm-to-palm) You can use any measurements for the dimensions, just need the equations and FBD Fig 1: Dumbbell Lateral Raises Fig 2: Cable Lateral Raises

Don't use chatgpt. I need a handwritten solution

A cantilever beam (with a clamp at x=0 and free at x=L, where L is the length of the beam) is modelled using two flexural elements. A moment, M, is applied at the free end. Which of the following describes the vector of external forces? Note that no other external forces are applied, and the degrees of freedom are defined in the usual order. f = [0 0 0 0 M 0]T f = [0 0 M 0]T f = [0 0 0 0 0 M]T f = [0 0 0 M]T f = [M 0 0 0]T f = [0 M 0 0]T

Please help explain the annotation?

Can you answer d through e on this question? thank you

Please see photo for full question

Tension at the cable is attached to B. With the given diagram find the Tension, supporting force reactions (Fax, Fay) at point A and the force acting in point C.

4.3 Please help. Written on paper not typed on computer or keyboard please. Need help both questions. Please include all units, steps to the problem and information such as its direction or if it is in compression or tension. Thx.