What command is used to test network connectivity and provide a response for every packet received by the remote host?   Connect   Tracert   Snmpserver   Ping

While investigating, you have decided that the problem may lie in the DHCP server's settings. Clients are able to ping IP addresses on the local network and the internet, but they are unable to load other websites. What may lead to a misconfigured DHCP server? incorrect NTP server erroneous Domain Name System server incorrect entryway Incorrect subnet mask

ping -s 65507 -c 10 <default gateway IP>.     What are the meanings of -s and -c parameters from the above command.

Find the IP addresses of these websites. Tools: You can use the ŋsleekun or ping command in your terminal/command prompt. Fill the table below with your solutions. Website www.usp.ac.fj www.facebook.com www.youtube.com IP Address Range Nelookup Results Update the ALC template below to block the identified IP ranges for the above websites. Router(config)# access-list 10 deny Router(config)# access-list 10 permit any Router(config)# interface IDE> Router(config-if)#ip access-group 10 in Router(config-if)#exit Explanation: • • • • • -list 10: Creates a standard ACL with number 10. dany : Blocks traffic from the specified IP address. Example: =====-list 10 dany 192.168.1.0 0.0.0.255 will block the range 292.168.1.0 to 192.168.1.255. permit any: Allows all other traffic not specified in the deny rule. interface : Applies the ACL to a specific interface (e.g.. GigabitEthernet0/0). -group 10 in Applies the ACL in the inbound direction on the interface. Cybersecurity Policies/Acts in Fiji…

6 Issue a ping command to any IP address or FQDN that you know. Write what a target IP address or FQDN are you using and list how many attempts were made to determine if the destination is reachable? 6.1 What information is provided to you after your ping command was executed to answer Q 6?