A 30- hp squirrel cage induction motor is connected to a 240-volt three phase feeder. The motor is to be replaced with a 50-hp squirrel cage induction motor connected to 480 volts. The motor has a nema code b, a full load current of 49.8 amps, and an sf of 1.10. the present conductors are 3 awg copper with thwn insulation. Are these conductors sufficient to connect to the 50-hp motor or will they have to be replaced

A 30- hp squirrel cage induction motor is connected to a 240-volt three phase feeder. The motor is to be replaced with a 50-hp squirrel cage induction motor connected to 480 volts. The motor has a nema code b, a full load current of 49.8 amps, and an sf of 1.10. the present conductors are 3 awg copper with thwn insulation. Are these conductors sufficient to connect to the 50-hp motor or will they have to be replaced

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.4P

See similar textbooks

Similar questions

A 40 hp Squirrel cage Induction-type, 230 volts rated 3 phase motor. It has a code rating of "B" and an ambient temperature of 40 degree celcius. Conductor code RHW copper will be used. Determine its conductor size.
Please help me with these MCQ 1. stator windings are connected in _____ types 2. Circuit resistance is checked by connecting a(n) ______ to the positive battery terminal and the output, or battery terminal of the AC regenerator. 3. Slip rings and brushes A: Mount on the rotor shaft B: Conduct current to the rotor field coils C: Are insulated from each other and the rotor shaft D: All of the above
A Flyback converter (for questions 1-3) shown below has the following parameters. Vin-100v, Vo-20V, Po-ioW, D-025, Fsw-250kHz 4. The magnetizing inductor at the primary side winding is 100uH, what is the peak current in the power switch? A. 1.8A B. 1.6A C. 2.1A D. None of the above
What is use of solenoid coil in the pressure to converter? a. To produce magnetic field in the LVDT b. To change the LVDT output c. To bring back the pivoted beam normal position d. To produce linear displacement in bellows
A Flyback converter (for questions 1-3) shown below has the following parameters. Vin=100V, Vo=20v, Po=40W, D=0.25, Fsw=250kHz iin i out in 1. What is the turns ratio N1:N2 between the primary side winding and the secondary side winding? A. Ν1: N25:3 B. N1: N2 = 3:5 C. N1: N2= 5:2 D. None of the above %3D 2. What is the maximum voltage on the power switch? A. 120V В. 133V С. 100V D. None of the above 3. What is the maximum voltage on the diode? Α. 40V В. 133V C. 80V D. None of the above 4. The magnetizing inductor at the primary side winding is 100uH, what is the peak current in the power switch? Α. 1.8Α В. 1.6A С. 2.1A D. None of the above
a. Draw the relationship between excitation current and short circuit, and Please explain. b. At what volts is the alternator end voltage short-circuited? At nominal voltage What will happen if a short circuit is made?
A 110 V, 60 Hz, 6 – pole single phase induction motor 1/3 hp has the following equivalent circuit impedances: RI = 1.52 ohm, R2 = 3.13 ohm and x1 =2.10 ohm, x2 =1.56 ohm. Xm=58.2 ohm, The Friction, windage and stry losses =16W, the core loss = 35 W, For a slip of 0.05, calculation (a) input current, (b) power factor, (c) developed power, (d) output power, (e) speed (f) in put power (g) air gab power (h) T ind (i) T load 6) efficiency.
In a single phase AC capacitor start and run induction motor, if the capacitor is connected in series with running coil, the motor will __________________. a. rotate in any direction. b. not rotate. c. rotate in anti- lockwise direction. d. rotate in clockwise direction
Explain why the alternators are never solidly grounded? How the short circuit current is limited in alternator?
14/ What are the following statements are true for a three-phase induction motor? I. Three-phase induction motor stator winding is fed from a three-phase supply II. Stator carries a three-phase winding III. Rotor carries a short circuited winding a. I and II only b. I,II and III c. II and III d. I only
Q/Two dc generators A and B has the following characteristics:GA: rated voltage=150 volt: rated carrent=30Ampere: armature resistance (0.4Ω).GB:no_lond voltage=160Volt: rated carrent=20Ampere: armature resistance=(0.6Ω).The generators are connected in paralled. Draw the circuit diagram, then find:no_load circulating current and no_load voltage?At what carrent the generator B will Be floating? The maximum possible land power
A Flyback converter (for questions 1-3) shown below has the following parameters. Vin=100V, Vo=20V, Po=40W, D=0.25, Fsw=250kHz V in 1. What is the turns ratio N1:N2 between the primary side winding and the secondary side winding? A. N1: N2 = 5: 3 B. N1: N2 = 3:5 C. N1: N2= 5:2 D. None of the above 2. What is the maximum voltage on the power switch? A. 120V В. 133V C. 100V D. None of the above 3. What is the maximum voltage on the diode? А. 40V В. 133V С. 80V D. None of the above 4. The magnetizing inductor at the primary side winding is 100uH, what is the peak current in the power switch? A. 1.8A В. 1.6A С. 2.1А D. None of the above